Search for dark matter produced in association with bottom or top quarks in √s = 13 TeV pp collisions with the ATLAS detector

A search for weakly interacting massive particle dark matter produced in association with bottom or top quarks is presented. Final states containing third-generation quarks and miss- ing transverse momentum are considered. The analysis uses 36.1 fb−1 of proton–proton collision data recorded by the ATLAS experiment at √s = 13 TeV in 2015 and 2016. No significant excess of events above the estimated backgrounds is observed. The results are in- terpreted in the framework of simplified models of spin-0 dark-matter mediators. For colour- neutral spin-0 mediators produced in association with top quarks and decaying into a pair of dark-matter particles, mediator masses below 50 GeV are excluded assuming a dark-matter candidate mass of 1 GeV and unitary couplings. For scalar and pseudoscalar mediators produced in association with bottom quarks, the search sets limits on the production cross- section of 300 times the predicted rate for mediators with masses between 10 and 50 GeV and assuming a dark-matter mass of 1 GeV and unitary coupling. Constraints on colour- charged scalar simplified models are also presented. Assuming a dark-matter particle mass of 35 GeV, mediator particles with mass below 1.1 TeV are excluded for couplings yielding a dark-matter relic density consistent with measurements

ATLAS tile calorimeter online software reorganization and phase-II test-beam campaigns

A thesis presented in fulfillment of the requirements for the degree of: Master of Science in Physics, University of the Witwatersrand, Johannesburg, 2017Tile Online software is a set of Trigger and Data Acquisition (TDAQ) required for the operation of Tile. It is built on top of ATLAS TDAQ software following AT LAS management tools and policies. The TDAQ software has been migrated from CMT to CMake, and from SVN to Git, in favor of modern software development tools and procedures. Since Tile Online software follows ATLAS TDAQ, there was a need of reorganization, simplification and clean-up of Tile Online software packages. Tile Online software packages have been migrated and reorganized to the newest ATLAS TDAQ release and the outcome is now used at Point-1 with success. The diagnostic and verification system (DVS) is part of the ATLAS TDAQ online software packages used for configuring and executing tests for TDAQ com ponents, and for advising recovery actions to the TDAQ operator/user. A wrapper way to start complex Tile DVS tests that required two separate programs to run on separate computers has been implemented and tests can now be run from a graphical user interface with detailed presentation of the results by non-experts. The upgrade of the Large Hadron Collider (LHC) to the High-Luminosity LHC will provide significant opportunities to explore new physics beyond the Standard Model. This however presents significant challenges to the detector and the TDAQ systems. The Tile Calorimeter will undergo upgrades whereby the current readout electronics will be completely redesigned and replaced in phase-II to cope with the increased luminosity imposed by the HL-LHC.XL201

Tests with beam setup of the TileCal Phase-II upgrade electronics

The LHC has planned a series of upgrades culminating in the High Luminosity LHC (HL-LHC) which will have an average luminosity 5-7 times larger than the nominal Run-2 value. The ATLAS Tile Calorimeter (TileCal) will undergo an upgrade to accommodate to the HL-LHC parameters. The TileCal electronics both on- and off-detector will be completely redesigned and a new readout architecture will be adopted. The photomultiplier signals will be digitised and transferred to the TileCal PreProcessors (PPr) located off-detector for every bunch crossing. Then, the PPr will provide preprocessed digital data to the first level trigger with improved spatial granularity and energy resolution with respect to the current analog trigger signals. We plan to insert one TileCal module instrumented with the new electronics in the real detector to evaluate and qualify the new readout and trigger concepts in the overall ATLAS data acquisition system. This new drawer, so-called Hybrid Demonstrator, must provide analog trigger signal for backwards compatibility with the current system. The 3in1 front-end option has been mounted in this Demonstrator which provides all the upgrade functionalities but maintaining the analog trigger signals. This Demonstrator drawer has been inserted in a TileCal module prototype to evaluate the operability and performance in the lab. In parallel, one more TileCal module has been instrumented with other two front-end electronics options based on custom ASICs (QIE and FATALIC) which are under evaluation. This two modules equipped with Phase-II upgrade electronics together with three modules equipped with the legacy system were exposed to different particles and energies in three test-beam campaigns during 2015 and 2016. This contribution will describe in detail the different components of the new readout electronics for the three options under evaluation. We will present the firmware and software developed explicitly for the tests with beam and we will show performance results for different types of particles as well as for calibration data

Study of energy response and resolution of the ATLAS Tile Calorimeter to hadrons of energies from 16 to 30 GeV

AbstractThree spare modules of the ATLAS Tile Calorimeter were exposed to test beams from the Super Proton Synchrotron accelerator at CERN in 2017. The detector’s measurements of the energy response and resolution to positive pions and kaons, and protons with energies ranging from 16 to 30 GeV are reported. The results have uncertainties of a few percent. They were compared to the predictions of the Geant4-based simulation program used in ATLAS to estimate the response of the detector to proton-proton events at the Large Hadron Collider. The determinations obtained using experimental and simulated data agree within the uncertainties.</jats:p

Study of energy response and resolution of the ATLAS Tile Calorimeter to hadrons of energies from 16 to 30 GeV

Three spare modules of the ATLAS Tile Calorimeter were exposed to test beams from the Super Proton Synchrotron accelerator at CERN in 2017. The detector&apos;s measurements of the energy response and resolution to positive pions and kaons, and protons with energies ranging from 16 to 30 GeV are reported. The results have uncertainties of a few percent. They were compared to the predictions of the Geant4-based simulation program used in ATLAS to estimate the response of the detector to proton-proton events at the Large Hadron Collider. The determinations obtained using experimental and simulated data agree within the uncertainties

Study of energy response and resolution of the ATLAS Tile Calorimeter to hadrons of energies from 16 to 30 GeV

International audienceThree spare modules of the ATLAS Tile Calorimeter were exposed to test beams from the Super Proton Synchrotron accelerator at CERN in 2017. The detector’s measurements of the energy response and resolution to positive pions and kaons, and protons with energies ranging from 16 to 30 GeV are reported. The results have uncertainties of a few percent. They were compared to the predictions of the Geant4-based simulation program used in ATLAS to estimate the response of the detector to proton-proton events at the Large Hadron Collider. The determinations obtained using experimental and simulated data agree within the uncertainties

Measurements of ttˉt\bar{t} differential cross-sections of highly boosted top quarks decaying to all-hadronic final states in pppp collisions at s=13 \sqrt{s}=13\, TeV using the ATLAS detector

Measurements are made of differential cross-sections of highly boosted pair-produced top quarks as a function of top-quark and $t\bar{t}$ system kinematic observables using proton--proton collisions at a center-of-mass energy of $\sqrt{s} = 13$ TeV. The data set corresponds to an integrated luminosity of $36.1$ fb$^{-1}$, recorded in 2015 and 2016 with the ATLAS detector at the CERN Large Hadron Collider. Events with two large-radius jets in the final state, one with transverse momentum $p_{\rm T} > 500$ GeV and a second with $p_{\rm T}>350$ GeV, are used for the measurement. The top-quark candidates are separated from the multijet background using jet substructure information and association with a $b$-tagged jet. The measured spectra are corrected for detector effects to a particle-level fiducial phase space and a parton-level limited phase space, and are compared to several Monte Carlo simulations by means of calculated $\chi^2$ values. The cross-section for $t\bar{t}$ production in the fiducial phase-space region is $292 \pm 7 \ \rm{(stat)} \pm 76 \rm{(syst)}$ fb, to be compared to the theoretical prediction of $384 \pm 36$ fb

Measurements of ttˉt\bar{t} differential cross-sections of highly boosted top quarks decaying to all-hadronic final states in pppp collisions at s=13 \sqrt{s}=13\, TeV using the ATLAS detector

Measurements are made of differential cross-sections of highly boosted pair-produced top quarks as a function of top-quark and $t\bar{t}$ system kinematic observables using proton--proton collisions at a center-of-mass energy of $\sqrt{s} = 13$ TeV. The data set corresponds to an integrated luminosity of $36.1$ fb$^{-1}$, recorded in 2015 and 2016 with the ATLAS detector at the CERN Large Hadron Collider. Events with two large-radius jets in the final state, one with transverse momentum $p_{\rm T} > 500$ GeV and a second with $p_{\rm T}>350$ GeV, are used for the measurement. The top-quark candidates are separated from the multijet background using jet substructure information and association with a $b$-tagged jet. The measured spectra are corrected for detector effects to a particle-level fiducial phase space and a parton-level limited phase space, and are compared to several Monte Carlo simulations by means of calculated $\chi^2$ values. The cross-section for $t\bar{t}$ production in the fiducial phase-space region is $292 \pm 7 \ \rm{(stat)} \pm 76 \rm{(syst)}$ fb, to be compared to the theoretical prediction of $384 \pm 36$ fb