Performance Improvement in Muli-user MIMO Networks via Interference Alignment

Almost all wireless networks are interference limited. Interference management has been always a primary concern for large section of current wireless networks with exponentially growing devices, lack of centralized medium access, power management. Because of broadcast nature of the wireless channel, all signals from simultaneous transmissions from devices apart in the same space, are added to the desired signal at the receiver end. Therefore optimal spectrum efficiency in such systems mandates distributed, low complexity interference management strategies with very less overhead which should be far more superior than existing successive interference cancellation, highly complex multiuser detection techniques. In this thesis, a novel interference management scheme- “Interference alignment” scheme for multi user scenario is investigated and analysed supporting the arguments with numerical results for most scenarios. Firstly, the concept of interference channel, Degrees of Freedom were well established which are prerequisite in understanding the predicament of multi user wireless channels. Later on, interference alignment concept has been put forward stating its origin back from linear algebra. IA for K-user MIMO is studied. In a fully connected K-user network with perfect channel state information, IA minimizes the interference space dimension at intended receivers thus maximizing the achievable capacity of the entire channel and increasing the Multiplexing gain. Later on the idea of IA is extended to multi-hop networks. A practical cellular multi-hop wireless network is considered and distributed interference alignment technique is implemented which shows superior performance even in high interference case. All IA schemes assume that the channels are full rank richly scattered environments which in practise is not always possible. The idea of using relays to act as external scatters which increase the rank of effective channel observed is considered. So two novel distributed relaying schemes have been proposed modifying the existing IA scheme to fit the case for rank deficient channels and still achieve multiplexing gain on par with full rank channels. The proposed algorithms doesn’t require global channel state information at all nodes except at relay nodes, doesn’t need large symbol extensions, and still are able to enhance the sum capacity of the networ

D3.2 First performance results for multi -node/multi -antenna transmission technologies

This deliverable describes the current results of the multi-node/multi-antenna technologies investigated within METIS and analyses the interactions within and outside Work Package 3. Furthermore, it identifies the most promising technologies based on the current state of obtained results. This document provides a brief overview of the results in its first part. The second part, namely the Appendix, further details the results, describes the simulation alignment efforts conducted in the Work Package and the interaction of the Test Cases. The results described here show that the investigations conducted in Work Package 3 are maturing resulting in valuable innovative solutions for future 5G systems.Fantini. R.; Santos, A.; De Carvalho, E.; Rajatheva, N.; Popovski, P.; Baracca, P.; Aziz, D.... (2014). D3.2 First performance results for multi -node/multi -antenna transmission technologies. http://hdl.handle.net/10251/7675

D 3. 3 Final performance results and consolidated view on the most promising multi -node/multi -antenna transmission technologies

This document provides the most recent updates on the technical contributions and research challenges focused in WP3. Each Technology Component (TeC) has been evaluated under possible uniform assessment framework of WP3 which is based on the simulation guidelines of WP6. The performance assessment is supported by the simulation results which are in their mature and stable state. An update on the Most Promising Technology Approaches (MPTAs) and their associated TeCs is the main focus of this document. Based on the input of all the TeCs in WP3, a consolidated view of WP3 on the role of multinode/multi-antenna transmission technologies in 5G systems has also been provided. This consolidated view is further supported in this document by the presentation of the impact of MPTAs on METIS scenarios and the addressed METIS goals.Aziz, D.; Baracca, P.; De Carvalho, E.; Fantini, R.; Rajatheva, N.; Popovski, P.; Sørensen, JH.... (2015). D 3. 3 Final performance results and consolidated view on the most promising multi -node/multi -antenna transmission technologies. http://hdl.handle.net/10251/7675

Cooperative Radio Communications for Green Smart Environments

The demand for mobile connectivity is continuously increasing, and by 2020 Mobile and Wireless Communications will serve not only very dense populations of mobile phones and nomadic computers, but also the expected multiplicity of devices and sensors located in machines, vehicles, health systems and city infrastructures. Future Mobile Networks are then faced with many new scenarios and use cases, which will load the networks with different data traffic patterns, in new or shared spectrum bands, creating new specific requirements. This book addresses both the techniques to model, analyse and optimise the radio links and transmission systems in such scenarios, together with the most advanced radio access, resource management and mobile networking technologies. This text summarises the work performed by more than 500 researchers from more than 120 institutions in Europe, America and Asia, from both academia and industries, within the framework of the COST IC1004 Action on "Cooperative Radio Communications for Green and Smart Environments". The book will have appeal to graduates and researchers in the Radio Communications area, and also to engineers working in the Wireless industry. Topics discussed in this book include: • Radio waves propagation phenomena in diverse urban, indoor, vehicular and body environments• Measurements, characterization, and modelling of radio channels beyond 4G networks• Key issues in Vehicle (V2X) communication• Wireless Body Area Networks, including specific Radio Channel Models for WBANs• Energy efficiency and resource management enhancements in Radio Access Networks• Definitions and models for the virtualised and cloud RAN architectures• Advances on feasible indoor localization and tracking techniques• Recent findings and innovations in antenna systems for communications• Physical Layer Network Coding for next generation wireless systems• Methods and techniques for MIMO Over the Air (OTA) testin

Energy Efficient Massive MIMO and Beamforming for 5G Communications

Massive multiple-input multiple-output (MIMO) has been a key technique in the next generation of wireless communications for its potential to achieve higher capacity and data rates. However, the exponential growth of data traffic has led to a significant increase in the power consumption and system complexity. Therefore, we propose and study wireless technologies to improve the trade-off between system performance and power consumption of wireless communications. This Thesis firstly proposes a strategy with partial channel state information (CSI) acquisition to reduce the power consumption and hardware complexity of massive MIMO base stations. In this context, the employment of partial CSI is proposed in correlated communication channels with user mobility. By exploiting both the spatial correlation and temporal correlation of the channel, our analytical results demonstrate significant gains in the energy efficiency of the massive MIMO base station. Moreover, relay-aided communications have experienced raising interest; especially, two-way relaying systems can improve spectral efficiency with short required operating time. Therefore, this Thesis focuses on an uncorrelated massive MIMO two-way relaying system and studies power scaling laws to investigate how the transmit powers can be scaled to improve the energy efficiency up to several times the energy efficiency without power scaling while approximately maintaining the system performance. In a similar line, large antenna arrays deployed at the space-constrained relay would give rise to the spatial correlation. For this reason, this Thesis presents an incomplete CSI scheme to evaluate the trade-off between the spatial correlation and system performance. In addition, the advantages of linear processing methods and the effects of channel aging are investigated to further improve the relay-aided system performance. Similarly, large antenna arrays are required in millimeter-wave communications to achieve narrow beams with higher power gain. This poses the problem that locating the best beam direction requires high power and complexity consumption. Therefore, this Thesis presents several low-complexity beam alignment methods with respect to the state-of-the-art to evaluate the trade-off between complexity and system performance. Overall, extensive analytical and numerical results show an improved performance and validate the effectiveness of the proposed techniques

Programmable Active Mirror: A Scalable Decentralized Router

This work proposes and demonstrates the scalable router array that eliminates the internal centralization of conventional arrays, unlocking scalability, and the potential for a system composed of spatially separated elements that do not share a common timing reference. Architectural variations are presented, and their specific tradeoffs are discussed. The general operation, steering capabilities, signal and noise considerations, and timing control advantages are evaluated through analysis, simulation, and measurements. An element-level CMOS radio frequency integrated circuit (RFIC) is developed and used to demonstrate a four-element 25 GHz prototype router. The RFIC's programmable true time delay (TTD) control is used to correct path-length-difference-induced intersymbol interference (ISI) and improve a rerouted 270-Mb/s 64-QAM constellation from a completely scrambled state to an EVM of 4% rms (-28 dB). The prototype scalable router's concurrent dual-beam capabilities are demonstrated by simultaneously steering two full power beams at 24.9 and 25 GHz in two different directions in a free-space electromagnetic setup

Cooperative Radio Communications for Green Smart Environments

The demand for mobile connectivity is continuously increasing, and by 2020 Mobile and Wireless Communications will serve not only very dense populations of mobile phones and nomadic computers, but also the expected multiplicity of devices and sensors located in machines, vehicles, health systems and city infrastructures. Future Mobile Networks are then faced with many new scenarios and use cases, which will load the networks with different data traffic patterns, in new or shared spectrum bands, creating new specific requirements. This book addresses both the techniques to model, analyse and optimise the radio links and transmission systems in such scenarios, together with the most advanced radio access, resource management and mobile networking technologies. This text summarises the work performed by more than 500 researchers from more than 120 institutions in Europe, America and Asia, from both academia and industries, within the framework of the COST IC1004 Action on "Cooperative Radio Communications for Green and Smart Environments". The book will have appeal to graduates and researchers in the Radio Communications area, and also to engineers working in the Wireless industry. Topics discussed in this book include: • Radio waves propagation phenomena in diverse urban, indoor, vehicular and body environments• Measurements, characterization, and modelling of radio channels beyond 4G networks• Key issues in Vehicle (V2X) communication• Wireless Body Area Networks, including specific Radio Channel Models for WBANs• Energy efficiency and resource management enhancements in Radio Access Networks• Definitions and models for the virtualised and cloud RAN architectures• Advances on feasible indoor localization and tracking techniques• Recent findings and innovations in antenna systems for communications• Physical Layer Network Coding for next generation wireless systems• Methods and techniques for MIMO Over the Air (OTA) testin

IRS-assisted UAV Communications: A Comprehensive Review

Intelligent reflecting surface (IRS) can smartly adjust the wavefronts in terms of phase, frequency, amplitude and polarization via passive reflections and without any need of radio frequency (RF) chains. It is envisaged as an emerging technology which can change wireless communication to improve both energy and spectrum efficiencies with low energy consumption and low cost. It can intelligently configure the wireless channels through a massive number of cost effective passive reflecting elements to improve the system performance. Similarly, unmanned aerial vehicle (UAV) communication has gained a viable attention due to flexible deployment, high mobility and ease of integration with several technologies. However, UAV communication is prone to security issues and obstructions in real-time applications. Recently, it is foreseen that UAV and IRS both can integrate together to attain unparalleled capabilities in difficult scenarios. Both technologies can ensure improved performance through proactively altering the wireless propagation using smart signal reflections and maneuver control in three dimensional (3D) space. IRS can be integrated in both aerial and terrene environments to reap the benefits of smart reflections. This study briefly discusses UAV communication, IRS and focuses on IRS-assisted UAC communications. It surveys the existing literature on this emerging research topic and highlights several promising technologies which can be implemented in IRS-assisted UAV communication. This study also presents several application scenarios and open research challenges. This study goes one step further to elaborate research opportunities to design and optimize wireless systems with low energy footprint and at low cost. Finally, we shed some light on future research aspects for IRS-assisted UAV communication

Optimising Cooperative Spectrum Sensing in Cognitive Radio Networks Using Interference Alignment and Space-Time Coding

In this thesis, the process of optimizing Cooperative Spectrum Sensing in Cognitive Radio has been investigated in fast-fading environments where simulation results have shown that its performance is limited by the Probability of Reporting Errors. By proposing a transmit diversity scheme using Differential space-time block codes (D-STBC) where channel state information (CSI) is not required and regarding multiple pairs of Cognitive Radios (CR’s) with single antennas as a virtual MIMO antenna arrays in multiple clusters, Differential space-time coding is applied for the purpose of decision reporting over Rayleigh channels. Both Hard and Soft combination schemes were investigated at the fusion center to reveal performance advantages for Hard combination schemes due to their minimal bandwidth requirements and simplistic implementation. The simulations results show that this optimization process achieves full transmit diversity, albeit with slight performance degradation in terms of power with improvements in performance when compared to conventional Cooperative Spectrum Sensing over non-ideal reporting channels. Further research carried out in this thesis shows performance deficits of Cooperative Spectrum Sensing due to interference on sensing channels of Cognitive Radio. Interference Alignment (IA) being a revolutionary wireless transmission strategy that reduces the impact of interference seems well suited as a strategy that can be used to optimize the performance of Cooperative Spectrum Sensing. The idea of IA is to coordinate multiple transmitters so that their mutual interference aligns at their receivers, facilitating simple interference cancellation techniques. Since its inception, research efforts have primarily been focused on verifying IA’s ability to achieve the maximum degrees of freedom (an approximation of sum capacity), developing algorithms for determining alignment solutions and designing transmission strategies that relax the need for perfect alignment but yield better performance. With the increased deployment of wireless services, CR’s ability to opportunistically sense and access the unused licensed frequency spectrum, without causing harmful interference to the licensed users becomes increasingly diminished, making the concept of introducing IA in CR a very attractive proposition. For a multiuser multiple-input–multiple-output (MIMO) overlay CR network, a space-time opportunistic IA (ST-OIA) technique has been proposed that allows spectrum sharing between a single primary user (PU) and multiple secondary users (SU) while ensuring zero interference to the PUs. With local CSI available at both the transmitters and receivers of SUs, the PU employs a space-time WF (STWF) algorithm to optimize its transmission and in the process, frees up unused eigenmodes that can be exploited by the SU. STWF achieves higher performance than other WF algorithms at low to moderate signal-to-noise ratio (SNR) regimes, which makes it ideal for implementation in CR networks. The SUs align their transmitted signals in such a way their interference impairs only the PU’s unused eigenmodes. For the multiple SUs to further exploit the benefits of Cooperative Spectrum Sensing, it was shown in this thesis that IA would only work when a set of conditions were met. The first condition ensures that the SUs satisfy a zero interference constraint at the PU’s receiver by designing their post-processing matrices such that they are orthogonal to the received signal from the PU link. The second condition ensures a zero interference constraint at both the PU and SUs receivers i.e. the constraint ensures that no interference from the SU transmitters is present at the output of the post-processing matrices of its unintended receivers. The third condition caters for the multiple SUs scenario to ensure interference from multiple SUs are aligned along unused eigenmodes. The SU system is assumed to employ a time division multiple access (TDMA) system such that the Principle of Reciprocity is employed towards optimizing the SUs transmission rates. Since aligning multiple SU transmissions at the PU is always limited by availability of spatial dimensions as well as typical user loads, the third condition proposes a user selection algorithm by the fusion centre (FC), where the SUs are grouped into clusters based on their numbers (i.e. two SUs per cluster) and their proximity to the FC, so that they can be aligned at each PU-Rx. This converts the cognitive IA problem into an unconstrained standard IA problem for a general cognitive system. Given the fact that the optimal power allocation algorithms used to optimize the SUs transmission rates turns out to be an optimal beamformer with multiple eigenbeams, this work initially proposes combining the diversity gain property of STBC, the zero-forcing function of IA and beamforming to optimize the SUs transmission rates. However, this solution requires availability of CSI, and to eliminate the need for this, this work then combines the D-STBC scheme with optimal IA precoders (consisting of beamforming and zero-forcing) to maximize the SUs data rates