A tightly-coupled GPS/INS/UWB cooperative positioning sensors system supported by V2I communication

This paper investigates a tightly-coupled Global Position System (GPS)/Ultra-Wideband (UWB)/Inertial Navigation System (INS) cooperative positioning scheme using a Robust Kalman Filter (RKF) supported by V2I communication. The scheme proposes a method that uses range measurements of UWB units transmitted among the terminals as augmentation inputs of the observations. The UWB range inputs are used to reform the GPS observation equations that consist of pseudo-range and Doppler measurements and the updated observation equation is processed in a tightly-coupled GPS/UWB/INS integrated positioning equation using an adaptive Robust Kalman Filter. The result of the trial conducted on the roof of the Nottingham Geospatial Institute (NGI) at the University of Nottingham shows that the integrated solution provides better accuracy and improves the availability of the system in GPS denied environments. RKF can eliminate the effects of gross errors. Additionally, the internal and external reliabilities of the system are enhanced when the UWB observables received from the moving terminals are involved in the positioning algorithm

Reliable Positioning and Journey Planning for Intelligent Transport Systems

Safety and reliability of intelligent transport systems applications require positioning accuracy at the sub-meter level with availability and integrity above 99%. At present, no single positioning sensor can meet these requirements in particular in the urban environment. Possible sensors that can be used for this task are first reviewed. Next, a suggested integrated system of low-cost real-time kinematic (RTK) GNSS, inertial measurement units (IMU) and vehicle odometer is discussed. To ensure positioning integrity, a method for fault detection in GNSS observations and computation of the protection levels (PL) that bound the position errors at a pre-set risk probability of the integrated sensors are presented. A case study is performed for demonstration. Moreover, to save energy, reduce pollution, and to improve the economy of the trip, proper journey planning is required. A new approach is introduced using 3D city models to predict the route with the best positioning integrity, availability and precision for route selection among different possible routes. The practical demonstration shows that effectiveness of this method. Finally, the potential of using the next generation SBAS for ITS applications was tested using kinematic tests carried out in various environments characterized by different levels of sky-visibility that may affect observations from GNSS

Decentralized Collaborative Localization Using Ultra-Wideband Ranging

This thesis summarizes the development of a collaborative localization algorithm simulation environment and the implementation of collaborative localization using Ultra-Wideband ranging in autonomous vehicles. In the developed simulation environment, multi-vehicle scenarios are testable with various sensor combinations and configurations. The simulation emulates the networking required for collaborative localization and serves as a platform for evaluating algorithm performance using Monte Carlo analysis. Monte-Carlo simulations were run using a number of situations and vehicles to test the efficacy of UWB sensors in decentralized collaborative localization as well as landmark measurements within an extended Kalman filter. Improvements from adding Ultra-Wideband ranging were shown in all simulated environments, with landmarks offering additional improvements to collaborative localization, and with the most significant accuracy improvements seen in GNSS-denied environments. Physical experiments were run using a by-wire GEM e6 from Autonomous Stuff in an urban environment in both collaborative and landmark setups. Due to higher than expected INS certainty, adding UWB measurements showed smaller improvements than simulations. Improvements of 9.2 to 12.1% were shown through the introduction of Ultra-Wideband ranging measurements in a decentralized collaborative localization algorithm. Improvements of 30.6 to 83.3% were shown in using UWB ranging measurements to landmarks in an Extended Kalman Filter for street crossing and tunnel environments respectively. These results are similar to the simulated data, and are promising in showing the efficacy of adding UWB ranging sensors to cars for collaborative and landmark localization, especially in GNSS-denied environments. In the future, additional moving vehicles with additional tags will be tested and further evaluations of the UWB ranging modules will be performed

Precise positioning of autonomous vehicles combining UWB ranging estimations with on-board sensors

In this paper, we analyze the performance of a positioning system based on the fusion of Ultra-Wideband (UWB) ranging estimates together with odometry and inertial data from the vehicle. For carrying out this data fusion, an Extended Kalman Filter (EKF) has been used. Furthermore, a post-processing algorithm has been designed to remove the Non Line-Of-Sight (NLOS) UWB ranging estimates to further improve the accuracy of the proposed solution. This solution has been tested using both a simulated environment and a real environment. This research work is in the scope of the PRoPART European Project. The different real tests have been performed on the AstaZero proving ground using a Radio Control car (RC car) developed by RISE (Research Institutes of Sweden) as testing platform. Thus, a real time positioning solution has been achieved complying with the accuracy requirements for the PRoPART use case

Theoretical Limits on Cooperative Positioning in Mixed Traffic

A promising solution to meet the demands on accurate positioning and real-time situational awareness in future intelligent transportation systems (ITSs) is cooperative positioning, where vehicles share sensor information over the wireless channel. However, the sensing and communication technologies required for this will be gradually introduced into the market, and it is, therefore, important to understand what performance we can expect from cooperative positioning systems as we transition to a more modern vehicle fleet. In this paper, we study what effects a gradual market penetration has on cooperative positioning applications, through a Fisher information analysis. The simulation results indicate that solely introducing a small fraction of automated vehicles with high-end sensors significantly improves the positioning quality but is not enough to meet the stringent demands posed by safety critical ITS applications. Furthermore, we find that retrofitting vehicles with low-cost satellite navigation receivers and communication have marginal impact when the positioning requirements are stringent and that the longitudinal road position can be estimated more accurately than lateral

Ultra Wideband Assisted Localization of Semi-Autonomous Floor Scrubber

The paper describes the design and features of the novel semi-autonomous floor scrubber add-on module, used for cleaning large indoor spaces. Module is designed in such a manner that it can be easily attached and detached from scrubber machine and that additional sensors can be introduced if needed. The paper focuses on the localization capabilities of the machine in several sensor setups with emphasis on the use of ultra wideband (UWB) real-time localization system (RTLS). It also proposes fusion of sensor data from several sources including novel use of wheel encoder’s data in UWB setup. Analysis is performed in terms of localization accuracy and reliability as well as associated advantages and disadvantages. Obtained results demonstrated that inclusion of UWB subsystem, despite its price and accuracy (20 cm in ideal, line of sight, conditions), based on behavior switching yields more reliable and accurate results in open spaces (up to 25 times in position and 2 times in orientation) and that its accuracy can be further improved with inclusion of wheel encoder data

Investigating multi-GNSS performance in the UK and China based on a zero-baseline measurement approach

GPS is the positioning tool of choice for a wide variety of applications where accurate (cm level or less) positions are required. However GPS is susceptible to a variety of errors that degrade both the quality of the position solution and the availability of these solutions. The contribution of additional observations from other GNSS systems may improve the quality of the positioning solution. This study investigates the contribution of the GLONASS and BeiDou systems and the potential improvement to the precision achieved compared to positioning using GPS only measurements. Furthermore, it is investigated whether the combination of the satellite systems can limit the noise level of the GPS-only solution. A series of zero-baseline measurements, of 1 Hz sampling rate, were recorded with different types of pairs of receivers over 12 consecutive days in the UK and in China simultaneously. The novel part in this study is comparing the simultaneous GNSS real measurements recorded in the UK and China. Moreover, the correlation between the geometry and positional precision was investigated. The results indicate an improvement in a multi-GNSS combined solution compared to the GPS-only solution, especially when the GPS-only solution derives from weak satellite geometry, or the GPS-only solution is not available. Furthermore, all the outliers due to poor satellite coverage with the individual solutions are limited and their precision is improved, agreeing also with the improvement in the mean of the GDOP, i.e. the mean GDOP was improved from 3.0 for the GPS only solution to 1.8 for the combined solution. However, the combined positioning did not show significant positional improvement when GPS has a good geometry and availability

Automotive applications of high precision GNSS

This thesis aims to show that Global Navigation Satellite Systems (GNSS) positioning can play a significant role in the positioning systems of future automotive applications. This is through the adoption of state-of-the-art GNSS positioning technology and techniques, and the exploitation of the rapidly developing vehicle-to-vehicle concept. The merging together of these two developments creates greater performance than can be achieved separately. The original contribution of this thesis comes from this combination: Through the introduction of the Pseudo-VRS concept. Pseudo-VRS uses the princples of Network Real Time Kinematic (N-RTK) positioning to share GNSS information between vehicles, which enables absolute vehicle positioning. Pseudo-VRS is shown to improve the performance of high precision GNSS positioning for road vehicles, through the increased availability of GNSS correction messages and the rapid resolution of the N-RTK fixed solution. Positioning systems in the automotive sector are dominated by satellite-based solutions provided by GNSS. This has been the case since May 2001, when the United States Department of Defense switched off Selective Availability, enabling significantly improved positioning performance for civilian users. The average person most frequently encounters GNSS when using electronic personal navigation devices. The Sat Nav or GPS Navigator is ubiquitous in modern societies, where versions can be found on nomadic devices such as smartphones and dedicated personal navigation devices, or built in to the dashboards of vehicles. Such devices have been hugely successful due to their intrinsic ability to provide position information anywhere in the world with an accuracy of approximately 10 metres, which has proved ideal for general navigation applications. There are a few well known limitations of GNSS positioning, including anecdotal evidence of incorrect navigation advice for personal navigation devices, but these are minor compared to the overall positioning performance. Through steady development of GNSS positioning devices, including the integration of other low cost sensors (for instance, wheel speed or odometer sensors in vehicles), and the development of robust map matching algorithms, the performance of these devices for navigation applications is truly incredible. However, when tested for advanced automotive applications, the performance of GNSS positioning devices is found to be inadequate. In particular, in the most advanced fields of research such as autonomous vehicle technology, GNSS positioning devices are relegated to a secondary role, or often not used at all. They are replaced by terrestrial sensors that provide greater situational awareness, such as radar and lidar. This is due to the high performance demand of such applications, including high positioning accuracy (sub-decimetre), high availability and continuity of solutions (100%), and high integrity of the position information. Low-cost GNSS receivers generally do not meet such requirements. This could be considered an enormous oversight, as modern GNSS positioning technology and techniques have significantly improved satellite-based positioning performance. Other non-GNSS techniques also have their limitations that GNSS devices can minimise or eliminate. For instance, systems that rely on situational awareness require accurate digital maps of their surroundings as a reference. GNSS positioning can help to gather this data, provide an input, and act as a fail-safe in the event of digital map errors. It is apparent that in order to deliver advanced automotive applications - such as semi- or fully-autonomous vehicles - there must be an element of absolute positioning capability. Positioning systems will work alongside situational awareness systems to enable the autonomous vehicles to navigate through the real world. A strong candidate for the positioning system is GNSS positioning. This thesis builds on work already started by researchers at the University of Nottingham, to show that N-RTK positioning is one such technique. N-RTK can provide sub-decimetre accuracy absolute positioning solutions, with high availability, continuity, and integrity. A key component of N-RTK is the availability of real-time GNSS correction data. This is typically delivered to the GNSS receiver via mobile internet (for a roving receiver). This can be a significant limitation, as it relies on the performance of the mobile communications network, which can suffer from performance degradation during dynamic operation. Mobile communications systems are expected to improve significantly over the next few years, as consumers demand faster download speeds and wider availability. Mobile communications coverage already covers a high percentage of the population, but this does not translate into a high percentage of a country's geography. Pockets of poor coverage, often referred to as notspots, are widespread. Many of these notspots include the transportation infrastructure. The vehicle-to-vehicle concept has made significant forward steps in the last few years. Traditionally promoted as a key component of future automotive safety applications, it is now driven primarily by increased demand for in-vehicle infotainment. The concept, which shares similarities with the Internet of Things and Mobile Ad-hoc Networks, relies on communication between road vehicles and other road agents (such as pedestrians and road infrastructure). N-RTK positioning can take advantage of this communication link to minimise its own communications-related limitations. Sharing GNSS information between local GNSS receivers enables better performance of GNSS positioning, based on the principles of differential GNSS and N-RTK positioning techniques. This advanced concept is introduced and tested in this thesis. The Pseudo VRS concept follows the protocols and format of sharing GNSS data used in N-RTK positioning. The technique utilises the latest GNSS receiver design, including multiple frequency measurements and high quality antennas