35 research outputs found

    An analytical model for performance evaluation of multimedia applications over EDCA in an IEEE 802.11e WLAN

    Get PDF
    We extend the modeling heuristic of (Harsha et al. 2006. In IEEE IWQoS '06, pp 178-187) to evaluate the performance of an IEEE 802.11e infrastructure network carrying packet telephone calls, streaming video sessions and TCP controlled file downloads, using Enhanced Distributed Channel Access (EDCA). We identify the time boundaries of activities on the channel (called channel slot boundaries) and derive a Markov Renewal Process of the contending nodes on these epochs. This is achieved by the use of attempt probabilities of the contending nodes as those obtained from the saturation fixed point analysis of (Ramaiyan et al. 2005. In Proceedings ACM Sigmetrics, '05. Journal version accepted for publication in IEEE TON). Regenerative analysis on this MRP yields the desired steady state performance measures. We then use the MRP model to develop an effective bandwidth approach for obtaining a bound on the size of the buffer required at the video queue of the AP, such that the streaming video packet loss probability is kept to less than 1%. The results obtained match well with simulations using the network simulator, ns-2. We find that, with the default IEEE 802.11e EDCA parameters for access categories AC 1, AC 2 and AC 3, the voice call capacity decreases if even one streaming video session and one TCP file download are initiated by some wireless station. Subsequently, reducing the voice calls increases the video downlink stream throughput by 0.38 Mbps and file download capacity by 0.14 Mbps, for every voice call (for the 11 Mbps PHY). We find that a buffer size of 75KB is sufficient to ensure that the video packet loss probability at the QAP is within 1%

    Contributions to QoS and energy efficiency in wi-fi networks

    Get PDF
    The Wi-Fi technology has been in the recent years fostering the proliferation of attractive mobile computing devices with broadband capabilities. Current Wi-Fi radios though severely impact the battery duration of these devices thus limiting their potential applications. In this thesis we present a set of contributions that address the challenge of increasing energy efficiency in Wi-Fi networks. In particular, we consider the problem of how to optimize the trade-off between performance and energy effciency in a wide variety of use cases and applications. In this context, we introduce novel energy effcient algorithms for real-time and data applications, for distributed and centralized Wi-Fi QoS and power saving protocols and for Wi-Fi stations and Access Points. In addition, the di¿erent algorithms presented in this thesis adhere to the following design guidelines: i) they are implemented entirely at layer two, and can hence be easily re-used in any device with a Wi-Fi interface, ii) they do not require modi¿cations to current 802.11 standards, and can hence be readily deployed in existing Wi-Fi devices, and iii) whenever possible they favor client side solutions, and hence mobile computing devices implementing them can benefit from an increased energy efficiency regardless of the Access Point they connect to. Each of our proposed algorithms is thoroughly evaluated by means of both theoretical analysis and packet level simulations. Thus, the contributions presented in this thesis provide a realistic set of tools to improve energy efficiency in current Wi-Fi networks

    A differentiated Services Architecture for Quality of Service Provisioning in Wireless Local Area Networks

    Get PDF
    Currently the issue of Quality of Service (QoS) is a major problem in IP networks due to the growth in multimedia traffic (e.g. voice and video applications) and therefore many mechanisms like IntServ, DiffServ, etc. have been proposed. Since the IEEE 802.11b (or Wi-Fi) standard was approved in 1999, it has gained in popularity to become the leading Wireless Local Area Network (WLAN) technology with millions of such networks deployed worldwide. Wireless networks have a limited capacity (11 Mbits/s in the case of Wi-Fi networks) owing to the limited amount of frequency spectrum available. At any given time there may be a large number of users contending for access which results in the bandwidth available to each user being severely limited. Moreover, the system does not differentiate between traffic types which means that all traffic, regardless of its importance or priority, experiences the same QoS. An important network application requiring QoS guarantees is the provision of time-bounded services, such as voice over IP and video streaming, where the combination of packet delay, jitter and packet loss will impact on the perceived QoS. Consequently this has led to a large amount of research work focussing mainly on QoS enhancement schemes for the 802.11 MAC mechanism. The Task Group E of the IEEE 802.11 working group has been developing an extension to the Wi-Fi standard that proposes to make changes to the MAC mechanism to support applications with QoS requirements. The 802.11e QoS standard is currently undergoing final revisions before approval expected sometime in 2004. As 802.11e WLAN equipment is not yet available, performance reports can only be based on simulation. The objective of this thesis was to develop a computer simulator that implements the upcoming IEEE 802.11e standard and to use this simulator to evaluate the QoS performance enhancement potential of 802.11e. This thesis discusses the QoS facilities, analyses the MAC protocol enhancements and compares them with the original 802.11 standard. The issue of QoS provisioning is primarily concerned with providing predictable performance guarantees with regard to throughput, packet delay, jitter and packet loss. The simulated results indicate that the proposed QoS enhancements to the MAC will considerably improve QoS performance in 802.11b WLANs. However, in order for the proposed 802.11e QoS mechanism to be effective the 802.11e parameters will need to be continually adjusted in order to ensure QoS guarantees are fulfilled for all traffic loads

    Supporting Internet Access and Quality of Service in Distributed Wireless Ad Hoc Networks

    Get PDF
    In this era of wireless hysteria, with continuous technological advances in wireless communication and new wireless technologies becoming standardized at a fast rate, we can expect an increased interest for wireless networks, such as ad hoc and mesh networks. These networks operate in a distributed manner, independent of any centralized device. In order to realize the practical benefits of ad hoc networks, two challenges (among others) need to be considered: distributed QoS guarantees and multi-hop Internet access. In this thesis we present conceivable solutions to both of these problems. An autonomous, stand-alone ad hoc network is useful in many cases, such as search and rescue operations and meetings where participants wish to quickly share information. However, an ad hoc network connected to the Internet is even more desirable. This is because Internet plays an important role in the daily life of many people by offering a broad range of services. In this thesis we present AODV+, which is our solution to achieve this network interconnection between a wireless ad hoc network and the wired Internet. Providing QoS in distributed wireless networks is another challenging, but yet important, task mainly because there is no central device controlling the medium access. In this thesis we propose EDCA with Resource Reservation (EDCA/RR), which is a fully distributed MAC scheme that provides QoS guarantees by allowing applications with strict QoS requirements to reserve transmission time for contention-free medium access. Our scheme is compatible with existing standards and provides both parameterized and prioritized QoS. In addition, we present the Distributed Deterministic Channel Access (DDCA) scheme, which is a multi-hop extension of EDCA/RR and can be used in wireless mesh networks. Finally, we have complemented our simulation studies with real-world ad hoc and mesh network experiments. With the experience from these experiments, we obtained a clear insight into the limitations of wireless channels. We could conclude that a wise design of the network architecture that limits the number of consecutive wireless hops may result in a wireless mesh network that is able to satisfy users’ needs. Moreover, by using QoS mechanisms like EDCA/RR or DDCA we are able to provide different priorities to traffic flows and reserve resources for the most time-critical applications

    Traffic Control and Quality of Service in Wireless LANs

    Get PDF
    The thesis deals with two aspects of the IEEE 802.11 standard. The first is the so-called “performance anomaly”: the variable bandwidth of the links and the use of multiple transmission rates push the throughput of all stations to align to the slowest one. To tackle this problem we designed and developed a simple channel-aware scheduling algorithm, called DTT, which actualises the proportional fairness concept, thus leading to noteworthy improvements, and in particular to flow isolation. This is achieved by measuring link quality as the time needed to deliver a frame. The resource to share is no longer capacity, but the time the channel is in use. DTT has then been integrated into a prototype Access Point, which is the first working implementation of a scheduler based on proportional fairness. Secondly, we focused on 802.11e networks, which, though enhancing QoS support, still offer scarce reliability of QoS guarantees and suffer from network congestion. We devised two admission control algorithms to assess the maximum number of users allowable to the services while satisfying QoS requirements. Following the studies on DTT, both algorithms centre the admission test on the time occupancy of the medium. The first algorithm builds on an analytical model of the EDCA mode in non-saturation conditions. This closely matches the real behaviour of a network carrying time-sensitive applications, thus overcoming the limits of all previous works, based on saturation models. The second algorithm uses and extends to 802.11e the NUC, a parameter defined and proved effective for 802.11b systems. This scheme needs measures of the actual state of the network. Simulations run within the E-model framework show good accuracy performance for both models
    corecore