Circularly polarized topological edge states derived from optical Weyl points in semiconductor-based chiral woodpile photonic crystals

The polarizations of topological edge modes in the vicinity of optical Weyl points were numerically studied in chiral photonic crystals. We investigated two kinds of rotationally stacked woodpile structures in which planar rod arrays were vertically stacked one-by-one with an in-plane rotation angle of 60 or 45 degrees. Both structures showed pairs of optical Weyl points having topological numbers of opposite signs for photonic bands in low orders. Topological edge states derived from the Weyl points appeared below the light line, and were strongly confined at the air interfaces in a length shorter than the wavelength. Their polarizations in a direction perpendicular to the propagation direction were found to be one particular circular polarization that depended on the handedness of the structural chirality. Since these chiral photonic crystals can be fabricated using semiconductor materials such as GaAs or Si, the obtained robust planar waveguides for circularly polarized light at the interface between air and the semiconductor structure can be useful not only in photonics but also in spintronics or quantum information technology through spin-photon interfaces

Transmission properties of microwaves at an optical Weyl point in a three-dimensional chiral photonic crystal

Microwave transmission measurements were performed for a three-dimensional (3D) layer-by-layer chiral photonic crystal (PhC), whose photonic band structure contains 3D singular points, Weyl points. For the frequency and wavevector in the vicinity of a Weyl point, the transmitted intensity was found to be inversely proportional to the square of the propagation length. In addition, the transmitted wave was well-collimated in the plane parallel to the PhC layers, even for point-source incidence. When a plane wave was incident on the PhC containing metal scatters, the planar wavefront was reconstructed after the transmission, indicating a cloaking effect

High-Q nanocavities in semiconductor-based three-dimensional photonic crystals

We experimentally demonstrated high quality factors (Q-factors) of nanocavities in three-dimensional photonic crystals by increasing the in-plane area of the structure. Entire structures made of GaAs were fabricated by a micro-manipulation technique, and the nanocavities contained InAs self-assembled quantum dots that emitted near-infrared light. The obtained Q-factor was improved to 93,000, which is 2.4-times larger than that in a previous report of a three-dimensional photonic crystal nanocavity. Due to this large Q-factor, we successfully observed a lasing oscillation from this cavity mode

The 2014 alma long baseline campaign: An overview

A major goal of the Atacama Large Millimeter/submillimeter Array (ALMA) is to make accurate images with resolutions of tens of milliarcseconds, which at submillimeter (submm) wavelengths requires baselines up to ~15 km. To develop and test this capability, a Long Baseline Campaign (LBC) was carried out from 2014 September to late November, culminating in end-to-end observations, calibrations, and imaging of selected Science Verification (SV) targets. This paper presents an overview of the campaign and its main results, including an investigation of the short-term coherence properties and systematic phase errors over the long baselines at the ALMA site, a summary of the SV targets and observations, and recommendations for science observing strategies at long baselines. Deep ALMA images of the quasar 3C 138 at 97 and 241 GHz are also compared to VLA 43 GHz results, demonstrating an agreement at a level of a few percent. As a result of the extensive program of LBC testing, the highly successful SV imaging at long baselines achieved angular resolutions as fine as 19 mas at ~350 GHz. Observing with ALMA on baselines of up to 15 km is now possible, and opens up new parameter space for submm astronomy