Testing the validity of the single-spin approximation in inspiral-merger-ringdown waveforms

Gravitational-wave signals from black-hole binaries with nonprecessing spins are described by four parameters—each black hole’s mass and spin. It has been shown that the dominant spin effects can be modeled by a single spin parameter, leading to the development of several three-parameter waveform models. Previous studies indicate that these models should be adequate for gravitational-wave detection. In this paper we focus on the systematic biases that would result from using them to estimate binary parameters, and consider a one-parameter family of configurations at mass ratio 4 and for one choice of effective single spin. We find that for low-mass binaries within that family of configurations, where the observable waveform is dominated by the inspiral, the systematic bias in all physical parameters is smaller than the parameter uncertainty due to degeneracies between the mass ratio and the spins, at least up to signal-to-noise ratios (SNRs) of 50. For higher-mass binaries, where the merger and ringdown make a greater contribution to the observed signal, the bias in the mass ratio is comparable to its uncertainty at SNRs of only ∼30, and the bias in the measurement of the total spin is larger than the uncertainty defined by the 90% confidence region even at an SNR of only 10. Although this bias may be mitigated in future models by a better choice of single-effective-spin parameter, these results suggest that it may be possible to accurately measure both black-hole spins in intermediate-mass binaries

Surrogate models for precessing binary black hole simulations with unequal masses

Only numerical relativity simulations can capture the full complexities of binary black hole mergers. These simulations, however, are prohibitively expensive for direct data analysis applications such as parameter estimation. We present two new fast and accurate surrogate models for the outputs of these simulations: the first model, NRSur7dq4, predicts the gravitational waveform and the second model, \RemnantModel, predicts the properties of the remnant black hole. These models extend previous 7-dimensional, non-eccentric precessing models to higher mass ratios, and have been trained against 1528 simulations with mass ratios $q\leq4$ and spin magnitudes $\chi_1,\chi_2 \leq 0.8$, with generic spin directions. The waveform model, NRSur7dq4, which begins about 20 orbits before merger, includes all $\ell \leq 4$ spin-weighted spherical harmonic modes, as well as the precession frame dynamics and spin evolution of the black holes. The final black hole model, \RemnantModel, models the mass, spin, and recoil kick velocity of the remnant black hole. In their training parameter range, both models are shown to be more accurate than existing models by at least an order of magnitude, with errors comparable to the estimated errors in the numerical relativity simulations. We also show that the surrogate models work well even when extrapolated outside their training parameter space range, up to mass ratios $q=6$.Comment: Matches published version. Models publicly available at https://zenodo.org/record/3455886#.XZ9s1-dKjBI and https://pypi.org/project/surfinB

Search of S3 LIGO data for gravitational wave signals from spinning black hole and neutron star binary inspirals

We report on the methods and results of the first dedicated search for gravitational waves emitted during the inspiral of compact binaries with spinning component bodies. We analyze 788 hours of data collected during the third science run (S3) of the LIGO detectors. We searched for binary systems using a detection template family specially designed to capture the effects of the spin-induced precession of the orbital plane. We present details of the techniques developed to enable this search for spin-modulated gravitational waves, highlighting the differences between this and other recent searches for binaries with nonspinning components. The template bank we employed was found to yield high matches with our spin-modulated target waveform for binaries with masses in the asymmetric range 1.0M

Physics, Astrophysics and Cosmology with Gravitational Waves

Gravitational wave detectors are already operating at interesting sensitivity levels, and they have an upgrade path that should result in secure detections by 2014. We review the physics of gravitational waves, how they interact with detectors (bars and interferometers), and how these detectors operate. We study the most likely sources of gravitational waves and review the data analysis methods that are used to extract their signals from detector noise. Then we consider the consequences of gravitational wave detections and observations for physics, astrophysics, and cosmology.Comment: 137 pages, 16 figures, Published version <http://www.livingreviews.org/lrr-2009-2

Testing gravitational-wave searches with numerical relativity waveforms: Results from the first Numerical INJection Analysis (NINJA) project

The Numerical INJection Analysis (NINJA) project is a collaborative effort between members of the numerical relativity and gravitational-wave data analysis communities. The purpose of NINJA is to study the sensitivity of existing gravitational-wave search algorithms using numerically generated waveforms and to foster closer collaboration between the numerical relativity and data analysis communities. We describe the results of the first NINJA analysis which focused on gravitational waveforms from binary black hole coalescence. Ten numerical relativity groups contributed numerical data which were used to generate a set of gravitational-wave signals. These signals were injected into a simulated data set, designed to mimic the response of the Initial LIGO and Virgo gravitational-wave detectors. Nine groups analysed this data using search and parameter-estimation pipelines. Matched filter algorithms, un-modelled-burst searches and Bayesian parameter-estimation and model-selection algorithms were applied to the data. We report the efficiency of these search methods in detecting the numerical waveforms and measuring their parameters. We describe preliminary comparisons between the different search methods and suggest improvements for future NINJA analyses.Comment: 56 pages, 25 figures; various clarifications; accepted to CQ

Tests of General Relativity with the Binary Black Hole Signals from the LIGO-Virgo Catalog GWTC-1

The detection of gravitational waves by Advanced LIGO and Advanced Virgo provides an opportunity to test general relativity in a regime that is inaccessible to traditional astronomical observations and laboratory tests. We present four tests of the consistency of the data with binary black hole gravitational waveforms predicted by general relativity. One test subtracts the best-fit waveform from the data and checks the consistency of the residual with detector noise. The second test checks the consistency of the low- and high-frequency parts of the observed signals. The third test checks that phenomenological deviations introduced in the waveform model (including in the post-Newtonian coefficients) are consistent with 0. The fourth test constrains modifications to the propagation of gravitational waves due to a modified dispersion relation, including that from a massive graviton. We present results both for individual events and also results obtained by combining together particularly strong events from the first and second observing runs of Advanced LIGO and Advanced Virgo, as collected in the catalog GWTC-1. We do not find any inconsistency of the data with the predictions of general relativity and improve our previously presented combined constraints by factors of 1.1 to 2.5. In particular, we bound the mass of the graviton to be mg ≤ 4.7 x 10-23 eV/c2 (90% credible level), an improvement of a factor of 1.6 over our previously presented results. Additionally, we check that the four gravitational-wave events published for the first time in GWTC-1 do not lead to stronger constraints on alternative polarizations than those published previously

Exploring intermediate and massive black-hole binaries with the Einstein Telescope

We discuss the capability of a third-generation ground-based detector such as the Einstein Telescope (ET) to enhance our astrophysical knowledge through detections of gravitational waves emitted by binaries including intermediate-mass and massive black holes. The design target for such instruments calls for improved sensitivity at low frequencies, specifically in the ~ 1-10 Hz range. This will allow the detection of gravitational waves generated in binary systems containing black holes of intermediate mass, ~ 100-1000 solar masses. We primarily discuss two different source types -- mergers between two intermediate mass black holes (IMBHs) of comparable mass, and intermediate-mass-ratio inspirals (IMRIs) of smaller compact objects with mass ~ 1-10 solar masses into IMBHs. IMBHs may form via two channels: (i) in dark matter halos at high redshift through direct collapse or the collapse of very massive metal-poor Population III stars, or (ii) via runaway stellar collisions in globular clusters. In this paper, we will discuss both formation channels, and both classes of merger in each case. We review existing rate estimates where these exist in the literature, and provide some new calculations for the approximate numbers of events that will be seen by a detector like the Einstein Telescope. These results indicate that the ET may see a few to a few thousand comparable-mass IMBH mergers and as many as several hundred IMRI events per year. These observations will significantly enhance our understanding of galactic black-hole growth, of the existence and properties of IMBHs and of the astrophysics of globular clusters. We finish our review with a discussion of some more speculative sources of gravitational waves for the ET, including hypermassive white dwarfs and eccentric stellar-mass compact-object binaries.Comment: Improved presentation with minor changes to result

Impact of subdominant modes on the interpretation of gravitational-wave signals from heavy binary black hole systems

Over the past year, a handful of new gravitational wave models have been developed to include multiple harmonic modes thereby enabling for the first time fully Bayesian inference studies including higher modes to be performed. Using one recently developed numerical relativity surrogate model, NRHybSur3dq8, we investigate the importance of higher modes on parameter inference of coalescing massive binary black holes. We focus on examples relevant to the current three-detector network of observatories, with a detector-frame mass set to 120 M⊙ and with signal amplitude values that are consistent with plausible candidates for the next few observing runs. We show that for such systems the higher mode content will be important for interpreting coalescing binary black holes, reducing systematic bias, and computing properties of the remnant object. Even for comparable-mass binaries and at low signal amplitude, the omission of higher modes can influence posterior probability distributions. We discuss the impact of our results on source population inference and self-consistency tests of general relativity. Our work can be used to better understand asymmetric binary black hole merger events, such as GW190412. Higher modes are critical for such systems, and their omission usually produces substantial parameter biases