1,035 research outputs found
An Energy Efficiency Perspective on Massive MIMO Quantization
One of the basic aspects of Massive MIMO (MaMi) that is in the focus of current investigations is its potential of using low-cost and energy-efficient hardware. It is often claimed that MaMi will allow for using analog-to-digital converters(ADCs) with very low resolutions and that this will result in overall improvement of energy efficiency. In this contribution, we perform a parametric energy efficiency analysis of MaMi uplink for the entire base station receiver system with varyingADC resolutions. The analysis shows that, for a wide variety of system parameters, ADCs with intermediate bit resolutions (4 - 10 bits) are optimal in energy efficiency sense, and that using very low bit resolutions results in degradation of energy efficiency
On Low-Resolution ADCs in Practical 5G Millimeter-Wave Massive MIMO Systems
Nowadays, millimeter-wave (mmWave) massive multiple-input multiple-output
(MIMO) systems is a favorable candidate for the fifth generation (5G) cellular
systems. However, a key challenge is the high power consumption imposed by its
numerous radio frequency (RF) chains, which may be mitigated by opting for
low-resolution analog-to-digital converters (ADCs), whilst tolerating a
moderate performance loss. In this article, we discuss several important issues
based on the most recent research on mmWave massive MIMO systems relying on
low-resolution ADCs. We discuss the key transceiver design challenges including
channel estimation, signal detector, channel information feedback and transmit
precoding. Furthermore, we introduce a mixed-ADC architecture as an alternative
technique of improving the overall system performance. Finally, the associated
challenges and potential implementations of the practical 5G mmWave massive
MIMO system {with ADC quantizers} are discussed.Comment: to appear in IEEE Communications Magazin
Efficient DSP and Circuit Architectures for Massive MIMO: State-of-the-Art and Future Directions
Massive MIMO is a compelling wireless access concept that relies on the use
of an excess number of base-station antennas, relative to the number of active
terminals. This technology is a main component of 5G New Radio (NR) and
addresses all important requirements of future wireless standards: a great
capacity increase, the support of many simultaneous users, and improvement in
energy efficiency. Massive MIMO requires the simultaneous processing of signals
from many antenna chains, and computational operations on large matrices. The
complexity of the digital processing has been viewed as a fundamental obstacle
to the feasibility of Massive MIMO in the past. Recent advances on
system-algorithm-hardware co-design have led to extremely energy-efficient
implementations. These exploit opportunities in deeply-scaled silicon
technologies and perform partly distributed processing to cope with the
bottlenecks encountered in the interconnection of many signals. For example,
prototype ASIC implementations have demonstrated zero-forcing precoding in real
time at a 55 mW power consumption (20 MHz bandwidth, 128 antennas, multiplexing
of 8 terminals). Coarse and even error-prone digital processing in the antenna
paths permits a reduction of consumption with a factor of 2 to 5. This article
summarizes the fundamental technical contributions to efficient digital signal
processing for Massive MIMO. The opportunities and constraints on operating on
low-complexity RF and analog hardware chains are clarified. It illustrates how
terminals can benefit from improved energy efficiency. The status of technology
and real-life prototypes discussed. Open challenges and directions for future
research are suggested.Comment: submitted to IEEE transactions on signal processin
- …