3D Millimeter-Wave Peer-to-Peer Networks With Boundary Located Destination

This letter presents a theoretical analysis for estimating the coverage probability and the average link capacity of an interfered peer-to-peer millimeter-wave communication, when the destination lies at the boundary of a three-dimensional cell. The proposed model provides closed-form expressions for the statistics of the desired and undesired signal powers, by accounting for the impact of directional antenna gains, path-loss attenuation, mid-scale fading, interference, and noise

System-Level Dynamics of Highly Directional Distributed Networks

While highly directional communications may offer considerable improvements in the link data rate and over-the-air latency of high-end wearable devices, the system-level capacity trade-offs call for separate studies with respect to the employed multiple access procedures and the network dynamics in general. This letter proposes a framework for estimating the system-level area throughput in dynamic distributed networks of highly-directional paired devices. We provide numerical expressions for the steady-state distribution of the number of actively communicating pairs and the probability of successful session initialization as well as derive the corresponding closed-form approximation for dense deployments.Comment: Accepted to IEEE Wireless Communications Letters on April 5, 2021. Copyright may be transferred without further notice after which this version may become non-availabl

Unmanned Aerial Vehicle (UAV)-Enabled Wireless Communications and Networking

The emerging massive density of human-held and machine-type nodes implies larger traffic deviatiolns in the future than we are facing today. In the future, the network will be characterized by a high degree of flexibility, allowing it to adapt smoothly, autonomously, and efficiently to the quickly changing traffic demands both in time and space. This flexibility cannot be achieved when the network’s infrastructure remains static. To this end, the topic of UAVs (unmanned aerial vehicles) have enabled wireless communications, and networking has received increased attention. As mentioned above, the network must serve a massive density of nodes that can be either human-held (user devices) or machine-type nodes (sensors). If we wish to properly serve these nodes and optimize their data, a proper wireless connection is fundamental. This can be achieved by using UAV-enabled communication and networks. This Special Issue addresses the many existing issues that still exist to allow UAV-enabled wireless communications and networking to be properly rolled out

Architecting a One-to-many Traffic-Aware and Secure Millimeter-Wave Wireless Network-in-Package Interconnect for Multichip Systems

With the aggressive scaling of device geometries, the yield of complex Multi Core Single Chip(MCSC) systems with many cores will decrease due to the higher probability of manufacturing defects especially, in dies with a large area. Disintegration of large System-on-Chips(SoCs) into smaller chips called chiplets has shown to improve the yield and cost of complex systems. Therefore, platform-based computing modules such as embedded systems and micro-servers have already adopted Multi Core Multi Chip (MCMC) architectures overMCSC architectures. Due to the scaling of memory intensive parallel applications in such systems, data is more likely to be shared among various cores residing in different chips resulting in a significant increase in chip-to-chip traffic, especially one-to-many traffic. This one-to-many traffic is originated mainly to maintain cache-coherence between many cores residing in multiple chips. Besides, one-to-many traffics are also exploited by many parallel programming models, system-level synchronization mechanisms, and control signals. How-ever, state-of-the-art Network-on-Chip (NoC)-based wired interconnection architectures do not provide enough support as they handle such one-to-many traffic as multiple unicast trafficusing a multi-hop MCMC communication fabric. As a result, even a small portion of such one-to-many traffic can significantly reduce system performance as traditional NoC-basedinterconnect cannot mask the high latency and energy consumption caused by chip-to-chipwired I/Os. Moreover, with the increase in memory intensive applications and scaling of MCMC systems, traditional NoC-based wired interconnects fail to provide a scalable inter-connection solution required to support the increased cache-coherence and synchronization generated one-to-many traffic in future MCMC-based High-Performance Computing (HPC) nodes. Therefore, these computation and memory intensive MCMC systems need an energy-efficient, low latency, and scalable one-to-many (broadcast/multicast) traffic-aware interconnection infrastructure to ensure high-performance. Research in recent years has shown that Wireless Network-in-Package (WiNiP) architectures with CMOS compatible Millimeter-Wave (mm-wave) transceivers can provide a scalable, low latency, and energy-efficient interconnect solution for on and off-chip communication. In this dissertation, a one-to-many traffic-aware WiNiP interconnection architecture with a starvation-free hybrid Medium Access Control (MAC), an asymmetric topology, and a novel flow control has been proposed. The different components of the proposed architecture are individually one-to-many traffic-aware and as a system, they collaborate with each other to provide required support for one-to-many traffic communication in a MCMC environment. It has been shown that such interconnection architecture can reduce energy consumption and average packet latency by 46.96% and 47.08% respectively for MCMC systems. Despite providing performance enhancements, wireless channel, being an unguided medium, is vulnerable to various security attacks such as jamming induced Denial-of-Service (DoS), eavesdropping, and spoofing. Further, to minimize the time-to-market and design costs, modern SoCs often use Third Party IPs (3PIPs) from untrusted organizations. An adversary either at the foundry or at the 3PIP design house can introduce a malicious circuitry, to jeopardize an SoC. Such malicious circuitry is known as a Hardware Trojan (HT). An HTplanted in the WiNiP from a vulnerable design or manufacturing process can compromise a Wireless Interface (WI) to enable illegitimate transmission through the infected WI resulting in a potential DoS attack for other WIs in the MCMC system. Moreover, HTs can be used for various other malicious purposes, including battery exhaustion, functionality subversion, and information leakage. This information when leaked to a malicious external attackercan reveals important information regarding the application suites running on the system, thereby compromising the user profile. To address persistent jamming-based DoS attack in WiNiP, in this dissertation, a secure WiNiP interconnection architecture for MCMC systems has been proposed that re-uses the one-to-many traffic-aware MAC and existing Design for Testability (DFT) hardware along with Machine Learning (ML) approach. Furthermore, a novel Simulated Annealing (SA)-based routing obfuscation mechanism was also proposed toprotect against an HT-assisted novel traffic analysis attack. Simulation results show that,the ML classifiers can achieve an accuracy of 99.87% for DoS attack detection while SA-basedrouting obfuscation could reduce application detection accuracy to only 15% for HT-assistedtraffic analysis attack and hence, secure the WiNiP fabric from age-old and emerging attacks

Recent Trends in Communication Networks

In recent years there has been many developments in communication technology. This has greatly enhanced the computing power of small handheld resource-constrained mobile devices. Different generations of communication technology have evolved. This had led to new research for communication of large volumes of data in different transmission media and the design of different communication protocols. Another direction of research concerns the secure and error-free communication between the sender and receiver despite the risk of the presence of an eavesdropper. For the communication requirement of a huge amount of multimedia streaming data, a lot of research has been carried out in the design of proper overlay networks. The book addresses new research techniques that have evolved to handle these challenges

Recent Results on the Implementation of a Burst Error and Burst Erasure Channel Emulator Using an FPGA Architecture

The behaviour of a transmission channel may be simulated using the performance abilities of current generation multiprocessing hardware, namely, a multicore Central Processing Unit (CPU), a general purpose Graphics Processing Unit (GPU), or a Field Programmable Gate Array (FPGA). These were investigated by Cullinan et al. in a recent paper (published in 2012) where these three devices capabilities were compared to determine which device would be best suited towards which specific task. In particular, it was shown that, for the application which is objective of our work (i.e., for a transmission channel simulation), the FPGA is 26.67 times faster than the GPU and 10.76 times faster than the CPU. Motivated by these results, in this paper we propose and present a direct hardware emulation. In particular, a Cyclone II FPGA architecture is implemented to simulate a burst error channel behaviour, in which errors are clustered together, and a burst erasure channel behaviour, in which the erasures are clustered together. The results presented in the paper are valid for any FPGA architecture that may be considered for this scope

Cooperative Radio Communications for Green Smart Environments

The demand for mobile connectivity is continuously increasing, and by 2020 Mobile and Wireless Communications will serve not only very dense populations of mobile phones and nomadic computers, but also the expected multiplicity of devices and sensors located in machines, vehicles, health systems and city infrastructures. Future Mobile Networks are then faced with many new scenarios and use cases, which will load the networks with different data traffic patterns, in new or shared spectrum bands, creating new specific requirements. This book addresses both the techniques to model, analyse and optimise the radio links and transmission systems in such scenarios, together with the most advanced radio access, resource management and mobile networking technologies. This text summarises the work performed by more than 500 researchers from more than 120 institutions in Europe, America and Asia, from both academia and industries, within the framework of the COST IC1004 Action on "Cooperative Radio Communications for Green and Smart Environments". The book will have appeal to graduates and researchers in the Radio Communications area, and also to engineers working in the Wireless industry. Topics discussed in this book include: • Radio waves propagation phenomena in diverse urban, indoor, vehicular and body environments• Measurements, characterization, and modelling of radio channels beyond 4G networks• Key issues in Vehicle (V2X) communication• Wireless Body Area Networks, including specific Radio Channel Models for WBANs• Energy efficiency and resource management enhancements in Radio Access Networks• Definitions and models for the virtualised and cloud RAN architectures• Advances on feasible indoor localization and tracking techniques• Recent findings and innovations in antenna systems for communications• Physical Layer Network Coding for next generation wireless systems• Methods and techniques for MIMO Over the Air (OTA) testin

Advanced Trends in Wireless Communications

Physical limitations on wireless communication channels impose huge challenges to reliable communication. Bandwidth limitations, propagation loss, noise and interference make the wireless channel a narrow pipe that does not readily accommodate rapid flow of data. Thus, researches aim to design systems that are suitable to operate in such channels, in order to have high performance quality of service. Also, the mobility of the communication systems requires further investigations to reduce the complexity and the power consumption of the receiver. This book aims to provide highlights of the current research in the field of wireless communications. The subjects discussed are very valuable to communication researchers rather than researchers in the wireless related areas. The book chapters cover a wide range of wireless communication topics

Exploring Wireless Data Center Networks: Can They Reduce Energy Consumption While Providing Secure Connections?

Data centers have become the digital backbone of the modern world. To support the growing demands on bandwidth, Data Centers consume an increasing amount of power. A significant portion of that power is consumed by information technology (IT) equipment, including servers and networking components. Additionally, the complex cabling in traditional data centers poses design and maintenance challenges and increases the energy cost of the cooling infrastructure by obstructing the flow of chilled air. Hence, to reduce the power consumption of the data centers, we proposed a wireless server-to-server data center network architecture using millimeter-wave links to eliminate the need for power-hungry switching fabric of traditional fat-tree-based data center networks. The server-to-server wireless data center network (S2S-WiDCN) architecture requires Line-of-Sight (LoS) between servers to establish direct communication links. However, in the presence of interference from internal or external sources, or an obstruction, such as an IT technician, the LoS may be blocked. To address this issue, we also propose a novel obstruction-aware adaptive routing algorithm for S2S-WiDCN. S2S-WiDCN can reduce the power consumption of the data center network portion while not affecting the power consumption of the servers in the data center, which contributes significantly towards the total power consumption of the data center. Moreover, servers in data centers are almost always underutilized due to over-provisioning, which contributes heavily toward the high-power consumption of the data centers. To address the high power consumption of the servers, we proposed a network-aware bandwidth-constrained server consolidation algorithm called Network-Aware Server Consolidation (NASCon) for wireless data centers that can reduce the power consumption up to 37% while improving the network performance. However, due to the arrival of new tasks and the completion of existing tasks, the consolidated utilization profile of servers change, which may have an adverse effect on overall power consumption over time. To overcome this, NASCon algorithm needs to be executed periodically. We have proposed a mathematical model to estimate the optimal inter-consolidation time, which can be used by the data center resource management unit for scheduling NASCon consolidation operation in real-time and leverage the benefits of server consolidation. However, in any data center environment ensuring security is one of the highest design priorities. Hence, for S2S-WiDCN to become a practical and viable solution for data center network design, the security of the network has to be ensured. S2S-WiDCN data center can be vulnerable to a variety of different attacks as it uses wireless links over an unguided channel for communication. As being a wireless system, the network has to be secured against common threats associated with any wireless networks such as eavesdropping attack, denial of services attack, and jamming attack. In parallel, other security threats such as the attack on the control plane, side-channel attack through traffic analysis are also possible. We have done an extensive study to elaborate the scope of these attacks as well as explore probable solutions against these issues. We also proposed viable solutions for the attack against eavesdropping, denial of services, jamming, and control-plane attack. To address the traffic analysis attack, we proposed a simulated annealing-based random routing mechanism which can be adopted instead of default routing in the wireless data center

Evolution Toward 5G Mobile Networks - A Survey on Enabling Technologies

In this paper, an extensive review has been carried out on the trends of existing as well as proposed potential enabling technologies that are expected to shape the fifth generation (5G) mobile wireless networks. Based on the classification of the trends, we develop a 5G network architectural evolution framework that comprises three evolutionary directions, namely, (1) radio access network node and performance enabler, (2) network control programming platform, and (3) backhaul network platform and synchronization. In (1), we discuss node classification including low power nodes in emerging machine-type communications, and network capacity enablers, e.g., millimeter wave communications and massive multiple-input multiple-output. In (2), both logically distributed cell/device-centric platforms, and logically centralized conventional/wireless software defined networking control programming approaches are discussed. In (3), backhaul networks and network synchronization are discussed. A comparative analysis for each direction as well as future evolutionary directions and challenges toward 5G networks are discussed. This survey will be helpful for further research exploitations and network operators for a smooth evolution of their existing networks toward 5G networks