An inter-laboratory comparative study of fluoride determination in water

South Africa is on the brink of implementation of mandatory fluoridation of municipal water following the final approval by Parliament in 2001. The ability to accurately measure fluoride in water is an obvious prerequisite for the safe and effective implementation of water fluoridation. This paper evaluates the current status of fluoride determination in water in South Africa. The study was undertaken by the University of Johannesburg in collaboration with the South African Bureau of Standards as part of their ongoing Water-Check Programme. River water, borehole water, and synthetic water samples were sent to 66 participating laboratories in South Africa in March 2004. The results obtained from the analysis of 7 fluoride-containing samples with varying matrix composition, show that 50% of the laboratories could achieve results that fall between a lower limit of -20% and an upper limit of +20% relative to the true value. The precision (%RSD) for the determination of samples with fluoride concentration at the important level below 0.5 mg/ℓ was poor, ranging from ±20% at 0.5 mg/ℓ to ±100% at 0.1 mg/ℓ. The two major analytical techniques used by the participating South African laboratories were ISE (40%) and IC (36%).. Water SA Vol.32 (3) 2006: pp.365-37

Fresh and sea water immersion corrosion testing on marine structural steel at low temperature

The aim of the present study is to experimentally examine the corrosion progress characteristics of steel associated with fresh and sea water immersion at low temperature. Three types of steel, namely mild steel (Grade A) and high tensile steel (Grades A and D) are tested under various corrosive conditions in the fresh water, in the sea water and in the air at a temperature of 18°C, 0°C and −10°C. Mass loss of test specimen due to corrosion is measured at a monthly interval and it is converted to a loss of steel plate thickness. Based on the test database, the effects of parameters affecting the corrosion progress are discussed. Test database obtained in the present study is documented

Reversible change in electrical and optical properties in epitaxially grown Al-doped ZnO thin films

Aluminum-doped ZnO (AZO) films were epitaxially grown on sapphire (0001) substrates using pulsed laser deposition. As-deposited AZO films had a low resistivity of 8.01× 10-4 Ω cm. However, after annealing at 450 °C in air, the electrical resistivity of the AZO films increased to 1.97× 10-1 Ω cm because of a decrease in the carrier concentration. Subsequent annealing of the air-annealed AZO films in H2 recovered the electrical conductivity of the AZO films. In addition, the conductivity change was reversible upon repeated air and H2 annealing. A photoluminescence study showed that oxygen interstitial (Oi′) is a critical material parameter allowing for the reversible control of the electrical conducting properties of AZO films. © 2008 American Institute of Physics

Selectively tunable optical Stark effect of anisotropic excitons in atomically thin ReS2

The optical Stark effect is a coherent light-matter interaction describing the modification of quantum states by non-resonant light illumination in atoms, solids and nanostructures. Researchers have strived to utilize this effect to control exciton states, aiming to realize ultra-high-speed optical switches and modulators. However, most studies have focused on the optical Stark effect of only the lowest exciton state due to lack of energy selectivity, resulting in low degree-of-freedom devices. Here, by applying a linearly polarized laser pulse to few-layer ReS2, where reduced symmetry leads to strong in-plane anisotropy of excitons, we control the optical Stark shift of two energetically separated exciton states. Especially, we selectively tune the Stark effect of an individual state with varying light polarization. This is possible because each state has a completely distinct dependence on light polarization due to different excitonic transition dipole moments. Our finding provides a methodology for energy-selective control of exciton states.111612Ysciescopu

Influence of ambient water intrusion on coral reef acidification in the Chuuk lagoon, located in the coral-rich western Pacific Ocean

Weekly carbonate chemistry condition data recorded between 2008 and 2014 in the Chuuk lagoon (7.3 degrees N and 151.5 degrees E) of the Federated States of Micronesia, located in the western Pacific Ocean, were analyzed. The results showed that, during periods of weak intrusion of ambient seawater from the surrounding open ocean, two internal biological processes (calcification and respiration) reinforced each other and together lowered the pH of the reef water for extended periods, ranging from a few to several months. The analysis indicated that reduced intrusion of ambient water is associated with periods of low wind speeds. Such conditions increase the residence time of reef water, thus promoting acidification by respiration and calcification. This phenomenon likely affects many other areas of the coral-rich western Pacific Ocean, which contains 50% of global coral reefs and in which the degree of ambient water intrusion into the atolls has been shown to be closely associated with the El Nino-Southern Oscillation-induced wind speed change.1111Ysciescopu

Seed-layer mediated orientation evolution in dielectric Bi-Zn-Ti-Nb-O thin films

Highly (hhh) -oriented pyrochlore Bi-Zn-Ti-Nb-O (BZTN) thin films were fabricated via metal-organic decomposition using orientation template layers. The preferred orientation was ascribed to the interfacial layer, the lattice parameter of which is similar to BZTN. High-resolution transmission electron microscopy supported that the interfacial layer consists of Bi and Pt. The (hhh) -oriented thin films exhibited a highly insulating nature enabling feasible applications in electronic devices, particularly voltage tunable application. The BZTN thin films did not show any apparent dielectric anisotropy and the slightly enhanced dielectric properties were discussed in connection to the internal stress and the grain boundary effect. © 2007 American Institute of Physics

Structure and dielectric properties of cubic Bi<inf>2</inf>(Zn <inf>1/3</inf>Ta<inf>2/3</inf>)<inf>2</inf> O<inf>7</inf> thin films

Pyrochlore Bi2(Zn1/3Ta2/3)2 O7 (BZT) films were prepared by pulsed laser deposition on Pt/TiO2/SiO2/Si substrates. In contrast to bulk monoclinic BZT ceramics, the BZT films have a cubic structure mediated by an interfacial layer. The dielectric properties of the cubic BZT films [ε∼177, temperature coefficient of capacitance (TCC) ∼-170 ppm/°C] are much different from those of monoclinic BZT ceramics (ε∼61, TCC ∼+60 ppm/°C). Increasing the thickness of the BZT films returns the crystal structure to the monoclinic phase, which allows the dielectric properties of the BZT films to be tuned without changing their chemical composition. © 2009 American Institute of Physics

Deformation of the Fermi surface in the extended Hubbard model

The deformation of the Fermi surface induced by Coulomb interactions is investigated in the t-t'-Hubbard model. The interplay of the local U and extended V interactions is analyzed. It is found that exchange interactions V enhance small anisotropies producing deformations of the Fermi surface which break the point group symmetry of the square lattice at the Van Hove filling. This Pomeranchuck instability competes with ferromagnetism and is suppressed at a critical value of U(V). The interaction V renormalizes the t' parameter to smaller values what favours nesting. It also induces changes on the topology of the Fermi surface which can go from hole to electron-like what may explain recent ARPES experiments.Comment: 5 pages, 4 ps figure

Pyrosequencing Revealed SAR116 Clade as Dominant dddP-Containing Bacteria in Oligotrophic NW Pacific Ocean

Dimethyl sulfide (DMS) is a climatically active gas released into the atmosphere from oceans. It is produced mainly by bacterial enzymatic cleavage of dimethylsulfoniopropionate (DMSP), and six DMSP lyases have been identified to date. To determine the biogeographical distribution of bacteria relevant to DMS production, we investigated the diversity of dddP-the most abundant DMS-producing gene-in the northwestern Pacific Ocean using newly developed primers and the pyrosequencing method. Consistent with previous studies, the major dddP-containing bacteria in coastal areas were those belonging to the Roseobacter clade. However, genotypes closely related to the SAR116 group were found to represent a large portion of dddP-containing bacteria in the surface waters of the oligotrophic ocean. The addition of DMSP to a culture of the SAR116 strain Candidatus Puniceispirillum marinum IMCC1322 resulted in the production of DMS and upregulated expression of the dddP gene. Considering the large area of oligotrophic water and the wide distribution of the SAR116 group in oceans worldwide, we propose that these bacteria may play an important role in oceanic DMS production and biogeochemical sulfur cycles, especially via bacteriamediated DMSP degradation.open1178sciescopu