To reduce the weight of cruise ships, the shipbuilding industry is interested in thin-walled superstructures, where the thickness of butt-welded plates in stiffened panels is under 5 mm. Compared to thick plates, thin ones can develop severe welding-induced distortions, which limit the validity of recommended early-design structural stress assessment methods. Therefore, computationally costly 3D non-linear numerical analysis must be used. For a quick and effective early design, this paper investigates on simplified computational models for thin-walled panels under uni-axial tension, considering the distortions measured on 4 -mm thick, full-scale ship-deck panels. A 2D simply-supported analytical plate is shown to be sufficiently accurate (i.e., error <10%) at 150 MPa for a distortion with maximum slope within 0.02 rad and amplitude smaller than the thickness (t). Moreover, a 1D beam numerical analysis efficiently predicts local stresses around the butt weld when the maximum distortion amplitude is below 0.6×t mm. The distortion needs to be considered at least up to a length of half of the plate width from the weld location and can represent longitudinal profiles within 60% of the plate width. In conclusion, the early structural stress assessment of thin-walled panels can be significantly simplified, thus helping bridge the gap between complex numerical analysis and simplified analytical solutions.Peer reviewe
Is data on this page outdated, violates copyrights or anything else? Report the problem now and we will take corresponding actions after reviewing your request.