13,125 research outputs found
An Energy Efficiency Perspective on Training for Fading Channels
In this paper, the bit energy requirements of training-based transmission
over block Rayleigh fading channels are studied. Pilot signals are employed to
obtain the minimum mean-square-error (MMSE) estimate of the channel fading
coefficients. Energy efficiency is analyzed in the worst case scenario where
the channel estimate is assumed to be perfect and the error in the estimate is
considered as another source of additive Gaussian noise. It is shown that bit
energy requirement grows without bound as the snr goes to zero, and the minimum
bit energy is achieved at a nonzero snr value below which one should not
operate. The effect of the block length on both the minimum bit energy and the
snr value at which the minimum is achieved is investigated. Flash training
schemes are analyzed and shown to improve the energy efficiency in the low-snr
regime. Energy efficiency analysis is also carried out when peak power
constraints are imposed on pilot signals.Comment: To appear in the Proc. of the 2007 IEEE International Symposium on
Information Theor
On Low-Resolution ADCs in Practical 5G Millimeter-Wave Massive MIMO Systems
Nowadays, millimeter-wave (mmWave) massive multiple-input multiple-output
(MIMO) systems is a favorable candidate for the fifth generation (5G) cellular
systems. However, a key challenge is the high power consumption imposed by its
numerous radio frequency (RF) chains, which may be mitigated by opting for
low-resolution analog-to-digital converters (ADCs), whilst tolerating a
moderate performance loss. In this article, we discuss several important issues
based on the most recent research on mmWave massive MIMO systems relying on
low-resolution ADCs. We discuss the key transceiver design challenges including
channel estimation, signal detector, channel information feedback and transmit
precoding. Furthermore, we introduce a mixed-ADC architecture as an alternative
technique of improving the overall system performance. Finally, the associated
challenges and potential implementations of the practical 5G mmWave massive
MIMO system {with ADC quantizers} are discussed.Comment: to appear in IEEE Communications Magazin
Massive MIMO for Internet of Things (IoT) Connectivity
Massive MIMO is considered to be one of the key technologies in the emerging
5G systems, but also a concept applicable to other wireless systems. Exploiting
the large number of degrees of freedom (DoFs) of massive MIMO essential for
achieving high spectral efficiency, high data rates and extreme spatial
multiplexing of densely distributed users. On the one hand, the benefits of
applying massive MIMO for broadband communication are well known and there has
been a large body of research on designing communication schemes to support
high rates. On the other hand, using massive MIMO for Internet-of-Things (IoT)
is still a developing topic, as IoT connectivity has requirements and
constraints that are significantly different from the broadband connections. In
this paper we investigate the applicability of massive MIMO to IoT
connectivity. Specifically, we treat the two generic types of IoT connections
envisioned in 5G: massive machine-type communication (mMTC) and ultra-reliable
low-latency communication (URLLC). This paper fills this important gap by
identifying the opportunities and challenges in exploiting massive MIMO for IoT
connectivity. We provide insights into the trade-offs that emerge when massive
MIMO is applied to mMTC or URLLC and present a number of suitable communication
schemes. The discussion continues to the questions of network slicing of the
wireless resources and the use of massive MIMO to simultaneously support IoT
connections with very heterogeneous requirements. The main conclusion is that
massive MIMO can bring benefits to the scenarios with IoT connectivity, but it
requires tight integration of the physical-layer techniques with the protocol
design.Comment: Submitted for publicatio
- …