Anatomical calibration through post-processing of standard motion tests data

The inertial measurement unit is popularly used as a wearable and flexible tool for human motion tracking. Sensor-to-body alignment, or anatomical calibration (AC), is fundamental to improve accuracy and reliability. Current AC methods either require extra movements or are limited to specific joints. In this research, the authors propose a novel method to achieve AC from standard motion tests (such as walking, or sit-to-stand), and compare the results with the AC obtained from specially designed movements. The proposed method uses the limited acceleration range on medial-lateral direction, and applies principal component analysis to estimate the sagittal plane, while the vertical direction is estimated from acceleration during quiet stance. The results show a good correlation between the two sets of IMUs placed on frontal/back and lateral sides of head, trunk and lower limbs. Moreover, repeatability and convergence were verified. The AC obtained from sit-to-stand and walking achieved similar results as the movements specifically designed for upper and lower body AC, respectively, except for the feet. Therefore, the experiments without AC performed can be recovered through post-processing on the walking and sit-to-stand data. Moreover, extra movements for AC can be avoided during the experiment and instead achieved through the proposed method

Comparison of gait event detection from shanks and feet in single-task and multi-task walking of healthy older adults

Automatic and objective detection algorithms for gait events from MEMS Inertial Measurement Units data have been developed to overcome subjective inaccuracy in traditional visual observation. Their accuracy and sensitivity have been verified with healthy older adults, Parkinson's disease and spinal injured patients, using single-task gait exercises, where events are precise as the subject is focusing only on walking. Multi-task walking instead simulates a more realistic and challenging scenario where subjects perform secondary cognitive task while walking, so it is a better benchmark. In this paper, we test two algorithms based on shank and foot angular velocity data in single-task, dual-task and multi-task walking. Results show that both algorithms fail when the subject slows extremely down or pauses due to high cognitive and attentional load, and, in particular, the first stride detection error rate of the foot-based algorithm increases. Stride time is accurate with both algorithms regardless of walking types, but the shank-based algorithm leads to an overestimation on the proportion of swing phase in one gait cycle. Increasing the number of cognitive tasks also causes this error with both algorithms

Angular sway propagation in One Leg Stance and quiet stance with Inertial Measurement Units for older adults

Postural stability degrades with age, threating the health and life quality of the older adults. One Leg Stance (OLS) is one of the standard and commonly adopted assessments for postural stability, and the postural sway in OLS has been demonstrated to be related with age. The propagation of postural sway between body segments could be a hint to the underlying mechanism of balance control. However, it is not yet fully understood. Therefore, the aim of this paper was to study the angular sways and their propagation of the head, trunk, and lower limb in healthy older adults. A cross-correlation of the normalized angular speeds was performed and the experiment with 68 older adults was conducted. The results showed that the head, hip and ankle joints affected the transfer of angular sway with a relatively lower correlation and longer latency

Comparison of gait event detection from shanks and feet in single-task and multi-task walking of healthy older adults

Automatic and objective detection algorithms for gait events from MEMS Inertial Measurement Units data have been developed to overcome subjective inaccuracy in traditional visual observation. Their accuracy and sensitivity have been verified with healthy older adults, Parkinson's disease and spinal injured patients, using single-task gait exercises, where events are precise as the subject is focusing only on walking. Multi-task walking instead simulates a more realistic and challenging scenario where subjects perform secondary cognitive task while walking, so it is a better benchmark. In this paper, we test two algorithms based on shank and foot angular velocity data in single-task, dual-task and multi-task walking. Results show that both algorithms fail when the subject slows extremely down or pauses due to high cognitive and attentional load, and, in particular, the first stride detection error rate of the foot-based algorithm increases. Stride time is accurate with both algorithms regardless of walking types, but the shank-based algorithm leads to an overestimation on the proportion of swing phase in one gait cycle. Increasing the number of cognitive tasks also causes this error with both algorithms

Development of new muscle contraction sensor to replace sEMG for using in muscles analysis fields

Nowadays, the technologies for detecting, processing and interpreting bioelectrical signals have improved tremendously. In particular, surface electromyography (sEMG) has gained momentum in a wide range of applications in various fields. However, sEMG sensing has several shortcomings, the most important being: measurements are heavily sensible to individual differences, sensors are difficult to position and very expensive. In this paper, the authors will present an innovative muscle contraction sensing device (MC sensor), aiming to replace sEMG sensing in the field of muscle movement analysis. Compared with sEMG, this sensor is easier to position, setup and use, less dependent from individual differences, and less expensive. Preliminary experiments, described in this paper, confirm that MC sensing is suitable for muscle contraction analysis, and compare the results of sEMG and MC sensor for the measurement of forearm muscle contraction

Application of wireless inertial measurement units and EMG sensors for studying deglutition - preliminary results

Different types of sensors are being used to study deglutition and mastication. These often suffer from problems related to portability, cost, reliability, comfort etc. that make it difficult to use for long term studies. An inertial measurement based sensor seems a good fit in this application; however its use has not been explored much for the specific application of deglutition research. In this paper, we present a system comprised of an IMU and EMG sensor that are integrated together as a single system. With a preliminary experiment, we determine that the system can be used for measuring the head-neck posture during swallowing in addition to other parameters during the swallowing phase. The EMG sensor may not always be a reliable source of physiological data especially for small clustered muscles like the ones responsible for swallowing. In this case, we explore the possibility of using gyroscopic data for the recognition of deglutition events

Development of new muscle contraction sensor to replace sEMG for using in muscles analysis fields

Nowadays, the technologies for detecting, processing and interpreting bioelectrical signals have improved tremendously. In particular, surface electromyography (sEMG) has gained momentum in a wide range of applications in various fields. However, sEMG sensing has several shortcomings, the most important being: measurements are heavily sensible to individual differences, sensors are difficult to position and very expensive. In this paper, the authors will present an innovative muscle contraction sensing device (MC sensor), aiming to replace sEMG sensing in the field of muscle movement analysis. Compared with sEMG, this sensor is easier to position, setup and use, less dependent from individual differences, and less expensive. Preliminary experiments, described in this paper, confirm that MC sensing is suitable for muscle contraction analysis, and compare the results of sEMG and MC sensor for the measurement of forearm muscle contraction

Angular sway propagation in One Leg Stance and quiet stance with Inertial Measurement Units for older adults

Postural stability degrades with age, threating the health and life quality of the older adults. One Leg Stance (OLS) is one of the standard and commonly adopted assessments for postural stability, and the postural sway in OLS has been demonstrated to be related with age. The propagation of postural sway between body segments could be a hint to the underlying mechanism of balance control. However, it is not yet fully understood. Therefore, the aim of this paper was to study the angular sways and their propagation of the head, trunk, and lower limb in healthy older adults. A cross-correlation of the normalized angular speeds was performed and the experiment with 68 older adults was conducted. The results showed that the head, hip and ankle joints affected the transfer of angular sway with a relatively lower correlation and longer latency