Decoder Hardware Architecture for HEVC

This chapter provides an overview of the design challenges faced in the implementation of hardware HEVC decoders. These challenges can be attributed to the larger and diverse coding block sizes and transform sizes, the larger interpolation filter for motion compensation, the increased number of steps in intra prediction and the introduction of a new in-loop filter. Several solutions to address these implementation challenges are discussed. As a reference, results for an HEVC decoder test chip are also presented.Texas Instruments Incorporate

A 249-Mpixel/s HEVC Video-Decoder Chip for 4K Ultra-HD Applications

High Efficiency Video Coding, the latest video standard, uses larger and variable-sized coding units and longer interpolation filters than [H.264 over AVC] to better exploit redundancy in video signals. These algorithmic techniques enable a 50% decrease in bitrate at the cost of computational complexity, external memory bandwidth, and, for ASIC implementations, on-chip SRAM of the video codec. This paper describes architectural optimizations for an HEVC video decoder chip. The chip uses a two-stage subpipelining scheme to reduce on-chip SRAM by 56 kbytes-a 32% reduction. A high-throughput read-only cache combined with DRAM-latency-aware memory mapping reduces DRAM bandwidth by 67%. The chip is built for HEVC Working Draft 4 Low Complexity configuration and occupies 1.77 mm[superscript 2] in 40-nm CMOS. It performs 4K Ultra HD 30-fps video decoding at 200 MHz while consuming 1.19 [nJ over pixel] of normalized system power.Texas Instruments Incorporate

An energy-aware system-on-chip architecture for intra prediction in HEVC standard

High resolution 4K and 8K are becoming the more used in video applications. Those resolutions are well supported in the new HEVC standard. Thus, embedded solutions such as development of dedicated ystems-On-Chips (SOC) to accelerate video processing on one chip instead of only software solutions are commendable. This paper proposes a novel parallel and high efficient hardware accelerator for the intra prediction block. This accelerator achieves a high-speed treatment due to pipelined processing units and parallel shaped architecture. The complexity of memory access is also reduced thanks to the proposed design with less increased power consumption. The implementation was performed on the 7 Series FPGA 28 nm technology resources on Zynq-7000 and results show, that the proposed architecture takes 16520 LUTs and can reach 143.65 MHz as a maximum frequency and it is able to support the throughput of 3840×2160 sequence at 90 frames per second

Complexity Analysis Of Next-Generation VVC Encoding and Decoding

While the next generation video compression standard, Versatile Video Coding (VVC), provides a superior compression efficiency, its computational complexity dramatically increases. This paper thoroughly analyzes this complexity for both encoder and decoder of VVC Test Model 6, by quantifying the complexity break-down for each coding tool and measuring the complexity and memory requirements for VVC encoding/decoding. These extensive analyses are performed for six video sequences of 720p, 1080p, and 2160p, under Low-Delay (LD), Random-Access (RA), and All-Intra (AI) conditions (a total of 320 encoding/decoding). Results indicate that the VVC encoder and decoder are 5x and 1.5x more complex compared to HEVC in LD, and 31x and 1.8x in AI, respectively. Detailed analysis of coding tools reveals that in LD on average, motion estimation tools with 53%, transformation and quantization with 22%, and entropy coding with 7% dominate the encoding complexity. In decoding, loop filters with 30%, motion compensation with 20%, and entropy decoding with 16%, are the most complex modules. Moreover, the required memory bandwidth for VVC encoding/decoding are measured through memory profiling, which are 30x and 3x of HEVC. The reported results and insights are a guide for future research and implementations of energy-efficient VVC encoder/decoder.Comment: IEEE ICIP 202

HEVC video compression hardware designs

High Efficiency Video Coding (HEVC), a recently developed international standard for video compression, offers significantly better video compression efficiency than previous international standards. However, this coding gain comes with an increase in computational complexity. Therefore, in this thesis, we first designed a high performance hardware architecture for deblocking filter algorithm used in HEVC standard. Two parallel datapaths are used in the hardware to increase its performance. The proposed hardware is implemented in Verilog HDL. The Verilog RTL code is mapped to a Xilinx XC6VLX240T FPGA, and it is verified to work correctly on a Xilinx ML605 FPGA board which includes a Xilinx XC6VLX240T FPGA. The FPGA implementation can work at 108 MHz, and it can code 30 full HD (1920x1080) video frames per second. We then proposed an energy reduction technique for Sum of Absolute Transformed Difference (SATD) based HEVC intra mode decision algorithm. We designed an efficient hardware architecture for SATD based HEVC intra mode decision algorithm including the proposed technique. The proposed hardware is implemented in Verilog HDL. The Verilog RTL code is mapped to a Xilinx XC6VLX365T FPGA, and it is verified with post place & route simulations. The FPGA implementation can work at 116 MHz, and it can code 21 HD (1280x720) video frames per second. The proposed technique reduced its energy consumption up to 64.6% on this FPGA without any PSNR loss

HEVCのイントラ予測と画素適応オフセット推定の集積回路設計および圧縮センシングへの拡張

早大学位記番号:新7981早稲田大

Dynamically Reconfigurable Architectures and Systems for Time-varying Image Constraints (DRASTIC) for Image and Video Compression

In the current information booming era, image and video consumption is ubiquitous. The associated image and video coding operations require significant computing resources for both small-scale computing systems as well as over larger network systems. For different scenarios, power, bitrate and image quality can impose significant time-varying constraints. For example, mobile devices (e.g., phones, tablets, laptops, UAVs) come with significant constraints on energy and power. Similarly, computer networks provide time-varying bandwidth that can depend on signal strength (e.g., wireless networks) or network traffic conditions. Alternatively, the users can impose different constraints on image quality based on their interests. Traditional image and video coding systems have focused on rate-distortion optimization. More recently, distortion measures (e.g., PSNR) are being replaced by more sophisticated image quality metrics. However, these systems are based on fixed hardware configurations that provide limited options over power consumption. The use of dynamic partial reconfiguration with Field Programmable Gate Arrays (FPGAs) provides an opportunity to effectively control dynamic power consumption by jointly considering software-hardware configurations. This dissertation extends traditional rate-distortion optimization to rate-quality-power/energy optimization and demonstrates a wide variety of applications in both image and video compression. In each application, a family of Pareto-optimal configurations are developed that allow fine control in the rate-quality-power/energy optimization space. The term Dynamically Reconfiguration Architecture Systems for Time-varying Image Constraints (DRASTIC) is used to describe the derived systems. DRASTIC covers both software-only as well as software-hardware configurations to achieve fine optimization over a set of general modes that include: (i) maximum image quality, (ii) minimum dynamic power/energy, (iii) minimum bitrate, and (iv) typical mode over a set of opposing constraints to guarantee satisfactory performance. In joint software-hardware configurations, DRASTIC provides an effective approach for dynamic power optimization. For software configurations, DRASTIC provides an effective method for energy consumption optimization by controlling processing times. The dissertation provides several applications. First, stochastic methods are given for computing quantization tables that are optimal in the rate-quality space and demonstrated on standard JPEG compression. Second, a DRASTIC implementation of the DCT is used to demonstrate the effectiveness of the approach on motion JPEG. Third, a reconfigurable deblocking filter system is investigated for use in the current H.264/AVC systems. Fourth, the dissertation develops DRASTIC for all 35 intra-prediction modes as well as intra-encoding for the emerging High Efficiency Video Coding standard (HEVC)

GPU Parallelization of HEVC In-Loop Filters

In the High Efficiency Video Coding (HEVC) standard, multiple decoding modules have been designed to take advantage of parallel processing. In particular, the HEVC in-loop filters (i.e., the deblocking filter and sample adaptive offset) were conceived to be exploited by parallel architectures. However, the type of the offered parallelism mostly suits the capabilities of multi-core CPUs, thus making a real challenge to efficiently exploit massively parallel architectures such as Graphic Processing Units (GPUs), mainly due to the existing data dependencies between the HEVC decoding procedures. In accordance, this paper presents a novel strategy to increase the amount of parallelism and the resulting performance of the HEVC in-loop filters on GPU devices. For this purpose, the proposed algorithm performs the HEVC filtering at frame-level and employs intrinsic GPU vector instructions. When compared to the state-of-the-art HEVC in-loop filter implementations, the proposed approach also reduces the amount of required memory transfers, thus further boosting the performance. Experimental results show that the proposed GPU in-loop filters deliver a significant improvement in decoding performance. For example, average frame rates of 76 frames per second (FPS) and 125 FPS for Ultra HD 4K are achieved on an embedded NVIDIA GPU for All Intra and Random Access configurations, respectively

Circuit implementations for high-efficiency video coding tools

Thesis (S.M.)--Massachusetts Institute of Technology, Dept. of Electrical Engineering and Computer Science, 2012.Cataloged from PDF version of thesis.Includes bibliographical references (p. 71-72).High-Efficiency Video Coding (HEVC) is planned to be the successor video standard to the popular Advanced Video Coding (H.264/AVC) with a targeted 2x improvement in compression at the same quality. This improvement comes at the cost of increased complexity through the addition of new coding tools and increased computation in existing tools. The ever-increasing demand for higher resolution video further adds to the computation cost. In this work, digital circuits for two HEVC tools - inverse transform and deblocking filter are implemented to support Quad-Full HD (4K x 2K) video decoding at 30fps. Techniques to reduce power and area cost are investigated and synthesis results in 40nm CMOS technology and Virtex-6 FPGA platform are presented.by Mehul Tikekar.S.M