32 research outputs found
All-analogue real-time filter bank OFDM over 50 Km of SSMF using a novel synchronization technique
A 21.6 Gbit/s 1.78 bit/s/Hz OFDM signal is transmitted over 50 Km of fiber without using DSP in the transmitter or the receiver. The synchronization scheme only requires one PLL to synchronize all the subcarriers
Impact of band rejection in multichannel broadband subcarrier multiplexing
This paper explores experimentally the impairments in performance that are generated when multiple single-sideband (SSB) subcarrier multiplexing (SCM) signals are closely allocated in frequency to establish a spectrally efficient wavelength division multiplexing (WDM) link. The performance of cost-effective SSB WDM/ SCM implementations, without optical filters in the transmitter, presents a strong dependency on the imperfect sideband suppression ratio that can be directly achieved with the electro-optical modulator. A direct detected broadband multichannel SCM link composed of a state-of-the-art optical IQ modulator and five quadrature phase-shift keyed (QPSK) subcarriers per optical channel is presented, showing that a suppression ratio of 20 dB obtained directly with the modulator produced a penalty of 2 dB in overall performance, due to interference between adjacent optical channels
All-analogue real-time broadband filter bank multicarrier optical communications system
This paper studies the key aspects of an optical link which transmits a broadband microwave filter bank multicarrier (FBMC) signal. The study is presented in the context of creating an all-analogue real-time multigigabit orthogonal frequency division multiplexing electro-optical transceiver for short range and high-capacity data center networks. Passive microwave filters are used to perform the pulse shaping of the bit streams, allowing an orthogonal transmission without the necessity of digital signal processing (DSP). Accordingly, a cyclic prefix that would cause a reduction in the net data rate is not required. An experiment consisting of three orthogonally spaced 2.7 Gbaud quadrature phase shift keyed subchannels demonstrates that the spectral efficiency of traditional DSP-less subcarrier multiplexed links can be potentially doubled. A sensitivity of -29.5 dBm is achieved in a 1-km link
WDM orthogonal subcarrier multiplexing
Electro-optical transceivers can be implemented employing all-analog signal processing in order to achieve low values of power consumption and latency. This paper shows that the spectral efficiency of such solutions can be increased by combining orthogonal multicarrier techniques and off-the-shelf microwave components. A real-time 108-Gbit/s experiment was performed emulating a wavelength division multiplexing (WDM) system composed of five optical channels. The optical carriers were provided by an externally injected gain switched optical frequency comb. Each optical channel transmitted a 21.6-Gbit/s orthogonal subcarrier multiplexing (SCM) signal that was modulated and demodulated in the electrical domain without the requirement for digital signal processing. The net data rate remained higher than 100 Gbit/s after taking into account forward error correction overheads. The use of orthogonally overlapping subchannels achieves an unprecedented spectral efficiency in all-analog real-time broadband WDM/SCM links
Semiconductor Optical Amplifiers and mm-Wave Wireless Links for Converged Access Networks
Future access networks are converged optical-wireless networks, where fixed-line and wireless services share the same infrastructure. In this book, semiconductor optical amplifiers (SOA) and mm-wave wireless links are investigated, and their use in converged access networks is explored: SOAs compensate losses in the network, and thereby extend the network reach. Millimeter-wave wireless links substitute fiber links when cabling is not economical
Space station tracking requirements feasibility study, volume 2
The objective of this feasibility study is to determine analytically the accuracies of various sensors being considered as candidates for Space Station use. Specifically, the studies were performed whether or not the candidate sensors are capable of providing the required accuracy, or if alternate sensor approaches should be investigated. Other topics related to operation in the Space Station environment were considered as directed by NASA-JSC. The following topics are addressed: (1) Space Station GPS; (2) Space Station Radar; (3) Docking Sensors; (4) Space Station Link Analysis; (5) Antenna Switching, Power Control, and AGC Functions for Multiple Access; (6) Multichannel Modems; (7) FTS/EVA Emergency Shutdown; (8) Space Station Information Systems Coding; (9) Wanderer Study; and (10) Optical Communications System Analysis. Brief overviews of the abovementioned topics are given. Wherever applicable, the appropriate appendices provide detailed technical analysis. The report is presented in two volumes. This is Volume 2, containing Appendices K through U
Millimetre-Wave Fibre-Wireless Technologies for 5G Mobile Fronthaul
The unprecedented growth in mobile data traffic, driven primarily by bandwidth rich applications and high definition video is accelerating the development of fifth generation (5G) mobile network. As mobile access network evolves towards centralisation, mobile fronthaul (MFH) architecture becomes essential in providing high capacity, ubiquitous and yet affordable services to subscribers. In order to meet the demand for high data rates in the access, Millimetre-wave (mmWave) has been highlighted as an essential technology in the development of 5G-new radio (5G-NR). In the present MFH architecture which is typically based on common public radio interface (CPRI) protocol, baseband signals are digitised before fibre transmission, featuring high overhead data and stringent synchronisation requirements. A direct application of mmWave 5G-NR to CPRI digital MFH, where signal bandwidth is expected to be up to 1GHz will be challenging, due to the increased complexity of the digitising interface and huge overhead data that will be required for such bandwidth. Alternatively, radio over fibre (RoF) technique can be employed in the transportation of mmWave wireless signals via the MFH link, thereby avoiding the expensive digitisation interface and excessive overhead associated with its implementation. Additionally, mmWave carrier can be realised with the aid of photonic components employed in the RoF link, further reducing the system complexity. However, noise and nonlinearities inherent to analog transmission presents implementation challenges, limiting the system dynamic range. Therefore, it is important to investigate the effects of these impairments in RoF based MFH architecture.
This thesis presents extensive research on the impact of noise and nonlinearities on 5G candidate waveforms, in mmWave 5G fibre wireless MFH. Besides orthogonal frequency division multiplexing (OFDM), another radio access technology (RAT) that has received significant attention is filter bank multicarrier (FBMC), particularly due to its high spectral containment and excellent performance in asynchronous transmission. Hence, FBMC waveform is adopted in this work to study the impact of noise and nonlinearities on the mmWave fibre-wireless MFH architecture. Since OFDM is widely deployed and it has been adopted for 5G-NR, the performance of OFDM and FBMC based 5G mmWave RAT in fibre wireless MFH architecture is compared for several implementations and transmission scenarios.
To this extent, an end to end transmission testbed is designed and implemented using industry standard VPI Transmission Maker® to investigate five mmWave upconversion techniques. Simulation results show that the impact of noise is higher in FBMC when the signal to-noise (SNR) is low, however, FBMC exhibits better performance compared to OFDM as the SNR improved. More importantly, an evaluation of the contribution of each noise component to the overall system SNR is carried out. It is observed in the investigation that noise contribution from the optical carriers employed in the heterodyne upconversion of intermediate frequency (IF) signals to mmWave frequency dominate the system noise. An adaptive modulation technique is employed to optimise the system throughput based on the received SNR. The throughput of FBMC based system reduced significantly compared to OFDM, due to laser phase noise and chromatic dispersion (CD). Additionally, it is shown that by employing frequency domain averaging technique to enhance the channel estimation (CE), the throughput of FBMC is significantly increased and consequently, a comparable performance is obtained for both waveforms.
Furthermore, several coexistence scenarios for multi service transmission are studied, considering OFDM and FBMC based RATs to evaluate the impact inter band interference (IBI), due to power amplifier (PA) nonlinearity on the system performance. The low out of band (OOB) emission in FBMC plays an important role in minimising IBI to adjacent services. Therefore, FBMC requires less guardband in coexistence with multiple services in 5G fibre-wireless MFH. Conversely, OFDM introduced significant OOB to adjacent services requiring large guardband in multi-service coexistence transmission scenario.
Finally, a novel transmission scheme is proposed and investigated to simultaneously generate multiple mmWave signals using laser heterodyning mmWave upconversion technique. With appropriate IF and optical frequency plan, several mmWave signals can be realised. Simulation results demonstrate successful simultaneous realisation of 28GHz, 38GHz, and 60GHz mmWave signals
Compensation of fibre impairments in coherent optical systems
Tese de mestrado integrado. Engenharia Electrotécnica e de Computadores. Faculdade de Engenharia. Universidade do Porto. 201
Otimização do fronthaul ótico para redes de acesso de rádio (baseadas) em computação em nuvem (CC-RANs)
Doutoramento conjunto (MAP-Tele) em Engenharia Eletrotécnica/TelecomunicaçõesA proliferação de diversos tipos de dispositivos moveis, aplicações e serviços
com grande necessidade de largura de banda têm contribuído para o aumento
de ligações de banda larga e ao aumento do volume de trafego das
redes de telecomunicações moveis. Este aumento exponencial tem posto
uma enorme pressão nos mobile operadores de redes móveis (MNOs). Um
dos aspetos principais deste recente desenvolvimento, é a necessidade que as
redes têm de oferecer baixa complexidade nas ligações, como também baixo
consumo energético, muito baixa latência e ao mesmo tempo uma grande
capacidade por baixo usto. De maneira a resolver estas questões, os MNOs
têm focado a sua atenção na redes de acesso por rádio em nuvem (C-RAN)
principalmente devido aos seus benefícios em termos de otimização de performance
e relação qualidade preço. O standard para a distribuição de sinais
sem fios por um fronthaul C-RAN é o common public radio interface (CPRI).
No entanto, ligações óticas baseadas em interfaces CPRI necessitam de uma
grande largura de banda. Estes requerimentos podem também ser atingidos
com uma implementação em ligação free space optical (FSO) que é um sistema
ótico que usa comunicação sem fios. O FSO tem sido uma alternativa
muito apelativa aos sistemas de comunicação rádio (RF) pois combinam a
flexibilidade e mobilidade das redes RF ao mesmo tempo que permitem a
elevada largura de banda permitida pelo sistema ótico. No entanto, as ligações
FSO são suscetíveis a alterações atmosféricas que podem prejudicar
o desempenho do sistema de comunicação. Estas limitações têm evitado o
FSO de ser tornar uma excelente solução para o fronthaul. Uma caracterização
precisa do canal e tecnologias mais avançadas são então necessárias
para uma implementação pratica de ligações FSO. Nesta tese, vamos estudar
uma implementação eficiente para fronthaul baseada em tecnologia
á rádio-sobre-FSO (RoFSO). Propomos expressões em forma fechada para
mitigação das perdas de propagação e para a estimação da capacidade do
canal de maneira a aliviar a complexidade do sistema de comunicação. Simulações
numéricas são também apresentadas para formatos de modulação
adaptativas. São também considerados esquemas como um sistema hibrido
RF/FSO e tecnologias de transmissão apoiadas por retransmissores
que ajudam a alivar os requerimentos impostos por um backhaul/fronthaul
de C-RAN. Os modelos propostos não só reduzem o esforço computacional,
como também têm outros méritos, tais como, uma elevada precisão na estimação
do canal e desempenho, baixo requisitos na capacidade de memória
e uma rápida e estável operação comparativamente com o estado da arte
em sistemas analíticos (PON)-FSO. Este sistema é implementado num recetor
em tempo real que é emulado através de uma field-programmable gate
array (FPGA) comercial. Permitindo assim um sistema aberto, interoperabilidade,
portabilidade e também obedecer a standards de software aberto.
Os esquemas híbridos têm a habilidade de suportar diferentes aplicações,
serviços e múltiplos operadores a partilharem a mesma infraestrutura de
fibra ótica.The proliferation of different mobile devices, bandwidth-intensive applications
and services contribute to the increase in the broadband connections
and the volume of traffic on the mobile networks. This exponential growth
has put considerable pressure on the mobile network operators (MNOs). In
principal, there is a need for networks that not only offer low-complexity,
low-energy consumption, and extremely low-latency but also high-capacity
at relatively low cost. In order to address the demand, MNOs have given significant
attention to the cloud radio access network (C-RAN) due to its beneficial
features in terms of performance optimization and cost-effectiveness.
The de facto standard for distributing wireless signal over the C-RAN fronthaul
is the common public radio interface (CPRI). However, optical links
based on CPRI interfaces requires large bandwidth. Also, the aforementioned
requirements can be realized with the implementation of free space
optical (FSO) link, which is an optical wireless system. The FSO is an appealing
alternative to the radio frequency (RF) communication system that
combines the flexibility and mobility offered by the RF networks with the
high-data rates provided by the optical systems. However, the FSO links are
susceptible to atmospheric impairments which eventually hinder the system
performance. Consequently, these limitations prevent FSO from being an
efficient standalone fronthaul solution. So, precise channel characterizations
and advanced technologies are required for practical FSO link deployment
and operation. In this thesis, we study an efficient fronthaul implementation
that is based on radio-on-FSO (RoFSO) technologies. We propose closedform
expressions for fading-mitigation and for the estimation of channel
capacity so as to alleviate the system complexity. Numerical simulations
are presented for adaptive modulation scheme using advanced modulation
formats. We also consider schemes like hybrid RF/FSO and relay-assisted
transmission technologies that can help in alleviating the stringent requirements
by the C-RAN backhaul/fronthaul. The propose models not only
reduce the computational requirements/efforts, but also have a number of
diverse merits such as high-accuracy, low-memory requirements, fast and
stable operation compared to the current state-of-the-art analytical based
approaches. In addition to the FSO channel characterization, we present
a proof-of-concept experiment in which we study the transmission capabilities
of a hybrid passive optical network (PON)-FSO system. This is
implemented with the real-time receiver that is emulated by a commercial
field-programmable gate array (FPGA). This helps in facilitating an
open system and hence enables interoperability, portability, and open software
standards. The hybrid schemes have the ability to support different
applications, services, and multiple operators over a shared optical fiber
infrastructure