4,575 research outputs found

    Ring cusp/hollow cathode discharge chamber performance studies

    Get PDF
    An experimental study was performed to determine the effects of hollow cathode position, anode position, and ring cusp magnetic field configuration and strength on discharge chamber performance. The results are presented in terms of comparative plasma ion energy cost, extracted ion fraction, and beam profile data. Such comparisons are used to demonstrate whether changes in performance are caused by changes in the loss rate of primary electrons to the anode or the loss rate of ions to discharge chamber walls or cathode and anode surfaces. Results show: (1) the rate of primary electron loss to the anode decreases as the anode is moved downstream of the ring cusp toward the screen grid; (2) the loss rate of ions to hollow cathode surfaces are excessive if the cathode is located upstream of a point of peak magnetic flux density at the discharge chamber centerline; and (3) the fraction of the ions produced that are lost to discharge chamber walls and ring magnet surfaces is reduced by positioning of the magnet rings so the plasma density is uniform over the grid surface, and adjusting their strength to a level where it is sufficient to prevent excessive ion losses by Bohm diffusion

    Heat-load simulator for heat sink design

    Get PDF
    Heat-load simulator is fabricated from 1/4-inch aluminum plate with a contact surface equal in dimensions and configuration to those of the electronic installation. The method controls thermal output to simulate actual electronic component thermal output

    Trends and correlates of marijuana use among late middle-aged and older adults in the United States, 2002–2014

    Full text link
    BACKGROUND: Recent trend studies suggest that marijuana use is on the rise among the general population of adults ages 18 and older in the United States. However, little is known about the trends in marijuana use and marijuana-specific risk/protective factors among American adults during the latter part of adulthood. METHOD: Findings are based on repeated, cross-sectional data collected from late middle-aged (ages 50–64) and older adults (ages 65 and older) surveyed as part of the National Survey on Drug Use and Health between 2002 and 2014. RESULTS: The prevalence of past-year marijuana use among late middle-aged adults increased significantly from a low of 2.95% in 2003 to a high of 9.08% in 2014. Similarly, the prevalence of marijuana use increased significantly among older adults from a low of 0.15% in 2003 to a high of 2.04% in 2014. Notably, the upward trends in marijuana use remained significant even when accounting for sociodemographic, substance use, behavioral, and health-related factors. We also found that decreases in marijuana-specific protective factors were associated with the observed trend changes in marijuana use among late middle-aged and older adults, and observed a weakening of the association between late-middle aged marijuana use and risk propensity, other illicit drug use, and criminal justice system involvement over the course of the study. CONCLUSIONS: Findings from the present study provide robust evidence indicating that marijuana use among older Americans has increased markedly in recent years, with the most evident changes observed between 2008 and 2014

    Current flow in a plasma caused by dielectric breakdown

    Get PDF
    Spacecraft with a thin dielectric coating on the outer surface of the structure which are biased (-200 V) negative relative to the atmospheric plasma are susceptible to dielectric breakdown. This paper will present experimental tests designed to measure the electron current flow from the structure through the plasma during the arc. The current path was examined in three parts: the electrons supplied through the structure and the arc to the outer structure, the expansion of the arc into the ambient plasma, and the return current through the ambient plasma. The measured electron current either flowing from the plasma or supplied to the plasma by the arc in each case was compared to the random thermal electron current which could be collected. The results of the tests show a spacecraft is capable of supporting arcs with peak currents greater than thermal electron currents, and these currents will be dependent upon the amount of stored charge in the structure (i.e., the structure's surface area and dielectric thickness). Also, the results of these tests show that it is possible for structures with a self capacitance of 10 microFarads to see peak currents of 90 A and structures with 1000 microFarads (i.e., capacitance of one Space Station Freedom module) to produce peak currents of 1000 A

    Atomic oxygen beam source for erosion simulation

    Get PDF
    A device for the production of low energy (3 to 10 eV) neutral atomic beams for surface modification studies is described that reproduces the flux of atomic oxygen in low Earth orbit. The beam is produced by the acceleration of plasma ions onto a negatively biased plate of high-Z metal; the ions are neutralized and reflected by the surface, retaining some fraction of their incident kinetic energy, forming a beam of atoms. The plasma is generated by a coaxial RF exciter which produces a magnetically-confined (4 kG) plasma column. At the end of the column, ions fall through the sheath to the plate, whose bias relative to the plasma can be varied to adjust the beam energy. The source provides a neutral flux approximately equal to 5 x 10(exp 16)/sq cm at a distance of 9 cm and a fluence approximately equal to 10(exp 20)/sq cm in five hours. The composition and energy of inert gas beams was diagnosed using a mass spectometer/energy analyzer. The energy spectra of the beams demonstrate energies in the range 5 to 15 eV, and qualitatively show expected dependences upon incident and reflecting atom species and potential drop. Samples of carbon film, carbon-based paint, Kapton, mylar, and teflon exposed to atomic O beams show erosion quite similar to that observed in orbit on the space shuttle

    Predicting Survival of East Texas Loblolly and Slash Pine Plantations Infected with Fusiform Rust

    Get PDF
    Repeated measurement during 1982-1992 of East Texas Pine Plantation Research Project permanent plots in loblolly( Pinus taedaL .) and slash( Pinus elliottii Engelm.) pine plantations throughout East Texas were used to develop equations for predicting the future number of trees per acre. A typical condition of East Texas pine plantations is the incidence of fusiform rust( Cronatrium quercuum [Berk.] Miyabe ex Shirai f. sp. fusiforme). A regression procedure for fitting nonlinear systems of equations was used to fit survival models that considered the possibility that trees with no rust galls on the stem could either (1) remain uninfected and alive, (2) become infected yet still alive or (3) die. For infected stem so, only two possible outcomes were considered in the model:(1) remain infected and alive or (2) die.Analyses of the differences between predicted and observed values indicated no adverse trends for either of the two species. Apparently the models do represent observed survival patterns.South J. Appl. For. 20(1):30-35

    Launch Procedures for Offshore Flights

    Get PDF
    The Linn-Benton Community College Space Exploration Team held two successful offshore high-altitude balloon launches from the deck of the research vessel Pacific Storm. The payload filmed the umbra casted by the total eclipse as it passed across the Oregon coastline on August 21, 2017. Assigning roles and having a set procedure made the launch process operate more efficiently. Approximately ten onshore launches were conducted to rehearse procedures in preparation for the launch. During these launches, members became more familiar with their roles and the roles of others on the team to prepare for any and all situations that may occur. Completing an offshore flight differs from a standard onshore launch given that the sea produces various weather conditions such as; sizable waves, increased chance of precipitation, higher wind speed, and the possibility of limited visibility. Seasickness, internet accessibility, and offshore communication are among other factors. A sudden change in wind direction caused a tear in the latex of the balloon which caused the payload to not achieve the desired altitude. The launch did not achieve 28,000 meters, however the team learned from its successes and failures, and anticipate that the next launch will be successful

    Characterization of a 5-eV neutral atomic oxygen beam facility

    Get PDF
    An experimental effort to characterize an existing 5-eV neutral atomic oxygen beam facility being developed at Princeton Plasma Physics Laboratory is described. This characterization effort includes atomic oxygen flux and flux distribution measurements using a catalytic probe, energy determination using a commercially designed quadrupole mass spectrometer (QMS), and the exposure of oxygen-sensitive materials in this beam facility. Also, comparisons were drawn between the reaction efficiencies of materials exposed in plasma ashers, and the reaction efficiencies previously estimated from space flight experiments. The results of this study show that the beam facility is capable of producing a directional beam of neutral atomic oxygen atoms with the needed flux and energy to simulate low Earth orbit (LEO) conditions for real time accelerated testing. The flux distribution in this facility is uniform to +/- 6 percent of the peak flux over a beam diameter of 6 cm

    Lifetime predictions for the Solar Maximum Mission (SMM) and San Marco spacecraft

    Get PDF
    Lifetime prediction techniques developed by the Goddard Space Flight Center (GSFC) Flight Dynamics Division (FDD) are described. These techniques were developed to predict the Solar Maximum Mission (SMM) spacecraft orbit, which is decaying due to atmospheric drag, with reentry predicted to occur before the end of 1989. Lifetime predictions were also performed for the Long Duration Exposure Facility (LDEF), which was deployed on the 1984 SMM repair mission and is scheduled for retrieval on another Space Transportation System (STS) mission later this year. Concepts used in the lifetime predictions were tested on the San Marco spacecraft, which reentered the Earth's atmosphere on December 6, 1988. Ephemerides predicting the orbit evolution of the San Marco spacecraft until reentry were generated over the final 90 days of the mission when the altitude was less than 380 kilometers. The errors in the predicted ephemerides are due to errors in the prediction of atmospheric density variations over the lifetime of the satellite. To model the time dependence of the atmospheric densities, predictions of the solar flux at the 10.7-centimeter wavelength were used in conjunction with Harris-Priester (HP) atmospheric density tables. Orbital state vectors, together with the spacecraft mass and area, are used as input to the Goddard Trajectory Determination System (GTDS). Propagations proceed in monthly segments, with the nominal atmospheric drag model scaled for each month according to the predicted monthly average value of F10.7. Calibration propagations are performed over a period of known orbital decay to obtain the effective ballistic coefficient. Progagations using plus or minus 2 sigma solar flux predictions are also generated to estimate the despersion in expected reentry dates. Definitive orbits are compared with these predictions as time expases. As updated vectors are received, these are also propagated to reentryto continually update the lifetime predictions

    Laboratory electron exposure of TSS-1 thermal control coating

    Get PDF
    RM400, a conductive thermal control coating, was developed for use on the exterior shell of the tethered satellite. Testing was performed by the Engineering Physics Division to quantify effects of the space environment on this coating and its conductive and optical properties. Included in this testing was exposure of RM400 to electrons with energies ranging from 0.1 to 1 keV, to simulate electrons accelerated from the ambient space plasma when the tethered satellite is fully deployed. During this testing, the coating was found to luminesce, and a prolonged exposure of the coating to high-energy electrons caused the coating to darken. This report describes the tests done to quantify the degradation of the thermal control properties caused by electron exposure and to measure the luminescence as a function of electron energy and current density to the satellite
    • …
    corecore