10,123 research outputs found
Sum-of-Squares approach to feedback control of laminar wake flows
A novel nonlinear feedback control design methodology for incompressible
fluid flows aiming at the optimisation of long-time averages of flow quantities
is presented. It applies to reduced-order finite-dimensional models of fluid
flows, expressed as a set of first-order nonlinear ordinary differential
equations with the right-hand side being a polynomial function in the state
variables and in the controls. The key idea, first discussed in Chernyshenko et
al. 2014, Philos. T. Roy. Soc. 372(2020), is that the difficulties of treating
and optimising long-time averages of a cost are relaxed by using the
upper/lower bounds of such averages as the objective function. In this setting,
control design reduces to finding a feedback controller that optimises the
bound, subject to a polynomial inequality constraint involving the cost
function, the nonlinear system, the controller itself and a tunable polynomial
function. A numerically tractable approach to the solution of such optimisation
problems, based on Sum-of-Squares techniques and semidefinite programming, is
proposed.
To showcase the methodology, the mitigation of the fluctuation kinetic energy
in the unsteady wake behind a circular cylinder in the laminar regime at
Re=100, via controlled angular motions of the surface, is numerically
investigated. A compact reduced-order model that resolves the long-term
behaviour of the fluid flow and the effects of actuation, is derived using
Proper Orthogonal Decomposition and Galerkin projection. In a full-information
setting, feedback controllers are then designed to reduce the long-time average
of the kinetic energy associated with the limit cycle. These controllers are
then implemented in direct numerical simulations of the actuated flow. Control
performance, energy efficiency, and physical control mechanisms identified are
analysed. Key elements, implications and future work are discussed
Comparison of POD reduced order strategies for the nonlinear 2D Shallow Water Equations
This paper introduces tensorial calculus techniques in the framework of
Proper Orthogonal Decomposition (POD) to reduce the computational complexity of
the reduced nonlinear terms. The resulting method, named tensorial POD, can be
applied to polynomial nonlinearities of any degree . Such nonlinear terms
have an on-line complexity of , where is the
dimension of POD basis, and therefore is independent of full space dimension.
However it is efficient only for quadratic nonlinear terms since for higher
nonlinearities standard POD proves to be less time consuming once the POD basis
dimension is increased. Numerical experiments are carried out with a two
dimensional shallow water equation (SWE) test problem to compare the
performance of tensorial POD, standard POD, and POD/Discrete Empirical
Interpolation Method (DEIM). Numerical results show that tensorial POD
decreases by times the computational cost of the on-line stage of
standard POD for configurations using more than model variables. The
tensorial POD SWE model was only slower than the POD/DEIM SWE model
but the implementation effort is considerably increased. Tensorial calculus was
again employed to construct a new algorithm allowing POD/DEIM shallow water
equation model to compute its off-line stage faster than the standard and
tensorial POD approaches.Comment: 23 pages, 8 figures, 5 table
Adaptive Nonlinear RF Cancellation for Improved Isolation in Simultaneous Transmit-Receive Systems
This paper proposes an active radio frequency (RF) cancellation solution to
suppress the transmitter (TX) passband leakage signal in radio transceivers
supporting simultaneous transmission and reception. The proposed technique is
based on creating an opposite-phase baseband equivalent replica of the TX
leakage signal in the transceiver digital front-end through adaptive nonlinear
filtering of the known transmit data, to facilitate highly accurate
cancellation under a nonlinear TX power amplifier (PA). The active RF
cancellation is then accomplished by employing an auxiliary transmitter chain,
to generate the actual RF cancellation signal, and combining it with the
received signal at the receiver (RX) low noise amplifier (LNA) input. A
closed-loop parameter learning approach, based on the decorrelation principle,
is also developed to efficiently estimate the coefficients of the nonlinear
cancellation filter in the presence of a nonlinear TX PA with memory, finite
passive isolation, and a nonlinear RX LNA. The performance of the proposed
cancellation technique is evaluated through comprehensive RF measurements
adopting commercial LTE-Advanced transceiver hardware components. The results
show that the proposed technique can provide an additional suppression of up to
54 dB for the TX passband leakage signal at the RX LNA input, even at
considerably high transmit power levels and with wide transmission bandwidths.
Such novel cancellation solution can therefore substantially improve the TX-RX
isolation, hence reducing the requirements on passive isolation and RF
component linearity, as well as increasing the efficiency and flexibility of
the RF spectrum use in the emerging 5G radio networks.Comment: accepted to IEE
Use of system identification techniques for improving airframe finite element models using test data
A method for using system identification techniques to improve airframe finite element models using test data was developed and demonstrated. The method uses linear sensitivity matrices to relate changes in selected physical parameters to changes in the total system matrices. The values for these physical parameters were determined using constrained optimization with singular value decomposition. The method was confirmed using both simple and complex finite element models for which pseudo-experimental data was synthesized directly from the finite element model. The method was then applied to a real airframe model which incorporated all of the complexities and details of a large finite element model and for which extensive test data was available. The method was shown to work, and the differences between the identified model and the measured results were considered satisfactory
Bibliographic Review on Distributed Kalman Filtering
In recent years, a compelling need has arisen to understand the effects of distributed information structures on estimation and filtering. In this paper, a bibliographical review on distributed Kalman filtering (DKF) is provided.\ud
The paper contains a classification of different approaches and methods involved to DKF. The applications of DKF are also discussed and explained separately. A comparison of different approaches is briefly carried out. Focuses on the contemporary research are also addressed with emphasis on the practical applications of the techniques. An exhaustive list of publications, linked directly or indirectly to DKF in the open literature, is compiled to provide an overall picture of different developing aspects of this area
- …