Vibrational ratchets

Transport in a one-dimensional symmetric device can be activated by the combination of thermal noise and a bi-harmonic drive. For the study case of an overdamped Brownian particle diffusing on a periodic one-dimensional substrate, we distinguish two apparently different bi-harmonic regimes: (i) Harmonic mixing, where the two drive frequencies are commensurate and of the order of some intrinsic dynamical relaxation rate. A comparison of new simulation results with earlier theoretical predictions shows that the analytical understanding of this frequency mixing mechanism is not satisfactory, yet; (ii) Vibrational mixing, where one harmonic drive component is characterized by a high frequency but finite amplitude-to-frequency ratio. Its effect on the device response to either a static or a low-frequency additional input signal is accurately reproduced by rescaling each spatial Fourier component of the substrate potential, separately. Contrary to common wisdom based on the linear response theory, we show that extremely high-frequency modulations can indeed influence the response of slowly (or dc) operated devices, with potential applications in sensor technology and cellular physiology. Finally, the mixing of two high-frequency beating signal is also investigated both numerically and analytically.Comment: 8 pages, 9 figure

Recycled Noise Rectification: A Dumb Maxwell's Daemon

The one dimensional motion of a massless Brownian particle on a symmetric periodic substrate can be rectified by re-injecting its driving noise through a realistic recycling procedure. If the recycled noise is multiplicatively coupled to the substrate, the ensuing feed-back system works like a passive Maxwell's daemon, capable of inducing a net current that depends on both the delay and the autocorrelation times of the noise signals. Extensive numerical simulations show that the underlying rectification mechanism is a resonant nonlinear effect: The observed currents can be optimized for an appropriate choice of the recycling parameters with immediate application to the design of nanodevices for particle transport.Comment: 7 pages, 6 figure

Detectable inertial effects on Brownian transport through narrow pores

We investigate the transport of suspended Brownian particles dc driven along corrugated narrow channels in a regime of finite damping. We demonstrate that inertial corrections cannot be neglected as long as the width of the channel bottlenecks is smaller than an appropriate particle diffusion length, which depends on both, the temperature and the strength of the dc drive. Therefore, transport through sufficiently narrow constrictions turns out to be sensitive to the viscosity of the suspension fluid. Applications to colloidal systems are discussed

AC Driven Jumps Distribution on a Periodic Substrate

A driven Brownian particle (e.g. an adatom on a surface) diffusing on a low-viscosity, periodic substrate may execute multiple jumps. In the presence of an additional periodic drive, the jump lengths and time durations become statistically modulated according to a syncronyzation mechanism reminiscent of asymmetric stochastic resonance. Here, too, bistability plays a key role, but in a dynamical sense, inasmuch as a particle switches between locked and running states.Comment: 4 pages, 4 figures, RevTeX, to be published in Surface Science Letter

Temperature-resonant cyclotron spectra in confined geometries

We consider a two-dimensional gas of colliding charged particles confined to finite size containers of various geometries and subjected to a uniform orthogonal magnetic field. The gas spectral densities are characterized by a broad peak at the cyclotron frequency. Unlike for infinitely extended gases, where the amplitude of the cyclotron peak grows linearly with temperature, here confinement causes such a peak to go through a maximum for an optimal temperature. In view of the fluctuation-dissipation theorem, the reported resonance effect has a direct counterpart in the electric susceptibility of the confined magnetized gas

Deterministic ratchets: route to diffusive transport

The rectification efficiency of an underdamped ratchet operated in the adiabatic regime increases according to a scaling current-amplitude curve as the damping constant approaches a critical threshold; below threshold the rectified signal becomes extremely irregular and eventually its time average drops to zero. Periodic (locked) and diffusive (fully chaotic) trajectories coexist on fine tuning the amplitude of the input signal. The transition from regular to chaotic transport in noiseless ratchets is studied numerically.Comment: 9 pages, 5 figures, to be published in Phys. Rev.

Noise sustained propagation: Local versus global noise

We expand on prior results on noise supported signal propagation in arrays of coupled bistable elements. We present and compare experimental and numerical results for kink propagation under the influence of local and global fluctuations. As demonstrated previously for local noise, an optimum range of global noise power exists for which the medium acts as a reliable transmission ``channel''. We discuss implications for propagation failure in a model of cardiac tissue and present a general theoretical framework based on discrete kink statistics. Valid for generic bistable chains, the theory captures the essential features ob served in our experiments and numerical simulations.Comment: 1 latex file 20 pages, 9 figures. Accepted for publication in Physical Review

Superconducting Fluxon Pumps and Lenses

We study stochastic transport of fluxons in superconductors by alternating current (AC) rectification. Our simulated system provides a fluxon pump, "lens", or fluxon "rectifier" because the applied electrical AC is transformed into a net DC motion of fluxons. Thermal fluctuations and the asymmetry of the ratchet channel walls induce this "diode" effect, which can have important applications in devices, like SQUID magnetometers, and for fluxon optics, including convex and concave fluxon lenses. Certain features are unique to this novel two-dimensional (2D) geometric pump, and different from the previously studied 1D ratchets.Comment: Phys. Rev. Lett. 83, in press (1999); 4 pages, 5 .gif figures; figures also available at http://www-personal.engin.umich.edu/~nori/ratche

Brownian motors: current fluctuations and rectification efficiency

With this work we investigate an often neglected aspect of Brownian motor transport: The r\^{o}le of fluctuations of the noise-induced current and its consequences for the efficiency of rectifying noise. In doing so, we consider a Brownian inertial motor that is driven by an unbiased monochromatic, time-periodic force and thermal noise. Typically, we find that the asymptotic, time- and noise-averaged transport velocities are small, possessing rather broad velocity fluctuations. This implies a corresponding poor performance for the rectification power. However, for tailored profiles of the ratchet potential and appropriate drive parameters, we can identify a drastic enhancement of the rectification efficiency. This regime is marked by persistent, uni-directional motion of the Brownian motor with few back-turns, only. The corresponding asymmetric velocity distribution is then rather narrow, with a support that predominantly favors only one sign for the velocity.Comment: 9 pages, 4 figure

Interaction of molecular motors can enhance their efficiency

Particles moving in oscillating potential with broken mirror symmetry are considered. We calculate their energetic efficiency, when acting as molecular motors carrying a load against external force. It is shown that interaction between particles enhances the efficiency in wide range of parameters. Possible consequences for artificial molecular motors are discussed.Comment: 6 pages, 8 figure