Thickness-Dependent Hydrophobicity of Epitaxial Graphene

This article addresses the much debated question whether the degree of hydrophobicity of single-layer graphene (1LG) is different from that of double-layer graphene (2LG). Knowledge of the water affinity of graphene and its spatial variations is critically important as it can affect the graphene properties as well as the performance of graphene devices exposed to humidity. By employing chemical force microscopy with a probe rendered hydrophobic by functionalization with octadecyltrichlorosilane (OTS), the adhesion force between the probe and epitaxial graphene on SiC has been measured in deionized water. Owing to the hydrophobic attraction, a larger adhesion force was measured on 2LG Bernal-stacked domains of graphene surfaces, thus showing that 2LG is more hydrophobic than 1LG. Identification of 1LG and 2LG domains was achieved through Kelvin probe force microscopy and Raman spectral mapping. Approximate values of the adhesion force per OTS molecule have been calculated through contact area analysis. Furthermore, the contrast of friction force images measured in contact mode was reversed to the 1LG/2LG adhesion contrast, and its origin was discussed in terms of the likely water depletion over hydrophobic domains as well as deformation in the contact area between the atomic force microscope tip and 1LG

Graphene quantum dot bolometer camera: practical approaches and preliminary results

Graphene is an exciting candidate for the detection of high-frequency electromagnetic radiation. Here, we have studied the bolometric performance of epitaxial graphene quantum dots (Q.D.s) on the silicon carbide (SiC) substrate in the terahertz (THz) range. The graphene Q.D. having a diameter in the 200 nm range, exhibited an extremely high resistance variation with temperature up to 4.7 MΩ K-1, a crucial parameter for the hot electron bolometers. The graphene Q.D.s bolometers have been fabricated in different geometrical configurations, such as variations in electrode spacing (2.5 and 5.0 μm) and parallelly connected arrays of 4 and 8 Q.D.s. It is demonstrated that the absorbed power can be improved by tuning the bolometer geometrical configuration and the active graphene area, and the electrical responsivity is still very high for an extensive range of absorbed power. Additionally, we report that the photo response of graphene Q.D. bolometer devices is meagerly affected by the presence of a magnetic field as high as 15 T. The results presented here open ways to continue to optimize and realize the chip-scale matrix of the graphene Q.D.s bolometers for THz imaging and magneto-optical spectroscopy applications

Conductance Anisotropy in Epitaxial Graphene Sheets Generated by Substrate Interactions

We present the first microscopic transport study of epitaxial graphene on SiC using an ultrahigh vacuum four-probe scanning tunneling microscope. Anisotropic conductivity is observed that is caused by the interaction between the graphene and the underlying substrate. These results can be explained by a model where charge buildup at the step edges leads to local scattering of charge carriers. This highlights the importance of considering substrate effects in proposed devices that utilize nanoscale patterning of graphene on electrically isolated substrates

Plasmon-Enhanced Terahertz Photodetection in Graphene

We report a large area terahertz detector utilizing a tunable plasmonic resonance in subwavelength graphene microribbons on SiC(0001) to increase the absorption efficiency. By tailoring the orientation of the graphene ribbons with respect to an array of subwavelength bimetallic electrodes, we achieve a condition in which the plasmonic mode can be efficiently excited by an incident wave polarized perpendicular to the electrode array, while the resulting photothermal voltage can be observed between the outermost electrodes

Plasmon-Enhanced Terahertz Photodetection in Graphene

We report a large area terahertz detector utilizing a tunable plasmonic resonance in subwavelength graphene microribbons on SiC(0001) to increase the absorption efficiency. By tailoring the orientation of the graphene ribbons with respect to an array of subwavelength bimetallic electrodes, we achieve a condition in which the plasmonic mode can be efficiently excited by an incident wave polarized perpendicular to the electrode array, while the resulting photothermal voltage can be observed between the outermost electrodes

Strong transient magnetic fields induced by THz-driven plasmons in graphene disks

Strong circularly polarized excitation opens up the possibility to generate and control effective magnetic fields in solid state systems, e.g., via the optical inverse Faraday effect or the phonon inverse Faraday effect. While these effects rely on material properties that can be tailored only to a limited degree, plasmonic resonances can be fully controlled by choosing proper dimensions and carrier concentrations. Plasmon resonances provide new degrees of freedom that can be used to tune or enhance the light-induced magnetic field in engineered metamaterials. Here we employ graphene disks to demonstrate light-induced transient magnetic fields from a plasmonic circular current with extremely high efficiency. The effective magnetic field at the plasmon resonance frequency of the graphene disks (3.5 THz) is evidenced by a strong (~1{\deg}) ultrafast Faraday rotation (~ 20 ps). In accordance with reference measurements and simulations, we estimated the strength of the induced magnetic field to be on the order of 0.7 T under a moderate pump fluence of about 440 nJ cm-2

Correlating Raman Spectral Signatures with Carrier Mobility in Epitaxial Graphene: A Guide to Achieving High Mobility on the Wafer Scale

We report a direct correlation between carrier mobility and Raman topography of epitaxial graphene (EG) grown on silicon carbide (SiC). We show the Hall mobility of material on SiC(0001) is highly dependent on thickness and monolayer strain uniformity. Additionally, we achieve high mobility epitaxial graphene (18100 cm2/(V s) at room temperature) on SiC(0001̅) and show that carrier mobility depends strongly on the graphene layer stacking

DataSheet1_Quasi-freestanding AA-stacked bilayer graphene induced by calcium intercalation of the graphene-silicon carbide interface.pdf

We study quasi-freestanding bilayer graphene on silicon carbide intercalated by calcium. The intercalation, and subsequent changes to the system, were investigated by low-energy electron diffraction, angle-resolved photoemission spectroscopy (ARPES) and density-functional theory (DFT). Calcium is found to intercalate only at the graphene-SiC interface, completely displacing the hydrogen terminating SiC. As a consequence, the system becomes highly n-doped. Comparison to DFT calculations shows that the band dispersion, as determined by ARPES, deviates from the band structure expected for Bernal-stacked bilayer graphene. Instead, the electronic structure closely matches AA-stacked bilayer graphene on calcium-terminated SiC, indicating a spontaneous transition from AB- to AA-stacked bilayer graphene following calcium intercalation of the underlying graphene-SiC interface.</p

Technique for the Dry Transfer of Epitaxial Graphene onto Arbitrary Substrates

To make graphene technologically viable, the transfer of graphene films to substrates appropriate for specific applications is required. We demonstrate the dry transfer of epitaxial graphene (EG) from the C-face of 4H-SiC onto SiO2, GaN and Al2O3 substrates using a thermal release tape. Subsequent Hall effect measurements illustrated that minimal degradation in the carrier mobility was induced following the transfer process in lithographically patterned devices. Correspondingly, a large drop in the carrier concentration was observed following the transfer process, supporting the notion that a gradient in the carrier density is present in C-face EG, with lower values being observed in layers further removed from the SiC interface. X-ray photoemission spectra collected from EG films attached to the transfer tape revealed the presence of atomic Si within the EG layers, which may indicate the identity of the unknown intrinsic dopant in EG. Finally, this transfer process is shown to enable EG films amenable for use in device fabrication on arbitrary substrates and films that are deemed most beneficial to carrier transport, as flexible electronic devices or optically transparent contacts