10.15376/biores.10.4.7618-7626

Effect of Selected Parameters on the Surface Waviness in Plane Milling of Thermally Modified Birch Wood

Abstract

This article focuses on the plane milling of thermally modified birch wood while taking into account technological parameters that have substantial effects on the processed wood surface’s arithmetic mean deviation of the waviness profile (Wa). The milling process was affected by the cutting speed, which varied from 20 to 60 m/s, with a feed rate of 4, 8, and 11 m/min. The results obtained on the set of thermally modified test specimens, were compared with the results obtained on test specimens without heat treatment. The surface finish was measured using various milling parameters. The material removal was 1 mm per pass. The results indicate that the thermal modification of wood did not significantly influence the arithmetic mean deviation of the waviness profile (Wa). Cutting speed and feed rate had the most significant effects among the monitored factors. The lowest arithmetic mean deviation of the waviness profile (Wa) was determined at a feed rate of 4 m/min and cutting speed of 40 m/s. An increase in cutting speed led to a decrease in the average roughness, while increased feed rate had the opposite effect

Similar works

This paper was published in Directory of Open Access Journals.

Having an issue?

Is data on this page outdated, violates copyrights or anything else? Report the problem now and we will take corresponding actions after reviewing your request.