Dynamic Virtual Network Restoration with Optimal Standby Virtual Router Selection

Title form PDF of title page, viewed on September 4, 2015Dissertation advisor: Deep MedhiVitaIncludes bibliographic references (pages 141-157)Thesis (Ph.D.)--School of Computing and Engineering and Department of Mathematics and Statistics. University of Missouri--Kansas City, 2015Network virtualization technologies allow service providers to request partitioned, QoS guaranteed and fault-tolerant virtual networks provisioned by the substrate network provider (i.e., physical infrastructure provider). A virtualized networking environment (VNE) has common features such as partition, flexibility, etc., but fault-tolerance requires additional efforts to provide survivability against failures on either virtual networks or the substrate network. Two common survivability paradigms are protection (proactive) and restoration (reactive). In the protection scheme, the substrate network provider (SNP) allocates redundant resources (e.g., nodes, paths, bandwidths, etc) to protect against potential failures in the VNE. In the restoration scheme, the SNP dynamically allocates resources to restore the networks, and it usually occurs after the failure is detected. In this dissertation, we design a restoration scheme that can be dynamically implemented in a centralized manner by an SNP to achieve survivability against node failures in the VNE. The proposed restoration scheme is designed to be integrated with a protection scheme, where the SNP allocates spare virtual routers (VRs) as standbys for the virtual networks (VN) and they are ready to serve in the restoration scheme after a node failure has been identified. These standby virtual routers (S-VR) are reserved as a sharedbackup for any single node failure, and during the restoration procedure, one of the S-VR will be selected to replace the failed VR. In this work, we present an optimal S-VR selection approach to simultaneously restore multiple VNs affected by failed VRs, where these VRs may be affected by failures within themselves or at their substrate host (i.e., power outage, hardware failures, maintenance, etc.). Furthermore, the restoration scheme is embedded into a dynamic reconfiguration scheme (DRS), so that the affected VNs can be dynamically restored by a centralized virtual network manager (VNM). We first introduce a dynamic reconfiguration scheme (DRS) against node failures in a VNE, and then present an experimental study by implementing this DRS over a realistic VNE using GpENI testbed. For this experimental study, we ran the DRS to restore one VN with a single-VR failure, and the results showed that with a proper S-VR selection, the performance of the affected VN could be well restored. Next, we proposed an Mixed-Integer Linear Programming (MILP) model with dual–goals to optimally select S-VRs to restore all VNs affected by VR failures while load balancing. We also present a heuristic algorithm based on the model. By considering a number of factors, we present numerical studies to show how the optimal selection is affected. The results show that the proposed heuristic’s performance is close to the optimization model when there were sufficient standby virtual routers for each virtual network and the substrate nodes have the capability to support multiple standby virtual routers to be in service simultaneously. Finally, we present the design of a software-defined resilient VNE with the optimal S-VR selection model, and discuss a prototype implementation on the GENI testbed.Introduction -- Literature survey -- Dynamic reconfiguration scheme in a VNE -- An experimental study on GpENI-VNI -- Optimal standby virtual router selection model -- Prototype design and implementation on GENI -- Conclusion and future work -- Appendix A. Resource Specification (RSpec) in GENI -- Appendix B. Optimal S-VR Selection Model in AMP

Intelligent Network Infrastructures: New Functional Perspectives on Leveraging Future Internet Services

The Internet experience of the 21st century is by far very different from that of the early '80s. The Internet has adapted itself to become what it really is today, a very successful business platform of global scale. As every highly successful technology, the Internet has suffered from a natural process of ossification. Over the last 30 years, the technical solutions adopted to leverage emerging applications can be divided in two categories. First, the addition of new functionalities either patching existing protocols or adding new upper layers. Second, accommodating traffic grow with higher bandwidth links. Unfortunately, this approach is not suitable to provide the proper ground for a wide gamma of new applications. To be deployed, these future Internet applications require from the network layer advanced capabilities that the TCP/IP stack and its derived protocols can not provide by design in a robust, scalable fashion. NGNs (Next Generation Networks) on top of intelligent telecommunication infrastructures are being envisioned to support future Internet Services. This thesis contributes with three proposals to achieve this ambitious goal. The first proposal presents a preliminary architecture to allow NGNs to seamlessly request advanced services from layer 1 transport networks, such as QoS guaranteed point-to-multipoint circuits. This architecture is based on virtualization techniques applied to layer 1 networks, and hides from NGNs all complexities of interdomain provisioning. Moreover, the economic aspects involved were also considered, making the architecture attractive to carriers. The second contribution regards a framework to develop DiffServ-MPLS capable networks based exclusively on open source software and commodity PCs. The developed DiffServ-MPLS flexible software router was designed to allow NGN prototyping, that make use of pseudo virtual circuits and assured QoS as a starting point of development. The third proposal presents a state of the art routing and wavelength assignment algorithm for photonic networks. This algorithm considers physical layer impairments to 100% guarantee the requested QoS profile, even in case of single network failures. A number of novel techniques were applied to offer lower blocking probability when compared with recent proposed algorithms, without impacting on setup delay time

Crosslayer Survivability in Overlay-IP-WDM Networks

As the Internet moves towards a three-layer architecture consisting of overlay networks on top of the IP network layer on top of WDM-based physical networks, incorporating the interaction between and among network layers is crucial for efficient and effective implementation of survivability.This dissertation has four major foci as follows: First, a first-of-its-kind analysis of the impact of overlay network dependency on the lower layer network unveils that backhaul, a link loop that occurs at any two or more lower layers below the layer where traffic is present, could happen. This prompts our proposal of a crosslayer survivable mapping to highlight such challenges and to offer survivability in an efficient backhaul-free way. The results demonstrate that the impact of layer dependency is more severe than initially anticipated making it clear that independent single layer network design is inadequate to assure service guarantees and efficient capacity allocation. Second, a forbidden link matrix is proposed masking part of the network for use in situations where some physical links are reserved exclusively for a designated service, mainly for the context of providing multiple levels of differentiation on the network use and service guarantee. The masking effect is evaluated on metrics using practical approaches in a sample real-world network, showing that both efficiency and practicality can be achieved. Third, matrix-based optimization problem formulations of several crosslayer survivable mappings are presented; examples on the link availability mapping are particularly illustrated. Fourth, survivability strategies for two-layer backbone networks where traffic originates at each layer are investigated. Optimization-based formulations of performing recovery mechanisms at each layer for both layers of traffic are also presented. Numerical results indicate that, in such a wavelength-based optical network, implementing survivability of all traffic at the bottom layer can be a viable solution with significant advantages.This dissertation concludes by identifying a roadmap of potential future work for crosslayer survivability in layered network settings

Resilient virtual topologies in optical networks and clouds

Optical networks play a crucial role in the development of Internet by providing a high speed infrastructure to cope with the rapid expansion of high bandwidth demand applications such as video, HDTV, teleconferencing, cloud computing, and so on. Network virtualization has been proposed as a key enabler for the next generation networks and the future Internet because it allows diversification the underlying architecture of Internet and lets multiple heterogeneous network architectures coexist. Physical network failures often come from natural disasters or human errors, and thus cannot be fully avoided. Today, with the increase of network traffic and the popularity of virtualization and cloud computing, due to the sharing nature of network virtualization, one single failure in the underlying physical network can affect thousands of customers and cost millions of dollars in revenue. Providing resilience for virtual network topology over optical network infrastructure thus becomes of prime importance. This thesis focuses on resilient virtual topologies in optical networks and cloud computing. We aim at finding more scalable models to solve the problem of designing survivable logical topologies for more realistic and meaningful network instances while meeting the requirements on bandwidth, security, as well as other quality of service such as recovery time. To address the scalability issue, we present a model based on a column generation decomposition. We apply the cutset theorem with a decomposition framework and lazy constraints. We are able to solve for much larger network instances than the ones in literature. We extend the model to address the survivability problem in the context of optical networks where the characteristics of optical networks such as lightpaths and wavelength continuity and traffic grooming are taken into account. We analyze and compare the bandwidth requirement between the two main approaches in providing resiliency for logical topologies. In the first approach, called optical protection, the resilient mechanism is provided by the optical layer. In the second one, called logical restoration, the resilient mechanism is done at the virtual layer. Next, we extend the survivability problem into the context of cloud computing where the major complexity arises from the anycast principle. We are able to solve the problem for much larger network instances than in the previous studies. Moreover, our model is more comprehensive that takes into account other QoS criteria, such that recovery time and delay requirement

Network Slicing

Network slicing is emerging as a key enabling technology to support new service needs, business cases, and the evolution of programmable networking. As an end-to-end concept involving network functions in different domains and administrations, network slicing calls for new standardization efforts, design methodologies, and deployment strategies. This chapter aims at addressing the main aspects of network slicing with relevant challenges and practical solutions