Article thumbnail

Three-layer 1.3 µm In1-xGaxAsyP1-ylasers with quaternary confining layers

By F. Prince

Abstract

[[abstract]]Improvements in the surface morphology of InGaAsP DH wafers were obtained with addition of small amounts of Ga and As in the confining layers. This method was used to improve interface flatness between active and confining layers, consequently improving wafer yield and reproducibility. Three-dimensional lattice-mismatch data of the confining layers were determined in detail using simultaneous multiple Bragg diffraction of X-rays. In all wafers tested, independent of the active layer thickness, the maximum threshold current density Jthwas at most 60 percent higher than Jthminimum. The minimum normalized threshold current density obtained by us-3.4 kA/cm2μmis to our knowledge the lowest reported to date. Low resistance contacts-differential series resistance of 1 to 2 Ω for 10 μm SiO2stripe-geometry contact-can consistently be directly applied to tile top confining layer, thus dispensing with file need of a cap layer. CW operation at room temperature has been achieved with these three-layer devices.[[fileno]]2010105010066[[department]]物理

Topics: CW lasers, Gallium materials/lasers, Optical fiber transmitters, [[classification]]33
Publisher: Institute of Electrical and Electronics Engineers
Year: 2011
DOI identifier: 10.1109/JQE.1981.1071148
OAI identifier: oai:nthur.lib.nthu.edu.tw:987654321/55496

Suggested articles


To submit an update or takedown request for this paper, please submit an Update/Correction/Removal Request.