2,655 research outputs found

    The order-disorder transition of the (3x3)Sn/Ge(111) phase

    Full text link
    Growing attention has been drawn in the past years to the \alpha-phase (1/3 monolayer) of Sn on Ge(111), which undergoes a transition from the low temperature (3x3) phase to the room temperature (\sqrt3 x \sqrt3)R30 one. On the basis of scanning tunnelling microscopy experiments, this transition was claimed to be the manifestation of a surface charge density wave (SCDW), i.e. a periodic redistribution of charge, possibly accompanied by a periodic lattice distortion, which determines a change of the surface symmetry. As further experiments with different techniques were being performed, increasing doubts were cast about the SCDW model. We have measured by He scattering the long range order of the 1/3 monolayer phase of Sn on the Ge(111) surface throughout the phase transition. The transition has been found of the order-disorder type with a critical temperature Tc=220 K. The expected 3-State Potts critical exponents are shown to be consistent with the observed power law dependence of the (3x3) order parameter and its correlation length close to Tc, thus excluding a charge density wave driven phase transition.Comment: 6 pages with 4 figures; updated reference

    Quantum size effects in the low temperature layer-by-layer growth of Pb on Ge(001)

    Full text link
    The electronic properties of thin metallic films deviate from the corresponding bulk ones when the film thickness is comparable with the wavelength of the electrons at the Fermi level due to quantum size effects (QSE). QSE are expected to affect the film morphology and structure leading to the low temperature (LT) ``electronic growth'' of metals on semiconductors. In particular, layer-by-layer growth of Pb(111) films has been reported for deposition on Ge(001) below 130 K. An extremely flat morphology is preserved throughout deposition from four up to a dozen of monolayers. These flat films are shown to be metastable and to reorganize into large clusters uncovering the first Pb layer, pseudomorphic to the substrate, already at room temperature. Indications of QSE induced structural variations of the growing films have been reported for Pb growth on Ge(001), where the apparent height of the Pb(111) monatomic step was shown to change in an oscillatory fashion by He atom scattering (HAS) during layer-by-layer growth. The extent of the structural QSE has been obtained by a comparison of the HAS data with X-ray diffraction (XRD) and reflectivity experiments. Whereas step height variations as large as 20 % have been measured by HAS reflectivity, the displacement of the atomic planes from their bulk position, as measured by XRD, has been found to mainly affect the topmost Pb layer, but with a lower extent, i.e. the QSE observed by HAS are mainly due to a perpendicular displacement of the topmost layer charge density. The effect of the variable surface relaxation on the surface vibration has been studied by inelastic HAS to measure the acoustic dispersion of the low energy phonons.Comment: 28 pages (laTex,elsart) and 13 figures (eps); updated reference

    Ouabain-induced cytoplasmic vesicles and their role in cell volume maintenance

    Get PDF
    Cellular swelling is controlled by an active mechanism of cell volume regulation driven by a Na+/K+-dependent ATPase and by aquaporins which translocate water along the osmotic gradient. Na+/K+-pump may be blocked by ouabain, a digitalic derivative, by inhibition of ATP, or by drastic ion alterations of extracellular fluid. However, it has been observed that some tissues are still able to control their volume despite the presence of ouabain, suggesting the existence of other mechanisms of cell volume control. In 1977, by correlating electron microscopy observation with ion and water composition of liver slices incubated in differentmetabolic conditions in the presence or absence of ouabain, we observed that hepatocytes were able to control their volume extruding water and recovering ion composition in the presence of ouabain. In particular, hepatocytes were able to sequester ions and water in intracellular vesicles and then secrete themat the bile canaliculus pole.We named this “vesicularmechanismof cell volume control.” Afterward, thismechanism has been confirmed by us and other laboratories in several mammalian tissues.This review summarizes evidences regarding this mechanism, problems that are still pending, and questions that need to be answered. Finally, we shortly review the importance of cell volume control in some human pathological conditions

    Study of the isotropic contribution to the analysis of photoelectron diffraction experiments at the ALOISA beamline

    Full text link
    The angular distribution of the intensity in photoemission experiments is affected by electron diffraction patterns and by a smoothly varying ISO contribution originated by both intrumental details and physical properties of the samples. The origin of the various contributions to the ISO component has been identified since many years. Nonetheless in this work we present original developement of the ED analysis, which arises from the evolution of instrumental performance, in terms of analyzers positioning and angular resolution, as well as collimation and size of X-ray beams in third generation synchrotron sources. The analytical treatement of the instrumental factors is presented in detail for the end station of the ALOISA beamline (Trieste Synchrotron), where a wide variety of scattering geometries is available for ED experiments. We present here the basic formulae and their application to experimental data taken on the Fe/Cu3Au(001) system in order to highlight the role of the various parameters included in the distribution function. A specific model for the surface illumination has been developed as well as the overlayer thickness and surface roughness have been considered.Comment: RevTex, nine pages with five eps figures; to be published in J. Electron Spectrosc. Relat. Pheno

    The pseudomorphic to bulk fcc phase transition of thin Ni films on Pd(100)

    Full text link
    We have measured the transformation of pseudomorphic Ni films on Pd(100) into their bulk fcc phase as a function of the film thickness. We made use of x-ray diffraction and x-ray induced photoemission to study the evolution of the Ni film and its interface with the substrate. The growth of a pseudomorphic film with tetragonally strained face centered symmetry (fct) has been observed by out-of-plane x-ray diffraction up to a maximum thickness of 10 Ni layers (two of them intermixed with the substrate), where a new fcc bulk-like phase is formed. After the formation of the bulk-like Ni domains, we observed the pseudomorphic fct domains to disappear preserving the number of layers and their spacing. The phase transition thus proceeds via lateral growth of the bulk-like phase within the pseudomorphic one, i.e. the bulk-like fcc domains penetrate down to the substrate when formed. This large depth of the walls separating the domains of different phases is also indicated by the strong increase of the intermixing at the substrate-film interface, which starts at the onset of the transition and continues at even larger thickness. The bulk-like fcc phase is also slightly strained; its relaxation towards the orthomorphic lattice structure proceeds slowly with the film thickness, being not yet completed at the maximum thickness presently studied of 30 Angstrom (i.e. about 17 layers).Comment: 8 pages, 7 figure

    Spectro-microscopy of single and multi-layer graphene supported by a weakly interacting substrate

    Full text link
    We report measurements of the electronic structure and surface morphology of exfoliated graphene on an insulating substrate using angle-resolved photoemission and low energy electron diffraction. Our results show that although exfoliated graphene is microscopically corrugated, the valence band retains a massless fermionic dispersion, with a Fermi velocity of ~10^6 m/s. We observe a close relationship between the morphology and electronic structure, which suggests that controlling the interaction between graphene and the supporting substrate is essential for graphene device applications.Comment: 10 pages of text, 4 JPEG figure

    The Planck Low Frequency Instrument

    Get PDF
    The Low Frequency Instrument (LFI) of the "Planck Surveyor" ESA mission will perform high-resolution imaging of the Cosmic Microwave Background anisotropies at four frequencies in the 30-100 GHz range. We review the LFI main scientific objectives, the current status of the instrument design and the on-going effort to develop software simulations of the LFI observations. In particular we discuss the design status of the PLANCK telescope, which is critical for reaching adequate effective angular resolution.Comment: 10 pages, Latex (use epsfig.sty); 4 Postscript figures; Astrophys. Lett & Comm, in press. Proc. of the Conference: "The Cosmic Microwave Background and the Planck Mission", Santander, Spain, 22-25 June 199

    Singlet-to-triplet conversion of metastable He atoms at alkali-metal overlayers

    Get PDF
    Energy distributions of electrons emitted from alkali-metal surfaces by impact of metastable He atoms reveal that there is a high probability for transformation of singlet atoms (excitation energy E*=20.6 eV) into triplet atoms (E*=19.8 eV) prior to deexcitation into the ground state. The conversion probability (as expressed by the ratio R of the intensities of valence-band emission due to triplet and singlet He* deexcitation, respectively) increases with increasing alkali-metal coverage on a Ru(0001) substrate, and in turn decreases with increasing oxygen exposure at a fixed alkali coverage. These findings indicate that R is a qualitative measure for the degree of ‘‘metallization’’ of the adlayer. R also increases with temperature due to broadening of the nearest-neighbor distribution whereby, on the average, a larger part of the adlayer becomes metalliclike. For Cs overlayers exhibiting work functions *− (1s12s2) formation as reflected by the R data as well as by the widths of the electron spectra

    Exoelectron emission during oxidation of Cs films

    Get PDF
    During oxidation of thin Cs films, a nonadiabatic surface reaction manifests itself in the emission of electrons. This effect was investigated in detail by combining measurements of the current and of energy distributions of these exoelectrons with studies on the electronic properties of the surface by means of ultraviolet photoelectron spectroscopy and metastable deexcitation spectroscopy. Exoelectron emission occurs via Auger deexcitation of the empty state derived from the O2 affinity level. This process is confined to the stage Cs2O2→CsO2 in which resonance ionization of the affinity level of the impinging O2 molecule upon crossing the Fermi level EF is efficiently suppressed due to the absence of metallic states near EF. A kinetic model based on the successive steps involved in the oxidation of Cs is developed which describes qualitatively well all the experimental findings

    Dynamic validation of the Planck/LFI thermal model

    Get PDF
    The Low Frequency Instrument (LFI) is an array of cryogenically cooled radiometers on board the Planck satellite, designed to measure the temperature and polarization anisotropies of the cosmic microwave backgrond (CMB) at 30, 44 and 70 GHz. The thermal requirements of the LFI, and in particular the stringent limits to acceptable thermal fluctuations in the 20 K focal plane, are a critical element to achieve the instrument scientific performance. Thermal tests were carried out as part of the on-ground calibration campaign at various stages of instrument integration. In this paper we describe the results and analysis of the tests on the LFI flight model (FM) performed at Thales Laboratories in Milan (Italy) during 2006, with the purpose of experimentally sampling the thermal transfer functions and consequently validating the numerical thermal model describing the dynamic response of the LFI focal plane. This model has been used extensively to assess the ability of LFI to achieve its scientific goals: its validation is therefore extremely important in the context of the Planck mission. Our analysis shows that the measured thermal properties of the instrument show a thermal damping level better than predicted, therefore further reducing the expected systematic effect induced in the LFI maps. We then propose an explanation of the increased damping in terms of non-ideal thermal contacts.Comment: Planck LFI technical papers published by JINST: http://www.iop.org/EJ/journal/-page=extra.proc5/1748-022
    • 

    corecore