10,618 research outputs found

    A computer program for calculating design and off-design performance for turbojet and turbofan engines

    Get PDF
    Program uses component performance maps to enable user to do analytical engine cycle calculations. Through scaling procedure, each of the component maps can be used to represent a family of maps. Either convergent or convergent-divergent nozzles may be used

    Preliminary QCGAT program test results

    Get PDF
    NASA Lewis Research Center is conducting a program to demonstrate that large commercial engine technology can be applied to general aviation engines to reduce noise, emissions and fuel consumption and to develop new technology where required. The overall engine program, design, and technology incorporated into the QCGAT engines are described. In addition, preliminary engine test results are presented and compared to the technical requirements the engines were designed to meet

    Comparative assessment of out-of-core nuclear thermionic power systems

    Get PDF
    The hardware selections available for fabrication of a nuclear electric propulsion stage for planetary exploration were explored. The investigation was centered around a heat-pipe-cooled, fast-spectrum nuclear reactor for an out-of-core power conversion system with sufficient detail for comparison with the in-core system studies completed previously. A survey of competing power conversion systems still indicated that the modular reliability of thermionic converters makes them the desirable choice to provide the 240-kWe end-of-life power for at least 20,000 full power hours. The electrical energy will be used to operate a number of mercury ion bombardment thrusters with a specific impulse in the range of about 4,000-5,000 seconds

    Performance of high-altitude, long-endurance, turboprop airplanes using conventional or cryogenic fuels

    Get PDF
    An analytical study has been conducted to evaluate the potential endurance of remotely piloted, low speed, high altitude, long endurance airplanes designed with 1990 technology. The baseline configuration was a propeller driven, sailplane like airplane powered by turbine engines that used JP-7, liquid methane, or liquid hydrogen as fuel. Endurance was measured as the time spent between 60,000 feet and an engine limited maximum altitude of 70,000 feet. Performance was calculated for a baseline vehicle and for configurations derived by varying aerodynamic, structural or propulsion parameters. Endurance is maximized by reducing wing loading and engine size. The level of maximum endurance for a given wing loading is virtually the same for all three fuels. Constraints due to winds aloft and propulsion system scaling produce maximum endurance values of 71 hours for JP-7 fuel, 70 hours for liquid methane, and 65 hours for liquid hydrogen. Endurance is shown to be strongly effected by structural weight fraction, specific fuel consumption, and fuel load. Listings of the computer program used in this study and sample cases are included in the report

    A computer program for calculating design and off-design performance of two- and three-spool turbofans with as many as three nozzles

    Get PDF
    Program uses component performance maps to enable user to do analytical engine cycle calculations. Either convergent or convergent-divergent nozzles may be used

    Religiousness and preoperative anxiety: a correlational study

    Get PDF
    <p>Abstract</p> <p>Background</p> <p>Major life changes are among factors that cause anxiety, and one of these changes is surgery. Emotional reactions to surgery have specific effects on the intensity and velocity as well as the process of physical disease. In addition, they can cause delay in patients recovery. This study is aimed at determining the relationship between religious beliefs and preoperative anxiety.</p> <p>Methods</p> <p>This survey is a correlational study to assess the relationship between religious beliefs and preoperative anxiety of patients undergoing abdominal, orthopaedic, and gynaecologic surgery in educational hospitals. We used the convenience sampling method. The data collection instruments included a questionnaire containing the Spielberger State-Trait Anxiety Inventory (STAI), and another questionnaire formulated by the researcher with queries on religious beliefs and demographic characteristics as well as disease-related information. Analysis of the data was carried out with SPSS software using descriptive and inferential statistics. Results were arranged in three tables.</p> <p>Results</p> <p>The findings showed that almost all the subjects had high level of religiosity and moderate level of anxiety. In addition, there was an inverse relationship between religiosity and intensity of anxiety, though this was not statistically significant.</p> <p>Conclusion</p> <p>The results of this study can be used as evidence for presenting religious counselling and spiritual interventions for individuals undergoing stress. Finally, based on the results of this study, the researcher suggested some recommendations for applying results and conducting further research.</p
    • …
    corecore