Performance Analysis and Optimization of Tc-DTR IR-UWB Receivers over Multipath Fading Channels with Tone Interference

International audienceIn this paper, we analyze the performance of a particular class of transmitted-reference receivers for impulse radio ultra wideband communication systems, which is called chip-time differential transmitted-reference (Tc-DTR). The analysis aims at investigating the robustness of this receiver to single-tone and multi-tone narrowband interference (NBI) and comparing its performance with other non-coherent receivers that are proposed in the literature. It is shown that the Tc-DTR scheme provides more degrees of freedom for performance optimization and that it is inherently more robust to NBI than other non-coherent receivers. More specifically, it is analytically proved that the performance improvement is due to the chip-time-level differential encoding/decoding of the direct sequence (DS) code and to an adequate design of DS code and average pulse repetition time. The analysis encompasses performance metrics that are useful for both data detection (i.e., average bit error probability) and timing acquisition (i.e., false-alarm probability Pfa and detection probability Pd). Moving from the proposed sem-analytical framework, the optimal code design and system parameters are derived, and it is highlighted that the same optimization criteria can be applied to all the performance metrics considered in this paper. In addition, analytical frameworks and theoretical findings are substantiated through Monte Carlo simulations

Timing Acquisition Performance Metrics of Tc-DTR UWB Receivers over Frequency-Selective Fading Channels with Narrow-Band Interference: Performance Analysis and Optimization

International audienceThe successful deployment of Impulse Radio (IR) Ultra Wide Band (UWB) wireless communication systems requie that they coexist and contend with a variety of interfering signals co–located over the same transmission band. In fact, if on the one hand the large transmission bandwidth of IR–UWB signals allows them to resolve multipath components and exploit multipath diversity, on the other hand it yields some new coexistence challenges for both unlicensed commercial and military communication systems, which are required to be robust to unintentional and intentional jammers, respectively. In particular, the design and analysis of low–complexity receiver schemes with good synchronization capabilities and high robustness to Narrow–Band Interference (NBI) is acknowledged as an important issue in IR–UWB research. Motivated by this consideration, in [1] we have recently proposed a low–complexity receiver design, the so–called Chip–Time Differential Transmitted–Reference (Tc–DTR) scheme, and have shown that it is more robust to NBI than other non–coherent receiver schemes available in the literature. In this paper, we aim at generalizing the results in [1] and at developing the enabling analytical tools for the analysis and design of timing acquisition algorithms for non–coherent receivers over frequency–selective fading channels with NBI. Furthermore, we move from the proposed analytical framework to tackle the optimization problem of devising optimal signature codes to reduce the impact of NBI on the performance of the Tc–DTR synchronizer. Analytical frameworks and findings are substantiated via Monte Carlo simulations

Efficient approaches to robust and cooperative wireless network design

Thesis (Ph. D.)--Massachusetts Institute of Technology, Dept. of Electrical Engineering and Computer Science, 2008.This electronic version was submitted by the student author. The certified thesis is available in the Institute Archives and Special Collections.Includes bibliographical references (p. 181-200).In wireless networks, relaying and user cooperation offer several attractive benefits such as higher throughput, better power efficiency, and larger coverage. As a result, cooperative networks are regarded as one of the most promising enabling technologies able to meet the increasingly high rate demands and quality of service requirements in wireless networks. In this dissertation, we investigate the efficient design of cooperative wireless networks from the perspectives of robust resource allocation, wideband communications, and energy efficiency. Given that the primary resource to be allocated is the relay node's transmission power, we propose robust and efficient relay power allocation algorithms when the global channel state information is subject to uncertainty. In addition, we propose practical algorithms that do not require frequent tracking of the global channel state information. This work reveals that ignoring global channel state information uncertainties and solving the relay power optimization problems often lead to poor performance, highlighting the importance of robust algorithm designs in practical wireless networks. Wideband cooperative networks allow for both higher data rate and higher resistance to interference. Since the gains achieved by using cooperation come at the cost of higher node complexity and substantial coordination overhead, it is important to study practical low-complexity signaling and receiver schemes suitable for wideband networks. In particular, we consider transmitted-reference signaling schemes and provide a unified performance analysis in terms of bit error rate. Since wideband networks are expected to coexist with many existing narrowband systems, it is important to characterize the effect of narrowband interference. We further extend the performance analysis of transmitted-reference signaling schemes to include the effect of narrowband interference..(cont) Finally, we conclude by studying the benefits of cooperation in a wireless sensor network, which aims at detecting the presence or absence of a certain physical phenomenon of interest using geographically dispersed sensor nodes. We propose a consensus flooding protocol and analyze its average energy consumption. We investigate the tradeoff between the detection reliability and the energy efficiency when nodes are allowed to cooperate. By addressing the above design challenges, this dissertation will be useful for obtaining insight into the theory and application of cooperative networks in future communication systemsby Tony Q.S. Quek.Ph.D

Relaying Techniques for Multi Hop Differential Transmitted Reference IR-UWB Systems

This thesis develops novel relaying techniques to overcome the limited coverage of Impulse Radio Ultra Wideband (IR-UWB) systems based on Differential Transmitted Reference (DTR). Firstly, we describe a cooperative approach for two hop Amplify-and-Forward (A&F) relaying that exploits both the signal forwarded by the relay and the one directly transmitted by the source. After deriving the log-likelihood ratio based decision rule, we propose a semi-analytical power allocation strategy by evaluating a closed form expression for the effective Signal to Noise Ratio (SNR) at the destination, which is maximized by exhaustive search. Successively, we present a Joint Power Allocation and Path Selection (JPAPS) method for multi hop Decode-and-Forward (D&F) relaying. Starting from the heuristic consideration that the overall Bit Error Rate (BER) of the system is essentially driven by the quality of the path with the best performance, the proposed technique associates to each possible route a metric given by an approximation of the minimum BER which can be achieved as the power allocation coefficients vary and then takes into account only the path minimizing that metric. Specifically, we employ an equal SNR power allocation strategy that yields a closed form expression for the power allocation coefficients and we describe a path selection algorithm with polynomial complexity. Simulation results show the remarkable SNR gains obtained by the proposed schemes with respect to direct transmission and existing relaying techniques. Lo scopo di questa tesi è elaborare nuove tecniche di relaying per risolvere il problema della copertura limitata in sistemi radio ad impulsi a banda ultra larga (Impulse-Radio Ultra-Wideband, IR-UWB) basati su Differential Transmitted Reference (DTR). Innanzi tutto, si descrive un approccio cooperativo per singolo relay Amplify-and-Forward (A&F) che sfrutta sia il segnale inoltrato dal relay sia quello trasmesso direttamente dalla sorgente. Dopo aver introdotto una regola di decisione basata sul logaritmo del rapporto di verosimiglianza, si propone una strategia di allocazione di potenza semi-analitica valutando un'espressione in forma chiusa per il rapporto segnale rumore (SNR) effettivo al nodo destinazione, che viene massimizzato per mezzo di una ricerca esaustiva. Successivamente, si presenta un metodo congiunto di allocazione di potenza e scelta del cammino ottimo (Joint Power Allocation and Path Selection, JPAPS) per relay Decode-and-Forward (D&F) multipli. Partendo dalla considerazione euristica che la probabilità d'errore complessiva del sistema dipende essenzialmente dalla qualità del cammino migliore, la tecnica proposta associa ad ogni possibile percorso una metrica data da un'approssimazione della minima probabilità d'errore ottenibile al variare dei coefficienti di allocazione di potenza e poi prende in considerazione soltanto il cammino che minimizza tale metrica. Specificatamente, si adopera una strategia di allocazione di potenza in cui si impone l'uguaglianza degli SNR dei singoli link (equal SNR power allocation strategy), ottenendo un'espressione in forma chiusa per i coefficienti di allocazione di potenza. Inoltre, si descrive un algoritmo di scelta del cammino ottimo con complessità polinomiale. I risultati delle simulazioni mostrano i notevoli guadagni in termini di SNR ottenuti dagli schemi proposti rispetto alla trasmissione diretta e alle altre tecniche di relaying esistenti

Performance Enhancement of Ultra Wideband WPAN using Narrowband Interference Mitigation Techniques

A new promising technique adopted by 4G community is ultra-wideband technology, which offers a solution for high bandwidth, high data rate, low cost, low power consumption, position location capability etc. A conventional type of UWB communication is impulse radio, where very short transient pulses are transmitted rather than a modulated carrier. Consequently, the spectrum is spread over several GHz, complying with the definition of UWB. Currently, the Rake receiver used for spread spectrum is considered a very promising candidate for UWB reception, due to its capability of collecting multipath components. Since UWB signals occupy such a large bandwidth, they operate as an overlay system with other existing narrowband (NB) radio systems overlapping with their bands. In order to ensure a robust communication link, the issue of coexistence and interference of UWB systems with current indoor wireless systems must be considered. Ultra Wideband technology with its application, advantages and disadvantages are discussed in detail. Design of UWB short pulse and a detail study IEEE 802.15.3a UWB channel models statistical characteristics have been analyzed through simulation. Simulation studies are performed and improved techniques are suggested for interference reduction in both Impulse Radio based UWB and Transmitted Reference type of UWB system. Modified TR-UWB receiver with UWB pulse design at transmitter end and notch filtering at receiver’s front end proved to be more efficient in single NBI, multiple NBI and WBI suppression. Extensive simulation studies to support the efficacy of the proposed schemes are carried out in the MATLAB. Bit error rate (BER) performance study for different data rates over different UWB channel models are also analyzed using proposed receiver models. Performance improvement of TR-UWB system is noticed using the proposed techniques

Synchronization for impulse radio ultra-wideband system

Master'sMASTER OF ENGINEERIN

An Assessment of Indoor Geolocation Systems

Currently there is a need to design, develop, and deploy autonomous and portable indoor geolocation systems to fulfil the needs of military, civilian, governmental and commercial customers where GPS and GLONASS signals are not available due to the limitations of both GPS and GLONASS signal structure designs. The goal of this dissertation is (1) to introduce geolocation systems; (2) to classify the state of the art geolocation systems; (3) to identify the issues with the state of the art indoor geolocation systems; and (4) to propose and assess four WPI indoor geolocation systems. It is assessed that the current GPS and GLONASS signal structures are inadequate to overcome two main design concerns; namely, (1) the near-far effect and (2) the multipath effect. We propose four WPI indoor geolocation systems as an alternative solution to near-far and multipath effects. The WPI indoor geolocation systems are (1) a DSSS/CDMA indoor geolocation system, (2) a DSSS/CDMA/FDMA indoor geolocation system, (3) a DSSS/OFDM/CDMA/FDMA indoor geolocation system, and (4) an OFDM/FDMA indoor geolocation system. Each system is researched, discussed, and analyzed based on its principle of operation, its transmitter, the indoor channel, and its receiver design and issues associated with obtaining an observable to achieve indoor navigation. Our assessment of these systems concludes the following. First, a DSSS/CDMA indoor geolocation system is inadequate to neither overcome the near-far effect not mitigate cross-channel interference due to the multipath. Second, a DSSS/CDMA/FDMA indoor geolocation system is a potential candidate for indoor positioning, with data rate up to 3.2 KBPS, pseudorange error, less than to 2 m and phase error less than 5 mm. Third, a DSSS/OFDM/CDMA/FDMA indoor geolocation system is a potential candidate to achieve similar or better navigation accuracy than a DSSS/CDMA indoor geolocation system and data rate up to 5 MBPS. Fourth, an OFDM/FDMA indoor geolocation system is another potential candidate with a totally different signal structure than the pervious three WPI indoor geolocation systems, but with similar pseudorange error performance