Photoelectrochemical water splitting: silicon photocathodes for hydrogen evolution

The development of low cost, scalable, renewable energy technologies is one of today's most pressing scientific challenges. We report on progress towards the development of a photoelectrochemical water-splitting system that will use sunlight and water as the inputs to produce renewable hydrogen with oxygen as a by-product. This system is based on the design principle of incorporating two separate, photosensitive inorganic semiconductor/liquid junctions to collectively generate the 1.7-1.9 V at open circuit needed to support both the oxidation of H_2O (or OH^-) and the reduction of H^+ (or H_2O). Si microwire arrays are a promising photocathode material because the high aspect-ratio electrode architecture allows for the use of low cost, earth-abundant materials without sacrificing energy-conversion efficiency, due to the orthogonalization of light absorption and charge-carrier collection. Additionally, the high surfacearea design of the rod-based semiconductor array inherently lowers the flux of charge carriers over the rod array surface relative to the projected geometric surface of the photoelectrode, thus lowering the photocurrent density at the solid/liquid junction and thereby relaxing the demands on the activity (and cost) of any electrocatalysts. Arrays of Si microwires grown using the Vapor Liquid Solid (VLS) mechanism have been shown to have desirable electronic light absorption properties. We have demonstrated that these arrays can be coated with earth-abundant metallic catalysts and used for photoelectrochemical production of hydrogen. This development is a step towards the demonstration of a complete artificial photosynthetic system, composed of only inexpensive, earth-abundant materials, that is simultaneously efficient, durable, and scalable

Solar Water Splitting Cells

No abstract

Evaluation of Pt, Ni, and Ni–Mo electrocatalysts for hydrogen evolution on crystalline Si electrodes

The dark electrocatalytic and light photocathodic hydrogen evolution properties of Ni, Ni–Mo alloys, and Pt on Si electrodes have been measured, to assess the viability of earth-abundant electrocatalysts for integrated, semiconductor coupled fuel formation. In the dark, the activities of these catalysts deposited on degenerately doped p^+-Si electrodes increased in the order Ni < Ni–Mo ≤ Pt. Ni–Mo deposited on degenerately doped Si microwires exhibited activity that was very similar to that of Pt deposited by metal evaporation on planar Si electrodes. Under 100 mW cm^(−2) of Air Mass 1.5 solar simulation, the energy conversion efficiencies of p-type Si/catalyst photoelectrodes ranged from 0.2–1%, and increased in the order Ni ≈ Ni–Mo < Pt, due to somewhat lower photovoltages and photocurrents for p-Si/Ni–Mo relative to p-Si/Ni and p-Si/Pt photoelectrodes. Deposition of the catalysts onto microwire arrays resulted in higher apparent catalytic activities and similar photoelectrode efficiencies than were observed on planar p-Si photocathodes, despite lower light absorption by p-Si in the microwire structures

Hydrogen-evolution characteristics of Ni–Mo-coated, radial junction, n+p-silicon microwire array photocathodes

The photocathodic H_2-evolution performance of Ni–Mo-coated radial n+p junction Si microwire (Si MW) arrays has been evaluated on the basis of thermodynamic energy-conversion efficiency as well as solar cell figures of merit. The Ni–Mo-coated n^(+)p-Si MW electrodes yielded open-circuit photovoltages (V_oc) of 0.46 V, short-circuit photocurrent densities (J_sc) of 9.1 mA cm^(−2), and thermodynamically based energy-conversion efficiencies (η) of 1.9% under simulated 1 Sun illumination. Under nominally the same conditions, the efficiency of the Ni–Mo-coated system was comparable to that of Pt-coated n+p-Si MW array photocathodes (V_oc = 0.44 V, J_sc = 13.2 mA cm^(−2_, η = 2.7%). This demonstrates that, at 1 Sun light intensity on high surface area microwire arrays, earth-abundant electrocatalysts can provide performance comparable to noble-metal catalysts for photoelectrochemical hydrogen evolution. The formation of an emitter layer on the microwires yielded significant improvements in the open-circuit voltage of the microwire-array-based photocathodes relative to Si MW arrays that did not have a buried n^(+)p junction. Analysis of the spectral response and light-intensity dependence of these devices allowed for optimization of the catalyst loading and photocurrent density. The microwire arrays were also removed from the substrate to create flexible, hydrogen-evolving membranes that have potential for use in a solar water-splitting device

Functional integration of Ni–Mo electrocatalysts with Si microwire array photocathodes to simultaneously achieve high fill factors and light-limited photocurrent densities for solar-driven hydrogen evolution

An n+p-Si microwire array coupled with a two-layer catalyst film consisting of Ni–Mo nanopowder and TiO_2 light-scattering nanoparticles has been used to simultaneously achieve high fill factors and light-limited photocurrent densities from photocathodes that produce H_2(g) directly from sunlight and water. The TiO_2 layer scattered light back into the Si microwire array, while optically obscuring the underlying Ni–Mo catalyst film. In turn, the Ni–Mo film had a mass loading sufficient to produce high catalytic activity, on a geometric area basis, for the hydrogen-evolution reaction. The best-performing microwire array devices prepared in this work exhibited short-circuit photocurrent densities of −14.3 mA cm^(−2), photovoltages of 420 mV, and a fill factor of 0.48 under 1 Sun of simulated solar illumination, whereas the equivalent planar Ni–Mo-coated Si device, without TiO_2 scatterers, exhibited negligible photocurrent due to complete light blocking by the Ni–Mo catalyst layer

Photoelectrochemical Hydrogen Evolution Using Si Microwire Arrays

Arrays of B-doped p-Si microwires, diffusion-doped with P to form a radial n+ emitter and subsequently coated with a 1.5-nm-thick discontinuous film of evaporated Pt, were used as photocathodes for H_2 evolution from water. These electrodes yielded thermodynamically based energy-conversion efficiencies >5% under 1 sun solar simulation, despite absorbing less than 50% of the above-band-gap incident photons. Analogous p-Si wire-array electrodes yielded efficiencies <0.2%, largely limited by the low photovoltage generated at the p-Si/H_2O junction

Hydrogen Evolution from Pt/Ru-Coated p-Type WSe_2 Photocathodes

Crystalline p-type WSe_2 has been grown by a chemical vapor transport method. After deposition of noble metal catalysts, p-WSe_2 photocathodes exhibited thermodynamically based photoelectrode energy-conversion efficiencies of >7% for the hydrogen evolution reaction under mildly acidic conditions, and were stable under cathodic conditions for at least 2 h in acidic as well as in alkaline electrolytes. The open circuit potentials of the photoelectrodes in contact with the H^(+)/H_2 redox couple were very close to the bulk recombination/diffusion limit predicted from the Shockley diode equation. Only crystals with a prevalence of surface step edges exhibited a shift in flat-band potential as the pH was varied. Spectral response data indicated effective minority-carrier diffusion lengths of ~1 μm, which limited the attainable photocurrent densities in the samples to ~15 mA cm^(–2) under 100 mW cm^(–2) of Air Mass 1.5G illumination

Nanostructured Nickel Phosphide as an Electrocatalyst for the Hydrogen Evolution Reaction

Nanoparticles of nickel phosphide (Ni_2P) have been investigated for electrocatalytic activity and stability for the hydrogen evolution reaction (HER) in acidic solutions, under which proton exchange membrane-based electrolysis is operational. The catalytically active Ni_2P nanoparticles were hollow and faceted to expose a high density of the Ni_2P(001) surface, which has previously been predicted based on theory to be an active HER catalyst. The Ni2P nanoparticles had among the highest HER activity of any non-noble metal electrocatalyst reported to date, producing H_2(g) with nearly quantitative faradaic yield, while also affording stability in aqueous acidic media

Earth-abundant hydrogen evolution electrocatalysts

Splitting water to hydrogen and oxygen is a promising approach for storing energy from intermittent renewables, such as solar power. Efficient, scalable solar-driven electrolysis devices require active electrocatalysts made from earth-abundant elements. In this mini-review, we discuss recent investigations of homogeneous and heterogeneous hydrogen evolution electrocatalysts, with emphasis on our own work on cobalt and iron complexes and nickel-molybdenum alloys

Restoring Cystic Fibrosis Transmembrane Conductance Regulator Function Reduces Airway Bacteria and Inflammation in People with Cystic Fibrosis and Chronic Lung Infections

Rationale: Previous work indicates that ivacaftor improves cystic fibrosis transmembrane conductance regulator (CFTR) activity and lung function in people with cystic fibrosis and G551D-CFTR mutations but does not reduce density of bacteria or markers of inflammation in the airway. These findings raise the possibility that infection and inflammation may progress independently of CFTR activity once cystic fibrosis lung disease is established. Objectives: To better understand the relationship between CFTR activity, airway microbiology and inflammation, and lung function in subjects with cystic fibrosis and chronic airway infections. Methods: We studied 12 subjects with G551D-CFTR mutations and chronic airway infections before and after ivacaftor. We measured lung function, sputum bacterial content, and inflammation, and obtained chest computed tomography scans. Measurements and Main Results: Ivacaftor produced rapid decreases in sputum Pseudomonas aeruginosa density that began within 48 hours and continued in the first year of treatment. However, no subject eradicated their infecting P. aeruginosa strain, and after the first year P. aeruginosa densities rebounded. Sputum total bacterial concentrations also decreased, but less than P. aeruginosa. Sputum inflammatory measures decreased significantly in the first week of treatment and continued to decline over 2 years. Computed tomography scans obtained before and 1 year after ivacaftor treatment revealed that ivacaftor decreased airway mucous plugging. Conclusions: Ivacaftor caused marked reductions in sputum P. aeruginosa density and airway inflammation and produced modest improvements in radiographic lung disease in subjects with G551D-CFTR mutations. However, P. aeruginosa airway infection persisted. Thus, measures that control infection may be required to realize the full benefits of CFTR-targeting treatments