On the interpretation of the multicolour disc model for black hole candidates

We present a critical analysis of the usual interpretation of the multicolour disc model parameters for black hole candidates in terms of the inner radius and temperature of the accretion disc. Using a self-consistent model for the radiative transfer and the vertical temperature structure in a Shakura-Sunyaev disc, we simulate the observed disc spectra, taking into account doppler blurring and gravitational redshift, and fit them with multicolour models. We show not only that such a model systematically underestimates the value of the inner disc radius, but that when the accretion rate and/or the energy dissipated in the corona are allowed to change the inner edge of the disc, as inferred from the multicolour model, appears to move even when it is in fact fixed at the innermost stable orbit.Comment: 4 pages including 2 figures, accepted for publication in MNRA

Power Distribution for Cryogenic Instruments at 6-40K The James Webb Space Telescope Case

The Integrated Science Instrument Module (ISIM) of the James Webb Space Telescope (JWST) operates its instruments passively cooled at around 40 Kelvin (K), with a warm Instrument Electronic Compartment (IEC) at 300K attached to it. From the warm electronics all secondary signal and power harnesses have to bridge this 300-40K temperature difference and minimize the power dissipation and parasitic heat leak into the cold region. After an introduction of the ISIM with its instruments, the IEC with the electronics, and the harness architecture with a special radiator, this paper elaborates on the cryogenic wire selection and tests performed to establish current de-rating rules for different wire types. Finally failure modes are analyzed for critical instrument interfaces that could inject excessive currents and heat into the harness and cold side, and several solutions for the removal of such failures are presented

Fast and accurate frequency-dependent radiation transport for hydrodynamics simulations in massive star formation

Context: Radiative feedback plays a crucial role in the formation of massive stars. The implementation of a fast and accurate description of the proceeding thermodynamics in pre-stellar cores and evolving accretion disks is therefore a main effort in current hydrodynamics simulations. Aims: We introduce our newly implemented three-dimensional frequency dependent radiation transport algorithm for hydrodynamics simulations of spatial configurations with a dominant central source. Methods: The module combines the advantage of the speed of an approximate Flux Limited Diffusion (FLD) solver with the high accuracy of a frequency dependent first order ray-tracing routine. Results: We prove the viability of the scheme in a standard radiation benchmark test compared to a full frequency dependent Monte-Carlo based radiative transfer code. The setup includes a central star, a circumstellar flared disk, as well as an envelope. The test is performed for different optical depths. Considering the frequency dependence of the stellar irradiation, the temperature distributions can be described precisely in the optically thin, thick, and irradiated transition regions. Resulting radiative forces onto dust grains are reproduced with high accuracy. The achievable parallel speedup of the method imposes no restriction on further radiative (magneto-) hydrodynamics simulations. Conclusions: The proposed approximate radiation transport method enables frequency dependent radiation hydrodynamics studies of the evolution of pre-stellar cores and circumstellar accretion disks around an evolving massive star in a highly efficient and accurate manner.Comment: 16 pages, 11 figure

Multi-Wavelength Variability of the Synchrotron Self-Compton Model for Blazar Emission

Motivated by recent reports of strongly correlated radio and X-ray variability in 3C279 (Grandi, etal 1995), we have computed the relative amplitudes of variations in the synchrotron flux at $\nu$ and the self-Compton X-ray flux at 1 keV ($R(\nu)$) for a homogeneous sphere of relativistic electrons orbiting in a tangled magnetic field. Relative to synchrotron self-Compton scattering without induced Compton scattering, stimulated scattering reduces the amplitude of $R(\nu)$ by as much as an order of magnitude when \tau_T \gtwid 1. When $\tau_T$ varies in a fixed magnetic field, $R_{\tau}$ increases monotonically from 0.01 at $\nu_o$, the self-absorption turnover frequency, to $0.5$ at $100 \nu_o$. The relative amplitudes of the correlated fluctuations in the radio-mm and X-ray fluxes from 3C279 are consistent with the synchrotron self-Compton model if $\tau_T$ varies in a fixed magnetic field and induced Compton scattering is the dominant source of radio opacity. The variation amplitudes are are too small to be produced by the passage of a shock through the synchrotron emission region unless the magnetic field is perpendicular to the shock front.Comment: 21 pages, 4 fig

On generation of Crab giant pulses

We propose that Crab giant pulses are generated on closed magnetic field lines near the light cylinder via anomalous cyclotron resonance on the ordinary mode. Waves are generated in a set of fine, unequally spaced, narrow emission bands at frequencies much lower than a local cyclotron frequency. Location of emission bands is fitted to spectral structures seen by Eilek et al. (2006). To reproduce the data, the required density of plasma in the giant pulses emission region is much higher, by a factor $\sim 3 \times 10^5$, than the minimal Goldreich-Julian density. Emission is generated by a population of highly energetic particles with radiation-limited Lorentz factors $\gamma \sim 7 \times 10^7$, produced during occasional reconnection close to the Y point, where the last closed field lines approach the light cylinder.Comment: accepted by MNRAS; added estimate of simultaneous GLAST signa

Vertical structure models of T Tauri and Herbig Ae/Be disks

In this paper we present detailed models of the vertical structure (temperature and density) of passive irradiated circumstellar disks around T Tauri and Herbig Ae/Be stars. In contrast to earlier work, we use full frequency- and angle-dependent radiative transfer instead of the usual moment equations. We find that this improvement of the radiative transfer has strong influence on the resulting vertical structure of the disk, with differences in temperature as large as 70 %. However, the spectral energy distribution (SED) is only mildly affected by this change. In fact, the SED compares reasonably well with that of improved versions of the Chiang & Goldreich (CG) model. This shows that the latter is a reasonable model for the SED, in spite of its simplicity. It also shows that from the SED alone, little can be learned about the vertical structure of a passive circumstellar disk. The molecular line emission from these disks is more sensitive to the vertical temperature and density structure, and we show as an example how the intensity and profiles of various CO lines depend on the adopted disk model. The models presented in this paper can also serve as the basis of theoretical studies of e.g. dust coagulation and settling in disks.Comment: 12 pages, 15 figures, accepted for publication in A&

Radiative Transfer in Obliquely Illuminated Accretion Disks

The illumination of an accretion disk around a black hole or neutron star by the central compact object or the disk itself often determines its spectrum, stability, and dynamics. The transport of radiation within the disk is in general a multi-dimensional, non-axisymmetric problem, which is challenging to solve. Here, I present a method of decomposing the radiative transfer equation that describes absorption, emission, and Compton scattering in an obliquely illuminated disk into a set of four one-dimensional transfer equations. I show that the exact calculation of the ionization balance and radiation heating of the accretion disk requires the solution of only one of the one-dimensional equations, which can be solved using existing numerical methods. I present a variant of the Feautrier method for solving the full set of equations, which accounts for the fact that the scattering kernels in the individual transfer equations are not forward-backward symmetric. I then apply this method in calculating the albedo of a cold, geometrically thin accretion disk.Comment: 16 pages, 3 figures; to appear in The Astrophysical Journa

Quasar bolometric corrections: theoretical considerations

Bolometric corrections based on the optical-to-ultraviolet continuum spectrum of quasars are widely used to quantify their radiative output, although such estimates are affected by a myriad of uncertainties, such as the generally unknown line-of-sight angle to the central engine. In order to shed light on these issues, we investigate the state-of-the-art models of Hubeny et al. that describe the continuum spectrum of thin accretion discs and include relativistic effects. We explore the bolometric corrections as a function of mass accretion rates, black hole masses and viewing angles, restricted to the parameter space expected for type-1 quasars. We find that a nonlinear relationship log L_bol=A + B log(lambda L_lambda) with B<=0.9 is favoured by the models and becomes tighter as the wavelength decreases. We calculate from the model the bolometric corrections corresponding to the wavelengths lambda = 1450A, 3000A and 5100A. In particular, for lambda=3000A we find A=9.24 +- 0.77 and B=0.81 +- 0.02. We demonstrate that the often-made assumption that quasars emit isotropically may lead to severe systematic errors in the determination of L_bol, when using the method of integrating the "big blue bump" spectrum. For a typical viewing angle of ~30 degrees to the quasar central engine, we obtain that the value of L_bol resulting from the isotropy assumption has a systematic error of ~30% high compared to the value of L_bol which incorporates the anisotropic emission of the accretion disc. These results are of direct relevance to observational determinations of the bolometric luminosities of quasars, and may be used to improve such estimates.Comment: 9 pages, 11 figures, accepted for publication in MNRA