35 research outputs found
Detection of PPM-UWB random signals
This paper focuses on the symbol detection problem of random pulse-position modulation (PPM) ultrawideband (UWB) signals in the absence of interframe interference. Particular attention is devoted to severely time-varying channels where optimal detectors are proposed for both uncorrelated and correlated scattering scenarios. This is done by assuming the received waveforms to be unknown parameters. In UWB communication systems, the assumption of unknown random waveforms is consistent with the fact that the received waveform has very little resemblance with the original transmitted pulse. In order to circumvent this limitation, a conditional approach is presented herein by compressing the likelihood ratio test with the information regarding the second-order moments of the end-to-end channel response. Both full-rank and rank-one detectors are derived. For the reduced complexity rank-one detector, an iterative procedure is presented that maximizes the J-divergence between the hypotheses to be tested. Finally, simulation results are provided to compare the performance of the proposed detectors in different propagation environments.Peer Reviewe
Multi Detector Fusion of Dynamic TOA Estimation using Kalman Filter
In this paper, we propose fusion of dynamic TOA (time of arrival) from
multiple non-coherent detectors like energy detectors operating at sub-Nyquist
rate through Kalman filtering. We also show that by using multiple of these
energy detectors, we can achieve the performance of a digital matched filter
implementation in the AWGN (additive white Gaussian noise) setting. We derive
analytical expression for number of energy detectors needed to achieve the
matched filter performance. We demonstrate in simulation the validity of our
analytical approach. Results indicate that number of energy detectors needed
will be high at low SNRs and converge to a constant number as the SNR
increases. We also study the performance of the strategy proposed using IEEE
802.15.4a CM1 channel model and show in simulation that two sub-Nyquist
detectors are sufficient to match the performance of digital matched filter
Non-Cooperative Detection of Ultra Wideband Signals
Techniques for the non-cooperative (non-matched filter) detection of impulse-like ultra wideband signals using channelized receiver architectures are developed and evaluated. Each technique considered is modeled and simulations conducted to characterize detection performance, the results of which are compared with the detection performance of three receivers: the matched filter receiver, which provides optimum detection performance in AWGN; the radiometer, or energy detector; and the multi-aperture cross correlation receiver. It is shown that a channelized receiver (with no downconversion) can provide approximately 2.5 dB improvement over the radiometer when performing detection using the temporal-temporal matrix (TTM). The TTM processing technique provides the best performance of all the proposed channelized receiver techniques. Detection with a downconverting channelized receiver is shown dependent on mixer phase value with performance variation generally minimized as the number of channels increases (channel bandwidth decreases)