606 research outputs found
A decentralized scalable approach to voltage control of DC islanded microgrids
We propose a new decentralized control scheme for DC Islanded microGrids
(ImGs) composed by several Distributed Generation Units (DGUs) with a general
interconnection topology. Each local controller regulates to a reference value
the voltage of the Point of Common Coupling (PCC) of the corresponding DGU.
Notably, off-line control design is conducted in a Plug-and-Play (PnP) fashion
meaning that (i) the possibility of adding/removing a DGU without spoiling
stability of the overall ImG is checked through an optimization problem; (ii)
when a DGU is plugged in or out at most neighbouring DGUs have to update their
controllers and (iii) the synthesis of a local controller uses only information
on the corresponding DGU and lines connected to it. This guarantee total
scalability of control synthesis as the ImG size grows or DGU gets replaced.
Yes, under mild approximations of line dynamics, we formally guarantee
stability of the overall closed-loop ImG. The performance of the proposed
controllers is analyzed simulating different scenarios in PSCAD.Comment: arXiv admin note: text overlap with arXiv:1405.242
Performance evaluation of secondary control policies with respect to digital communications properties in inverter-based islanded microgrids
A key challenge for inverted-based microgrids working in islanded mode is to maintain their own frequency and voltage to a certain reference values while regulating the active and reactive power among distributed generators and loads. The implementation of frequency and voltage restoration control policies often requires the use of a digital communication network for real-time data exchange (tertiary control covers the coordi- nated operation of the microgrid and the host grid). Whenever a digital network is placed within the loop, the operation of the secondary control may be affected by the inherent properties of the communication technology. This paper analyses the effect that properties like transmission intervals and message dropouts have for four existing representative approaches to secondary control in a scalable islanded microgrid. The simulated results reveals pros and cons for each approach, and identifies threats that properly avoided or handled in advance can prevent failures that otherwise would occur. Selected experimental results on a low- scale laboratory microgrid corroborate the conclusions extracted from the simulation study.Peer ReviewedPostprint (author's final draft
A scalable line-independent design algorithm for voltage and frequency control in AC islanded microgrids
We propose a decentralized control synthesis procedure for stabilizing
voltage and frequency in AC Islanded microGrids (ImGs) composed of Distributed
Generation Units (DGUs) and loads interconnected through power lines. The
presented approach enables Plug-and-Play (PnP) operations, meaning that DGUs
can be added or removed without compromising the overall ImG stability. The
main feature of our approach is that the proposed design algorithm is
line-independent. This implies that (i) the synthesis of each local controller
requires only the parameters of the corresponding DGU and not the model of
power lines connecting neighboring DGUs, and (ii) whenever a new DGU is plugged
in, DGUs physically coupled with it do not have to retune their regulators
because of the new power line connected to them. Moreover, we formally prove
that stabilizing local controllers can be always computed, independently of the
electrical parameters. Theoretical results are validated by simulating in PSCAD
the behavior of a 10-DGUs ImG
Voltage stabilization in DC microgrids: an approach based on line-independent plug-and-play controllers
We consider the problem of stabilizing voltages in DC microGrids (mGs) given
by the interconnection of Distributed Generation Units (DGUs), power lines and
loads. We propose a decentralized control architecture where the primary
controller of each DGU can be designed in a Plug-and-Play (PnP) fashion,
allowing the seamless addition of new DGUs. Differently from several other
approaches to primary control, local design is independent of the parameters of
power lines. Moreover, differently from the PnP control scheme in [1], the
plug-in of a DGU does not require to update controllers of neighboring DGUs.
Local control design is cast into a Linear Matrix Inequality (LMI) problem
that, if unfeasible, allows one to deny plug-in requests that might be
dangerous for mG stability. The proof of closed-loop stability of voltages
exploits structured Lyapunov functions, the LaSalle invariance theorem and
properties of graph Laplacians. Theoretical results are backed up by
simulations in PSCAD
Plug-and-play robust voltage control of DC microgrids
The purpose of this paper is to explore the applicability of linear time-invariant dynamical systems with polytopic uncertainty for modeling and control of islanded dc microgrids under plug-and-play (PnP) functionality of distributed generations (DGs). We develop a robust decentralized voltage control framework to ensure robust stability and reliable operation for islanded dc microgrids. The problem of voltage control of islanded dc microgrids with PnP operation of DGs is formulated as a convex optimization problem with structural constraints on some decision variables. The proposed control scheme offers several advantages including decentralized voltage control with no communication link, transient stability/performance, PnP capability, scalability of design, applicability to microgrids with general topology, and robustness to microgrid uncertainties. The effectiveness of the proposed control approach is evaluated through simulation studies carried out in MATLAB/SimPowerSystems Toolbox
Review on Control of DC Microgrids and Multiple Microgrid Clusters
This paper performs an extensive review on control schemes and architectures applied to dc microgrids (MGs). It covers multilayer hierarchical control schemes, coordinated control strategies, plug-and-play operations, stability and active damping aspects, as well as nonlinear control algorithms. Islanding detection, protection, and MG clusters control are also briefly summarized. All the mentioned issues are discussed with the goal of providing control design guidelines for dc MGs. The future research challenges, from the authors' point of view, are also provided in the final concluding part
- …