An integrated scheme to improve performance of fast mobile IPv6 handover in IEEE 802.16e network

IEEE 802.16e standard for mobile Worldwide Interoperability for Microwave Access (WiMAX), defines the implementation of hard handover. The standard covers the physical and MAC layer. To apply the layer 3 (L3) handover protocol over the existing IEEE 802.16e layer 2 (L2) handover scheme, the fast mobile IPv6 was used by many researches, but long latency is main challenge for real-time applications. In this paper, to solve latency problem, an integrated scheme is proposed that it combines cross layer design and cross function optimization. The integrated scheme, bases on a pre-establish tunnels concept is dealt both, L2 handover in 802.16e and L3 handover in fast mobile IPv6 to effectively blend the relative messages of L2 and L3. The proposed scheme is compare with the scheme what standardized in IETF network working group (RFC5270). Analytic results prove that the proposed scheme can reduce not only handover latency but also packet losses

Motorized cart

Motorized cart is known as an effective tool and timeless that help people carry heavy loads. For farmers, it has an especially vital tool for moving goods. Oil palm farmers typically uses the wheelbarrow to move the oil palm fruit (Figure 10.1). However, there is a lack of equipment that should be further enhanced in capabilities. Motorized carts that seek to add automation to wheelbarrow as it is to help people save manpower while using it. At present, oil palm plantation industry is among the largest in Malaysia. However, in an effort to increase the prestige of the industry to a higher level there are challenges to be faced. Shortage of workers willing to work the farm for harvesting oil palm has given pain to manage oil palm plantations. Many have complained about the difficulty of hiring foreign workers and a high cost. Although there are tools that can be used to collect or transfer the proceeds of oil palm fruits such as carts available. However, these tools still have the disadvantage that requires high manpower to operate. Moreover, it is not suitable for all land surfaces and limited cargo space. Workload and manpower dependence has an impact on farmers' income

Handover management in mobile WiMAX using adaptive cross-layer technique

The protocol type and the base station (BS) technology are the main communication media between the Vehicle to Infrastructure (V2I) communication in vehicular networks. During high speed vehicle movement, the best communication would be with a seamless handover (HO) delay in terms of lower packet loss and throughput. Many studies have focused on how to reduce the HO delay during lower speeds of the vehicle with data link (L2) and network (L3) layers protocol. However, this research studied the Transport Layer (L4) protocol mobile Stream Control Transmission Protocol (mSCTP) used as an optimal protocol in collaboration with the Location Manager (LM) and Domain Name Server (DNS). In addition, the BS technology that performs smooth HO employing an adaptive algorithm in L2 to perform the HO according to current vehicle speed was also included in the research. The methods derived from the combination of L4 and the BS technology methods produced an Adaptive Cross-Layer (ACL) design which is a mobility oriented handover management scheme that adapts the HO procedure among the protocol layers. The optimization has a better performance during HO as it is reduces scanning delay and diversity level as well as support transparent mobility among layers in terms of low packet loss and higher throughput. All of these metrics are capable of offering maximum flexibility and efficiency while allowing applications to refine the behaviour of the HO procedure. Besides that, evaluations were performed in various scenarios including different vehicle speeds and background traffic. The performance evaluation of the proposed ACL had approximately 30% improvement making it better than the other handover solutions

Handover in Mobile WiMAX Networks: The State of Art and Research Issues

The next-generation Wireless Metropolitan Area Networks, using the Worldwide Interoperability for Microwave Access (WiMAX) as the core technology based on the IEEE 802.16 family of standards, is evolving as a Fourth-Generation (4G) technology. With the recent introduction of mobility management frameworks in the IEEE 802.16e standard, WiMAX is now placed in competition to the existing and forthcoming generations of wireless technologies for providing ubiquitous computing solutions. However, the success of a good mobility framework largely depends on the capability of performing fast and seamless handovers irrespective of the deployed architectural scenario. Now that the IEEE has defined the Mobile WiMAX (IEEE 802.16e) MAC-layer handover management framework, the Network Working Group (NWG) of the WiMAX Forum is working on the development of the upper layers. However, the path to commercialization of a full-fledged WiMAX mobility framework is full of research challenges. This article focuses on potential handover-related research issues in the existing and future WiMAX mobility framework. A survey of these issues in the MAC, Network and Cross-Layer scenarios is presented along with discussion of the different solutions to those challenges. A comparative study of the proposed solutions, coupled with some insights to the relevant issues, is also included

Performance study of FMIPv6-based cross-layer WiMAX handover scheme for supporting VoIP service

This report presents performance study of the FMIPv6-based cross-layer handover scheme for VoIP supports over mobile WiMAX network. For this performance validation and evaluation, the handover delays for four different handover mechanisms are formulated and ns2 based simulation module has been developed. The handover delay, the total delay, and the R factor representing VoIP quality are measured to evaluate the VoIP support characteristics of the FMIPv6-based cross-layer scheme. Simulation results verified that the proposed FMIPv6-based cross-layer handover scheme, compared to the non-cross-layer scheme, successfully reduces total handover delay by almost 50% for the case of layer-3 handover. Further, simulation was also evaluated in terms of R factor indicating voice quality level, of which 70 is a minimum value of a traditional PSTN call to be considered as the lower limit of a VoIP call quality [6]. Through the simulation in this study, the result revealed that the proposed scheme effectively improves VoIP call quality from unacceptable quality to acceptable quality (R factor of 75). Based on these simulation results, it was found that the proposed FMIPv6-based cross-layer handover scheme is an adequate protocol for supporting VoIP services in mobile WiMAX environment

Design of interface selection protocols for multi-homed wireless networks

This thesis was submitted for the degree of Doctor of Philosophy and was awarded by Brunel University on 10 December 2010.The IEEE 802.11/802.16 standards conformant wireless communication stations have multi-homing transmission capability. To achieve greater communication efficiency, multi-homing capable stations use handover mechanism to select appropriate transmission channel according to variations in the channel quality. This thesis presents three internal-linked handover schemes, (1) Interface Selection Protocol (ISP), belonging to Wireless Local Area Network (WLAN)- Worldwide Interoperability for Microwave Access (WiMAX) environment (2) Fast Channel Scanning (FCS) and (3) Traffic Manager (TM), (2) and (3) belonging to WiMAX Environment. The proposed schemes in this thesis use a novel mechanism of providing a reliable communication route. This solution is based on a cross-layer communication framework, where the interface selection module uses various network related parameters from Medium Access Control (MAC) sub-layer/Physical Layer (PHY) across the protocol suite for decision making at the Network layer. The proposed solutions are highly responsive when compared with existing multi-homed schemes; responsiveness is one of the key factors in the design of such protocols. Selected route under these schemes is based on the most up to date link-layer information. Therefore, such a route is not only reliable in terms of route optimization but it also fulfils the application demands in terms of throughput and delay. Design of ISP protocol use probing frames during the route discovery process. The 802.11 mandates the use of different rates for data transmission frames. The ISP-metric can be incorporated into various routing aspects and its applicability is determined by the possibility of provision of MAC dependent parameters that are used to determine the best path metric values. In many cases, higher device density, interference and mobility cause variable medium access delays. It causes creation of ‘unreachable zones’, where destination is marked as unreachable. However, by use of the best path metric, the destination has been made reachable, anytime and anywhere, because of the intelligent use of the probing frames and interface selection algorithm implemented. The IEEE 802.16e introduces several MAC level queues for different access categories, maintaining service requirement within these queues; which imply that frames from a higher priority queue, i.e. video frames, are serviced more frequently than those belonging to lower priority queues. Such an enhancement at the MAC sub-layer introduces uneven queuing delays. Conventional routing protocols are unaware of such MAC specific constraints and as a result, these factors are not considered which result in channel performance degradation. To meet such challenges, the thesis presents FCS and TM schemes for WiMAX. For FCS, Its solution is to improve the mobile WiMAX handover and address the scanning latency. Since minimum scanning time is the most important issue in the handover process. This handover scheme aims to utilize the channel efficiently and apply such a procedure to reduce the time it takes to scan the neighboring access stations. TM uses MAC and physical layer (PHY) specific information in the interface metric and maintains a separate path to destination by applying an alternative interface operation. Simulation tests and comparisons with existing multi-homed protocols and handover schemes demonstrate the effectiveness of incorporating the medium dependent parameters. Moreover, show that suggested schemes, have shown better performance in terms of end-to-end delay and throughput, with efficiency up to 40% in specific test scenarios

Handover in Mobile Wireless Communication Network - A Review

Mobility is the characteristics of mobile communication that makes it irresistible by all and sundry. The whole world is now engaging in wireless communication as it provides users\u27 ability to communicate on-the-go. This is achieved by transferring users from a radio network to another. This process is called handover. Handover occurs either by cell crossing or by deterioration in signal quality of the current channel. The continuation of an active call is a critical characteristic in cellular systems. Brief overview of handover, handover type, commonly used handover parameters, some methods employed in the literature and we present the convergent point for furtherance in the area of mobile wireless communication Handover