A flexible sensor technology for the distributed measurement of interaction pressure

We present a sensor technology for the measure of the physical human-robot interaction pressure developed in the last years at Scuola Superiore Sant'Anna. The system is composed of flexible matrices of opto-electronic sensors covered by a soft silicone cover. This sensory system is completely modular and scalable, allowing one to cover areas of any sizes and shapes, and to measure different pressure ranges. In this work we present the main application areas for this technology. A first generation of the system was used to monitor human-robot interaction in upper- (NEUROExos; Scuola Superiore Sant'Anna) and lower-limb (LOPES; University of Twente) exoskeletons for rehabilitation. A second generation, with increased resolution and wireless connection, was used to develop a pressure-sensitive foot insole and an improved human-robot interaction measurement systems. The experimental characterization of the latter system along with its validation on three healthy subjects is presented here for the first time. A perspective on future uses and development of the technology is finally drafted

An impairment-specific hip exoskeleton assistance for gait training in subjects with acquired brain injury: a feasibility study

This study was designed to investigate the feasibility and the potential effects on walking performance of a short gait training with a novel impairment-specific hip assistance (iHA) through a bilateral active pelvis orthosis (APO) in patients with acquired brain injury (ABI). Fourteen subjects capable of independent gait and exhibiting mild-to-moderate gait deficits, due to an ABI, were enrolled. Subjects presenting deficit in hip flexion and/or extension were included and divided into two groups based on the presence (group A, n = 6) or absence (group B, n = 8) of knee hyperextension during stance phase of walking. Two iHA-based profiles were developed for the groups. The protocol included two overground gait training sessions using APO, and two evaluation sessions, pre and post training. Primary outcomes were pre vs. post-training walking distance and steady-state speed in the 6-min walking test. Secondary outcomes were self-selected speed, joint kinematics and kinetics, gait symmetry and forward propulsion, assessed through 3D gait analysis. Following the training, study participants significantly increased the walked distance and average steady-state speed in the 6-min walking tests, both when walking with and without the APO. The increased walked distance surpassed the minimal clinically important difference for groups A and B, (respectively, 42 and 57 m > 34 m). In group A, five out of six subjects had decreased knee hyperextension at the post-training session (on average the peak of the knee extension angle was reduced by 36%). Knee flexion during swing phase increased, by 16% and 31%, for A and B groups respectively. Two-day gait training with APO providing iHA was effective and safe in improving walking performance and knee kinematics in ABI survivors. These preliminary findings suggest that this strategy may be viable for subject-specific post-ABI gait rehabilitation

A Novel Design of a Cable-driven Active Leg Exoskeleton (C-ALEX) and Gait Training with Human Subjects

Exoskeletons for gait training commonly use a rigid-linked "skeleton" which makes them heavy and bulky. Cable-driven exoskeletons eliminate the rigid-linked skeleton structure, therefore creating a lighter and more transparent design. Current cable-driven leg exoskeletons are limited to gait assistance use. This thesis presented the Cable-driven Active Leg Exoskeleton (C-ALEX) designed for gait retraining and rehabilitation. Benefited from the cable-driven design, C-ALEX has minimal weight and inertia (4.7 kg) and allows all the degrees-of-freedom (DoF) of the leg of the user. C-ALEX uses an assist-as-needed (AAN) controller to train the user to walk in a new gait pattern. A preliminary design of C-ALEX was first presented, and an experiment was done with this preliminary design to study the effectiveness of the AAN controller. The result on six healthy subjects showed that the subjects were able to follow a new gait pattern significantly more accurately with the help of the AAN controller. After this experiment, C-ALEX was redesigned to improve its functionality. The improved design of C-ALEX is lighter, has more DoFs and larger range-of-motion. The controller of the improved design improved the continuity of the generated cable tensions and added the function to estimate the phase of the gait of the user in real-time. With the improved design of C-ALEX, an experiment was performed to study the effect of the weight and inertia of an exoskeleton on the gait of the user. C-ALEX was used to simulate exoskeletons with different levels of weight and inertia by adding extra mass and change the weight compensation level. The result on ten subjects showed that adding extra mass increased step length and reduced knee flexion. Compensating the weight of the mass partially restored the knee flexion but not the step length, implying that the inertia of the mass is responsible for the change. This study showed the distinctive effect of weight and inertia on gait and demonstrated the benefit of a lightweight exoskeleton. C-ALEX was designed for gait training and rehabilitation, and its training effectiveness was studied in nine healthy subjects and a stroke patient. The healthy subjects trained with C-ALEX to walk in a new gait pattern with 30% increase in step height for 40 min. After the training, the subjects were able to closely repeat the trained gait pattern without C-ALEX, and the step height of the subjects increased significantly. A stroke patient also tested C-ALEX for 40 minutes and showed short-term improvements in step length, step height, and knee flexion after training. The result showed the effectiveness of C-ALEX in gait training and its potential to be used in stroke rehabilitation

Evaluation Of Impedance Control On A Powered Hip Exoskeleton

This thesis presents an impedance control strategy for a novel powered hip exoskeleton designed to provide partial assistance and leverage the dynamics of human gait. The control strategy is based on impedance control and provides the user assistance as needed which is determined by the user’s interaction with the exoskeleton. A series elastic element is used to drive the exoskeleton and measures the interaction torque between the user and the device. The device operates in two modes. Free mode is a low impedance state that attempts to provide no assistance. Assist mode increases the gains of the controller to provide assistance as needed. The device was tested on five healthy subjects, and the resulting assistive hip torque was evaluated to determine the ability of the controller to provide gait assistance. The device was evaluated at different speeds to assess the gait speed adaptation performance of the controller. Results show that hip torque assistance range was between 0.3 to 0.5 Nm/kg across the subjects, corresponding to 24% to 40% of the maximum hip torque requirements of healthy adults during walking. The peak power provided by the system is 35 W on average and a peak power of up to 45 W

Lower-limb amputees can reduce the energy cost of walking when assisted by an Active Pelvis Orthosis

Exoskeletons could compete with active prostheses as effective aids to reduce the increased metabolic demands faced by lower-limb amputees during locomotion. However, little evidence of their efficacy with amputees has been provided so far. In this paper, a portable hip exoskeleton has been tested with seven healthy subjects and two transfemoral amputees, with the final goal to verify whether a hip flexion-extension assistance could be effective in reducing the metabolic cost of walking. The metabolic power of the participants was estimated through indirect calorimetry during alternated repetitions of three treadmill-based walking conditions: without the exoskeleton (NoExo), with the exoskeleton in zero-torque mode (ExoTM) and with the exoskeleton providing hip flexion-extension assistance (ExoAM). The results showed that the exoskeleton reduced the net metabolic power of the two amputees in ExoAM with respect to NoExo, by 5.0% and 3.4%. With healthy subjects, a 5.5±3.1% average reduction in the metabolic power was observed during ExoAM compared to ExoTM (differences were not statistically significant), whereas ExoAM required 3.9±3.0% higher metabolic power than NoExo (differences were not statistically significant). These results provide initial evidence of the potential of exoskeletal technologies for assisting lower-limb amputees, thereby paving the way for further experimentations

Comparing walking with knee-ankle-foot orthoses and a knee-powered exoskeleton after spinal cord injury: a randomized, crossover clinical trial

Recovering the ability to stand and walk independently can have numerous health benefits for people with spinal cord injury (SCI). Wearable exoskeletons are being considered as a promising alternative to conventional knee-ankle-foot orthoses (KAFOs) for gait training and assisting functional mobility. However, comparisons between these two types of devices in terms of gait biomechanics and energetics have been limited. Through a randomized, crossover clinical trial, this study compared the use of a knee-powered lower limb exoskeleton (the ABLE Exoskeleton) against passive orthoses, which are the current standard of care for verticalization and gait ambulation outside the clinical setting in people with SCI. Ten patients with SCI completed a 10-session gait training program with each device followed by user satisfaction questionnaires. Walking with the ABLE Exoskeleton improved gait kinematics compared to the KAFOs, providing a more physiological gait pattern with less compensatory movements (38% reduction of circumduction, 25% increase of step length, 29% improvement in weight shifting). However, participants did not exhibit significantly better results in walking performance for the standard clinical tests (Timed Up and Go, 10-m Walk Test, and 6-min Walk Test), nor significant reductions in energy consumption. These results suggest that providing powered assistance only on the knee joints is not enough to significantly reduce the energy consumption required by people with SCI to walk compared to passive orthoses. Active assistance on the hip or ankle joints seems necessary to achieve this outcome.Peer ReviewedPostprint (published version

Design, control, and pilot study of a lightweight and modular robotic exoskeleton for walking assistance after spinal cord injury

Walking rehabilitation using exoskeletons is of high importance to maximize independence and improve the general well-being of spinal cord injured subjects. We present the design and control of a lightweight and modular robotic exoskeleton to assist walking in spinal cord injured subjects who can control hip flexion, but lack control of knee and ankle muscles. The developed prototype consists of two robotic orthoses, which are powered by a motor-harmonic drive actuation system that controls knee flexion–extension. This actuation module is assembled on standard passive orthoses. Regarding the control, the stance-to-swing transition is detected using two inertial measurement units mounted on the tibial supports, and then the corresponding motor performs a predefined flexion–extension cycle that is personalized to the specific patient’s motor function. The system is portable by means of a backpack that contains an embedded computer board, the motor drivers, and the battery. A preliminary biomechanical evaluation of the gait-assistive device used by a female patient with incomplete spinal cord injury at T11 is presented. Results show an increase of gait speed (+24.11%), stride length (+7.41%), and cadence (+15.56%) when wearing the robotic orthoses compared with the case with passive orthoses. Conversely, a decrease of lateral displacement of the center of mass (-19.31%) and step width (-13.37% right step, -8.81% left step) are also observed, indicating gain of balance. The biomechanical assessment also reports an overall increase of gait symmetry when wearing the developed assistive device.Peer ReviewedPostprint (published version

Immediate Adaptations to Post-Stroke Walking Performance Using a Wearable Robotic Exoskeleton

Objective To examine the immediate effects of a hip-assistive wearable robotic exoskeleton on clinical walking performance, walking energetics, gait kinematics, and corticomotor excitability in individuals with stroke. Design Randomized cross-over trial. Setting Research laboratory of a rehabilitation hospital. Participants Twelve individuals (4F/8M, mean age 57.8±7.2) with chronic hemiparetic stroke. Interventions Honda’s Stride Management Assist (SMA) exoskeleton, which provides torque-based flexion and extension assistance at the hip joints during walking. Main Outcome Measures The primary outcome measure was change in self-selected walking speed with the device off vs. with the device on. Secondary outcome measures included changes in clinical endurance, energy expenditure, kinematics, and corticomotor excitability of lower limb muscles. Results In a single session using the device, participants exhibited adaptations over most outcome measures. Self-selected walking speed and peak treadmill speed increased, while oxygen consumption rate decreased during overground and treadmill endurance tests. More symmetric walking patterns were observed during treadmill walking. Changes in corticomotor excitability were highly variable among participants, with a non-significant increase in excitability for the paretic rectus femoris. Conclusions The SMA hip exoskeleton causes immediate positive adaptations in walking performance in individuals with stroke when the device is in use

Adapted assistance and resistance training with a knee exoskeleton after stroke

Studies on robotic interventions for gait rehabilitation after stroke require: (i) rigorous performance evidence; (ii) systematic procedures to tune the control parameters; and (iii) combination of control modes. In this study, we investigated how stroke individuals responded to training for two weeks with a knee exoskeleton (ABLE-KS) using both Assistance and Resistance training modes together with auditory feedback to train peak knee flexion angle. During the training, the torque provided by the ABLE-KS and the biofeedback were systematically adapted based on the subject’s performance and perceived exertion level. We carried out a comprehensive experimental analysis that evaluated a wide range of biomechanical metrics, together with usability and users’ perception metrics. We found significant improvements in peak knee flexion ( p=0.0016 ), minimum knee angle during stance ( p=0.0053 ), paretic single support time ( p=0.0087 ) and gait endurance ( p=0.022 ) when walking without the exoskeleton after the two weeks of training. Participants significantly ( p<0.00025 ) improved the knee angle during the stance and swing phases when walking with the exoskeleton powered in the high Assistance mode in comparison to the No Exo and the Unpowered conditions. No clinically relevant differences were found between Assistance and Resistance training sessions. Participants improved their performance with the exoskeleton (24-55 %) for the peak knee flexion angle throughout the training sessions. Moreover, participants showed a high level of acceptability of the ABLE-KS (QUEST 2.0 score: 4.5 ± 0.3 out of 5). Our preliminary findings suggest that the proposed training approach can produce similar or larger improvements in post-stroke individuals than other studies with knee exoskeletons that used higher training intensities.This work was supported in part by the Agency for Management of University and Research Grants (AGAUR) along with the Secretariat of Universities and Research of the Catalan Ministry of Research and Universities and the European Social Fund (ESF) under Grant 2020 FI_B 00331, in part by the Spanish Ministry of Science and Innovation (MCI)—Agencia Estatal de Investigación (AEI) under Grant PTQ2018-010227, in part by “La Caixa” Foundation under Grant LCF/TR/CC20/52480002, and in part by the Eurostars-3 Joint Program with co-financing from CDTI and the European Union’s Horizon Europe Research and Innovation Framework Program under Eureka Application Number 1789 under Grant CIIP-20221022Peer ReviewedPostprint (published version