Design of rate-adaptive MAC and medium aware routing protocols for multi-rate, multi-hop wireless networks

This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.The IEEE 802.11 standard conformant wireless communication stations have multi-rate transmission capability. To achieve greater communication efficiency, multi-rate capable stations use rateadaptation to select appropriate transmission rate according to variations in the channel quality. The thesis presents two rate-adaptation schemes, each belonging to one of the two classes of rateadaptation schemes i.e.(1) the frame-transmission statistics based schemes, and (2) Signal-to-Noise Ratio (SNR) based, closed loop schemes. The SNR-based rate-adaptation scheme, proposed in this thesis uses a novel mechanism of delivering a receiver’s feedback to a transmitter; without requiring any modification in the standard frames as suggested by existing research. The frame-transmissionstatistics based rate adaptation solution uses an on-demand incremental strategy for selecting a rate-selection threshold. This solution is based on a cross-layer communication framework, where the rate-adaptation module uses information to/from the Application layer along with relevant information from the Medium Access Control (MAC) sub-layer. The proposed solutions are highly responsive when compared with existing rate-adaptation schemes; responsiveness is one of the key factors in the design of such protocols. The novel feedback mechanism makes it possible to achieve frame-loss differentiation with just three frames, avoiding the use of Request To Send/ Clear To Send (RTS/CTS) frames and further delays in this process. Performance tests have affirmed that the proposed rate-adaptation schemes are energy efficient; with efficiency up to 19% in specific test scenarios. In terms of throughput and frame loss-differentiation mechanisms, the proposed schemes have shown significantly better performance.Routing protocols for Mobile Ad-Hoc Networks (MANETs) use broadcast frames during the route discovery process. The 802.11 mandates the use of different transmission rates for broadcast and unicast (data-) frames. In many cases it causes creation of communication gray zones, where stations which are marked as ‘reachable neighbours’ using the broadcast frames (using lower transmission rate) are not accessible during normal, unicast communication (mainly at a higher rate). Similarly, higher device density, interference and mobility cause variable medium access delays. The IEEE 802.11e introduces four different MAC level queues for four access categories, maintaining service priority within the queues; which implies that frames from a higher priority queue are serviced more frequently than those belonging to lower priority queues. Such an enhancement at the MAC sub-layer introduces uneven queuing delays. Conventional routing protocols are unaware of such MAC specific constraints and as a result these factors are not considered which result in severe performance deterioration. To meet such challenges, the thesis presents a medium aware distance vector (MADV) routing protocol for MANETs. MADV uses MAC and physical layer (PHY) specific information in the route metric and maintains a separate route per-AC-per-destination in its routing tables. The MADV-metric can be incorporated into various routing rotocols and its applicability is determined by the possibility of provision of MAC dependent arameters that are used to determine the hop-by-hop MADV-metric values. Simulation tests and omparison with existing MANET protocols demonstrate the effectiveness of incorporating the medium dependent parameters and show that MADV is significantly better in terms of end-to-end delay and throughput

STiCMAC: A MAC Protocol for Robust Space-Time Coding in Cooperative Wireless LANs

Relay-assisted cooperative wireless communication has been shown to have significant performance gains over the legacy direct transmission scheme. Compared with single relay based cooperation schemes, utilizing multiple relays further improves the reliability and rate of transmissions. Distributed space-time coding (DSTC), as one of the schemes to utilize multiple relays, requires tight coordination between relays and does not perform well in a distributed environment with mobility. In this paper, a cooperative medium access control (MAC) layer protocol, called \emph{STiCMAC}, is designed to allow multiple relays to transmit at the same time in an IEEE 802.11 network. The transmission is based on a novel DSTC scheme called \emph{randomized distributed space-time coding} (\emph{R-DSTC}), which requires minimum coordination. Unlike conventional cooperation schemes that pick nodes with good links, \emph{STiCMAC} picks a \emph{transmission mode} that could most improve the end-to-end data rate. Any station that correctly receives from the source can act as a relay and participate in forwarding. The MAC protocol is implemented in a fully decentralized manner and is able to opportunistically recruit relays on the fly, thus making it \emph{robust} to channel variations and user mobility. Simulation results show that the network capacity and delay performance are greatly improved, especially in a mobile environment.Comment: This paper is a revised version of a paper with the same name submitted to IEEE Transaction on Wireless Communications. STiCMAC protocol with RTS/CTS turned off is presented in the appendix of this draf

Quality of service differentiation for multimedia delivery in wireless LANs

Delivering multimedia content to heterogeneous devices over a variable networking environment while maintaining high quality levels involves many technical challenges. The research reported in this thesis presents a solution for Quality of Service (QoS)-based service differentiation when delivering multimedia content over the wireless LANs. This thesis has three major contributions outlined below: 1. A Model-based Bandwidth Estimation algorithm (MBE), which estimates the available bandwidth based on novel TCP and UDP throughput models over IEEE 802.11 WLANs. MBE has been modelled, implemented, and tested through simulations and real life testing. In comparison with other bandwidth estimation techniques, MBE shows better performance in terms of error rate, overhead, and loss. 2. An intelligent Prioritized Adaptive Scheme (iPAS), which provides QoS service differentiation for multimedia delivery in wireless networks. iPAS assigns dynamic priorities to various streams and determines their bandwidth share by employing a probabilistic approach-which makes use of stereotypes. The total bandwidth to be allocated is estimated using MBE. The priority level of individual stream is variable and dependent on stream-related characteristics and delivery QoS parameters. iPAS can be deployed seamlessly over the original IEEE 802.11 protocols and can be included in the IEEE 802.21 framework in order to optimize the control signal communication. iPAS has been modelled, implemented, and evaluated via simulations. The results demonstrate that iPAS achieves better performance than the equal channel access mechanism over IEEE 802.11 DCF and a service differentiation scheme on top of IEEE 802.11e EDCA, in terms of fairness, throughput, delay, loss, and estimated PSNR. Additionally, both objective and subjective video quality assessment have been performed using a prototype system. 3. A QoS-based Downlink/Uplink Fairness Scheme, which uses the stereotypes-based structure to balance the QoS parameters (i.e. throughput, delay, and loss) between downlink and uplink VoIP traffic. The proposed scheme has been modelled and tested through simulations. The results show that, in comparison with other downlink/uplink fairness-oriented solutions, the proposed scheme performs better in terms of VoIP capacity and fairness level between downlink and uplink traffic

Performance of an adaptive multimedia mechanism in a wireless multi-user environment

With the increasing popularity of accessing multimedia services over different wireless networks, researchers have been trying to develop different adaptive multimedia mechanisms in order to mitigate the impact of fluctuating radio resources. This paper considers the case when multiple users stream video over the same IEEE 802.11b WLAN using a newly proposed Signal Strength-based Adaptive Multimedia Delivery Mechanism (SAMMy). SAMMy makes use of the IEEE 802.11k standard and uses estimated signal strength, location, and packet loss as part of its adaptive mechanism in order to increase user perceived quality for multimedia streaming applications in wireless networks. SAMMy is evaluated by modeling and simulations and compared with another adaptive multimedia delivery mechanism TFRC, in terms of aggregate throughput and fairness. The results show that the proposed signal strengthbased adaptive multimedia delivery scheme outperforms the other scheme in terms of both throughput and fairness when performing video streaming in WLAN

Frequency-aware rate adaptation and MAC protocol

There has been burgeoning interest in wireless technologies that can use wider frequency spectrum. Technology advances, such as 802.11n and ultra-wideband (UWB), are pushing toward wider frequency bands. The analog-to-digital TV transition has made 100-250 MHz of digital whitespace bandwidth available for unlicensed access. Also, recent work on WiFi networks has advocated discarding the notion of channelization and allowing all nodes to access the wide 802.11 spectrum in order to improve load balancing. This shift towards wider bands presents an opportunity to exploit frequency diversity. Specifically, frequencies that are far from each other in the spectrum have significantly different SNRs, and good frequencies differ across sender-receiver pairs. This paper presents FARA, a combined frequency-aware rate adaptation and MAC protocol. FARA makes three departures from conventional wireless network design: First, it presents a scheme to robustly compute per-frequency SNRs using normal data transmissions. Second, instead of using one bit rate per link, it enables a sender to adapt the bitrate independently across frequencies based on these per-frequency SNRs. Third, in contrast to traditional frequency-oblivious MAC protocols, it introduces a MAC protocol that allocates to a sender-receiver pair the frequencies that work best for that pair. We have implemented FARA in FPGA on a wideband 802.11-compatible radio platform. Our experiments reveal that FARA provides a 3.1x throughput improvement in comparison to frequency-oblivious systems that occupy the same spectrum.Industrial Technology Research InstituteNational Science Foundation (U.S.)

FastM: Design and Evaluation of a Fast Mobility Mechanism for Wireless Mesh Networks

Although there is a large volume of work in the literature in terms of mobility approaches for Wireless Mesh Networks, usually these approaches introduce high latency in the handover process and do not support realtime services and applications. Moreover, mobility is decoupled from routing, which leads to inefficiency to both mobility and routing approaches with respect to mobility. In this paper we present a new extension to proactive routing protocols using a fast mobility extension, FastM, with the purpose of increasing handover performance in Wireless Mesh Networks. With this new extension, a new concept is created to integrate information between neighbor wireless mesh routers, managing locations of clients associated to wireless mesh routers in a certain neighborhood, and avoiding packet loss during handover. The proposed mobility approach is able to optimize the handover process without imposing any modifications to the current IEE 802.11 MAC protocol and use unmodified clients. Results show the improved efficiency of the proposed scheme: metrics such as disconnection time, throughput, packet loss and control overhead are largely improved when compared to previous approaches. Moreover, these conclusions apply to mobility scenarios, although mobility decreases the performance of the handover approach, as expected