IC-Antenna Co-Integration for Efficient and Scalable Millimeter-Wave Antenna Interfaces

Millimeter-wave (mm-wave) technology promises high speed, high system capacity and low latency interconnects with reduced cost. Applications like high data-rate wireless links, next generation automotive sensors and security body scanners highly depend on mm-wave technology innovations. As operating frequency moves to higher mm-wave bands, shrinking antenna dimensions enable co-integration of IC and antenna. Limited transistor output power at mm-wave requires multi-element arrays to satisfy communication and radar link budgets. This dissertation presents a wafer-scale compatible IC-antenna co-integration for efficient and scalable mm-wave antenna interfaces. The proposed IC-antenna co-integration approach is demonstrated through single antenna transmitters, a concurrent dual-polarization receiver front-end and polarization-duplex transmitter/receiver front-end. Chapter 2 discusses the challenge of mm-wave IC-antenna interfaces with prior art including antenna-in-package (AiP) and on-chip antennas. The 60 GHz efficient, scalable and wafer-scale compatible IC-antenna co-integration approach is presented demonstrating wide bandwidth and large efficiency which are comparable to system-level AiP techniques at a lower cost and fabrication complexity. Chapter 3 extends the proposed approach to a concurrent 60 GHz dual-polarization receiver front-end for short-range imaging/communication applications and polarization diversity based MIMO links. Active cancellation between orthogonal polarizations is adopted to achieve ∼ 30 dB cross-polarization leakage cancellation and concurrent dual-pol reception. Chapter 4 presents a 60 GHz simultaneous transmit and receive front-end to achieve efficient polarization-duplex operation based on dual-polarization IC-antenna co-integration. Transmitter leakage is suppressed at receiver input and output by intrinsic antenna isolation and a feed-forward passive canceller. Total average self-interference cancellation >40 dB is achieved for 1.07 GHz RF bandwidth at 60 GHz in the presence of a reflector

A Directly Matched PA-Integrated K-band Antenna for Efficient mm-Wave High-Power Generation

A K-band slot antenna element with integrated GaN (Gallium nitride) power amplifier (PA) is presented. It has been optimized through a circuit-EM co-design methodology to directly match the transistor drain output to its optimal load impedance (\ua0Zopt=17+j46Ω\ua0) while accounting for the over-the-air coupling effects in the vicinity of the transition between the PA and antenna. This obviates the need for using a potentially lossy and bandwidth-limiting output impedance matching network. The measured PA-integrated antenna gain of 15 dBi with a 40% total efficiency at 28 dBm output power agrees well with the theoretically achievable performance targets. The proposed element is compact (\ua00.6 70.5 70.3\ua0λ3\ua0), and thus well-suited to meet the high-performance demands of future emerging beamforming active antenna array applications

A review of technologies and design techniques of millimeter-wave power amplifiers

his article reviews the state-of-the-art millimeter-wave (mm-wave) power amplifiers (PAs), focusing on broadband design techniques. An overview of the main solid-state technologies is provided, including Si, gallium arsenide (GaAs), GaN, and other III-V materials, and both field-effect and bipolar transistors. The most popular broadband design techniques are introduced, before critically comparing through the most relevant design examples found in the scientific literature. Given the wide breadth of applications that are foreseen to exploit the mm-wave spectrum, this contribution will represent a valuable guide for designers who need a single reference before adventuring in the challenging task of the mm-wave PA design

Design methods for 60GHz beamformers in CMOS

The 60GHz band is promising for applications such as high-speed short-range wireless personal-area network (WPAN), real-time video streaming at rates of several-Gbps, automotive radar, and mm-Wave imaging, since it provides a large amount of bandwidth that can freely (i.e. without a license) be used worldwide. However, transceivers at 60GHz pose several additional challenges over microwave transceivers. In addition to the circuit design challenges of implementing high performance 60GHz RF circuits in mainstream CMOS technology, the path loss at 60GHz is significantly higher than at microwave frequencies because of the smaller size of isotropic antennas. This can be overcome by using phased array technology. This thesis studies the new concepts and design techniques that can be used for 60GHz phased array systems. It starts with an overview of various applications at mm-wave frequencies, such as multi-Gbps radio at 60GHz, automotive radar and millimeter-wave imaging. System considerations of mm-wave receivers and transmitters are discussed, followed by the selection of a CMOS technology to implement millimeter-wave (60GHz) systems. The link budget of a 60GHz WPAN is analyzed, which leads to the introduction of phased array techniques to improve system performance. Different phased array architectures are studied and compared. The system requirements of phase shifters are discussed. Several types of conventional RF phase shifters are reviewed. A 60GHz 4-bit passive phase shifter is designed and implemented in a 65nm CMOS technology. Measurement results are presented and compared to published prior art. A 60GHz 4-bit active phase shifter is designed and integrated with low noise amplifier and combiner for a phased array receiver. This is implemented in a 65nm CMOS technology, and the measurement results are presented. The design of a 60GHz 4-bit active phase shifter and its integration with power amplifier is also presented for a phased array transmitter. This is implemented in a 65nm CMOS technology. The measurement results are also presented and compared to reported prior art. The integration of a 60GHz CMOS amplifier and an antenna in a printed circuit-board (PCB) package is investigated. Experimental results are presented and discussed

Pathways to servers of the future

The Special Session on “Pathways to Servers of the Future” outlines a new research program set up at Technische Universität Dresden addressing the increasing energy demand of global internet usage and the resulting ecological impact of it. The program pursues a novel holistic approach that considers hardware as well as software adaptivity to significantly increase energy efficiency, while suitably addressing application demands. The session presents the research challenges and industry perspective

Integrated Circuit and Antenna Technology for Millimeter-wave Phased Array Radio Front-end

Ever growing demands for higher data rate and bandwidth are pushing extremely high data rate wireless applications to millimeter-wave band (30-300GHz), where sufficient bandwidth is available and high data rate wireless can be achieved without using complex modulation schemes. In addition to the communication applications, millimeter-wave band has enabled novel short range and long range radar sensors for automotive as well as high resolution imaging systems for medical and security. Small size, high gain antennas, unlicensed and worldwide availability of released bands for communication and a number of other applications are other advantages of the millimeter-wave band. The major obstacle for the wide deployment of commercial wireless and radar systems in this frequency range is the high cost and bulky nature of existing GaAs- and InP-based solutions. In recent years, with the rapid scaling and development of the silicon-based integrated circuit technologies such as CMOS and SiGe, low cost technologies have shown acceptable millimeter-wave performance, which can enable highly integrated millimeter-wave radio devices and reduce the cost significantly. Furthermore, at this range of frequencies, on-chip antenna becomes feasible and can be considered as an attractive solution that can further reduce the cost and complexity of the radio package. The propagation channel challenges for the realization of low cost and reliable silicon-based communication devices at millimeter-wave band are severe path loss as well as shadowing loss of human body. Silicon technology challenges are low-Q passive components, low breakdown voltage of active devices, and low efficiency of on-chip antennas. The main objective of this thesis is to investigate and to develop antenna and front-end for cost-effective silicon based millimeter-wave phased array radio architectures that can address above challenges for short range, high data rate wireless communication as well as radar applications. Although the proposed concepts and the results obtained in this research are general, as an important example, the application focus in this research is placed on the radio aspects of emerging 60 GHz communication system. For this particular but extremely important case, various aspects of the technology including standard, architecture, antenna options and indoor propagation channel at presence of a human body are studied. On-chip dielectric resonator antenna as a radiation efficiency improvement technique for an on-chip antenna on low resistivity silicon is presented, developed and proved by measurement. Radiation efficiency of about 50% was measured which is a significant improvement in the radiation efficiency of on-chip antennas. Also as a further step, integration of the proposed high efficiency antenna with an amplifier in transmit and receive configurations at 30 GHz is successfully demonstrated. For the implementation of a low cost millimeter-wave array antenna, miniaturized, and efficient antenna structures in a new integrated passive device technology using high resistivity silicon are designed and developed. Front-end circuit blocks such as variable gain LNA, continuous passive and active phase shifters are investigated, designed and developed for a 60GHz phased array radio in CMOS technology. Finally, two-element CMOS phased array front-ends based on passive and active phase shifting architectures are proposed, developed and compared

Architectures and Integrated Circuits for Efficient, High-power "Digital'' Transmitters for Millimeter-wave Applications

This thesis presents architectures and integrated circuits for the implementation of energy-efficient, high-power "digital'' transmitters to realize high-speed long-haul links at millimeter-wave frequencies in nano-scale silicon-based processes

High Performance Local Oscillator Design for Next Generation Wireless Communication

Local Oscillator (LO) is an essential building block in modern wireless radios. In modern wireless radios, LO often serves as a reference of the carrier signal to modulate or demod- ulate the outgoing or incoming data. The LO signal should be a clean and stable source, such that the frequency or timing information of the carrier reference can be well-defined. However, as radio architecture evolves, the importance of LO path design has become much more important than before. Of late, many radio architecture innovations have exploited sophisticated LO generation schemes to meet the ever-increasing demands of wireless radio performances. The focus of this thesis is to address challenges in the LO path design for next-generation high performance wireless radios. These challenges include (1) Congested spectrum at low radio frequency (RF) below 5GHz (2) Continuing miniaturization of integrated wireless radio, and (3) Fiber-fast (>10Gb/s) mm-wave wireless communication. The thesis begins with a brief introduction of the aforementioned challenges followed by a discussion of the opportunities projected to overcome these challenges. To address the challenge of congested spectrum at frequency below 5GHz, novel ra- dio architectures such as cognitive radio, software-defined radio, and full-duplex radio have drawn significant research interest. Cognitive radio is a radio architecture that opportunisti- cally utilize the unused spectrum in an environment to maximize spectrum usage efficiency. Energy-efficient spectrum sensing is the key to implementing cognitive radio. To enable energy-efficient spectrum sensing, a fast-hopping frequency synthesizer is an essential build- ing block to swiftly sweep the carrier frequency of the radio across the available spectrum. Chapter 2 of this thesis further highlights the challenges and trade-offs of the current LO gen- eration scheme for possible use in sweeping LO-based spectrum analysis. It follows by intro- duction of the proposed fast-hopping LO architecture, its implementation and measurement results of the validated prototype. Chapter 3 proposes an embedded phase-shifting LO-path design for wideband RF self-interference cancellation for full-duplex radio. It demonstrates a synergistic design between the LO path and signal to perform self-interference cancellation. To address the challenge of continuing miniaturization of integrated wireless radio, ring oscillator-based frequency synthesizer is an attractive candidate due to its compactness. Chapter 4 discussed the difficulty associated with implementing a Phase-Locked Loop (PLL) with ultra-small form-factor. It further proposes the concept sub-sampling PLL with time- based loop filter to address these challenges. A 65nm CMOS prototype and its measurement result are presented for validation of the concept. In shifting from RF to mm-wave frequencies, the performance of wireless communication links is boosted by significant bandwidth and data-rate expansion. However, the demand for data-rate improvement is out-pacing the innovation of radio architectures. A >10Gb/s mm-wave wireless communication at 60GHz is required by emerging applications such as virtual-reality (VR) headsets, inter-rack data transmission at data center, and Ultra-High- Definition (UHD) TV home entertainment systems. Channel-bonding is considered to be a promising technique for achieving >10Gb/s wireless communication at 60GHz. Chapter 5 discusses the fundamental radio implementation challenges associated with channel-bonding for 60GHz wireless communication and the pros and cons of prior arts that attempted to address these challenges. It is followed by a discussion of the proposed 60GHz channel- bonding receiver, which utilizes only a single PLL and enables both contiguous and non- contiguous channel-bonding schemes. Finally, Chapter 6 presents the conclusion of this thesis

Wideband Circuits and Antenna Designs for mm-Wave/5G Phased Arrays

The objective of this work is to present the performance and feasibility of wideband circuits and antennas for future mm-Wave phased array systems. Chapter 1 introduces the motivation of this research, first explaining the desire to operate at higher frequency regimes. Then focus is directed on the rich application spaces at mm-Wave frequencies and the corresponding need for wideband, compact, and fully integrated system-on-chip (SoC) solutions. A brief study of advanced node commercial silicon processes is also examined to demonstrate the increasing feasibility of implementing the aforementioned SoC solutions on silicon. Chapter 2 presents a design methodology of a novel ultra-compact, low-loss, and wideband mm-Wave Wilkinson Power Divider (WPD). Careful study and analysis reveal optimal and necessary design parameters and equations in terms of the coupling and mutual inductances within the structure, yielding a device that is competitive with existing literature. Chapter 3 first introduces the operation principle of spiral antennas (SA). The unique properties of SAs that make them great candidates for use in future mm-Wave phased arrays are explored. The rest of this chapter discusses the design, analysis, and results of an octagonal 4-arm Archimedean SA. Lastly, Chapter 4 provides closing remarks and discusses potential future work.M.S